Problem 2 Determine the magnitude of W so that the 200-lb body will have an acceleration up the plane of 4.025 ft/s² . Coefficient of kinetic friction is 0.20. 200 lb 30 W lb

Q: The 10-1b box is projected up a smooth vertical circular Track as shown. When the box reaches 045",…

A: Given:To find:A) Sketch a Free body diagram and a kinetic diagram of the box at this instant.B)…

Q: A child goes down a playground slide that is inclined at an angle of 24.5°below the horizontal. Find…

A: Given data: Angle of inclined plane = 24.5° coefficient of kinetic friction between the child =…

Q: 2. Determine the force P required to maintain the 100-kg engine in the position for which 0 = 45°.…

A:

Q: Motorized moving platform is lifting a car with some acceleration. If the combined weight of the…

A: Mass of platform = 2800 kgMass of the lift = 200000 kgFind the maximum acceleration before tipping

Q: The piston of an internal-combustion engine is connected to its connecting rod with a “wrist pin.”…

A: Given   Mass, m = 0.5 kg Acceleration, a = 2500 m/s2 Find   Force on the wrist pin, F

Q: At an airport, luggage is unloaded from a plane into the three cars of a luggage carrier, as the…

A:

Q: Problem 1 The crate has a mass of 20-kg, and the force P = 100 N. The coefficient of kinetic…

A:

Q: A 5-kg crate is released from rest at Point A of a 20-kg ramp which is inclined at 40 degrees as…

A:

Q: Three blocks are connected over two frictionless, massless pulleys by two inextensible, massless…

A:

Q: A box with mass m is on a frictionless inclined ramp, as shown. The ramp has an angle of θ with…

A: Note: Since you have asked multiple question, we will solve the first question for you. If you want…

Q: he solid homogeneous cylinder shown has a mass of 30 kg and is rotating at 1200 rpm clockwise about…

A: The tension in spring is .The coefficient of kinectic friction between brake and cylinder is The…

Q: velocity of 3.60m/s² safely without skidding when approaching the next stop on the road. a. Draw the…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.