PROBLEM 2 A flat bar of width b = 60mm and thickness t=10mm is loaded in tension by a force P. The bar is attached to a support by a pin of diameter d that passes through a hole in the bar of the same size. If the allowable normal stress = 140MPA, shear stress is 80MPA and bearing stress is 200MPA, what is the diameter of the hole for which P is maximum? What is the value of P? %3D

PROBLEM 2 A flat bar of width b = 60mm and thickness t=10mm is loaded in tension by a force P. The bar is attached to a support by a pin of diameter d that passes through a hole in the bar of the same size. If the allowable normal stress = 140MPA, shear stress is 80MPA and bearing stress is 200MPA, what is the diameter of the hole for which P is maximum? What is the value of P? %3D

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Draw FBD and step-by-step process
Note:hand written solution is not allowed .
Someone can help me on this one. Thanks
Someone can help me with this one please
Someone can help me with this one please
Use Plastic Limit
Kindly give me right solution with clear hand writing
SHOW SOLUTION, FBD, AND PLS WRITE LEGIBLE
Note: careful with given dimensions. Give me right solution with clear calculations step by step. Don't copy from other experts solution
Please answer in complete solution and draw fbd
I need datiled solution with clear calculations
Show 5 failures. Show step by step solution. Steel Type: Cross section flat bar PL 12.7 x 165 with an area of 2095.5 mm2 Textbook reference Handbook of steel construction.