Problem 1) A soil sample was compacted. The result of the standard proctor test shows that at 100% compaction, the soil weighs 131.1 pcf with optimum moisture content of 14%. G₂ = 2.67 a) What is the saturated unit weight of the soil in pcf?

Problem 1) A soil sample was compacted. The result of the standard proctor test shows that at 100% compaction, the soil weighs 131.1 pcf with optimum moisture content of 14%. G₂ = 2.67 a) What is the saturated unit weight of the soil in pcf?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The compacted soil sample has 250 g mass and 1.89 g/cm³ density using 12% water content. If the specific gravity of the soil is 2,74 and density of water is 1 g/cm³, the degree of saturation is approximately
A cylindrical soil sample prepared for laboratory testing has a diameter of 71 mm, a height of 142 mm, and weighs 10.675 x 10-3 kN. If the degree of saturation is 93% and the specific gravity of soil solids is 2.71, determine: void ratio water content water content under fully saturated condition
3- A series of standard Proctor compaction tests were performed on soil and the obtained results are presented in Figure below. The volume of the standard mould was 1 x 10³ m³ and Gs = 2.65. 1.82 1.80 1.78 1.76 What is the degree of saturation of the sample compacted to the maximum dry density? Estimate the volume of air (in m3) in the sample compacted to 15% water content. The void ratio of this soil in its loosest state is 1.74 1.72 1.70 1.68 1.66 0.623. Estimate the relative density of the soil sample compacted to 11% water content? 10 11 12 13 14 15 16 17 18 19 20 21 22 Water content (%) Dry density (g cm-3)
A 1972 kg/mᶟ wet unit weight and 5.5% average actual moisture content were obtained from a laboratory data during the conduct of FDT on an aggregate base coarse materials, what is the dry unit weight of the soil? From the above laboratory data and the obtained dry unit weight of soil, What will be the degree of compaction of the compacted materials when a 1960 kg/mᶟ maximum dry density is used as a reference Laboratory compaction data?
Question 4 In a standard compaction test on a soil (grain specific gravity of 2.67) the following results were obtained: Water content (%) 12.8 Mass (g) 1890 14.5 2130 15.6 2200 16.8 2210 19.2 2160 The volume of the mould is 1000 cm (i) Determine the maximum dry density obtainable under standard test conditions and the water content at which this occurs. (ii) Using the above results, specify a detailed quality control plan for field compaction of a highway project.
A field sand cone test is performed on a layer of compacted fill. determined that the fill soil has a maximum dry unit weight of approximately 120 pcf. Determine the relative compaction of the compacted fill. Unit weight of dry uniform of sand: 95 pcf Weight of sand to fill the cone: 1.10 lb weight of jar + cone + sand (before test): 16.5 lb Weight of jar + cone + sand (after test): 10.5 lb Weight of moist soil excavated from hole: 6.60 lb Moisture content of soil from hole: 10 %
8. The results of a standard compaction test on a soil sample from Glasgow are shown in the graph below. From the graph, determine the optimum moisture content (OMC), maximum dry density and air content at maximum dry density. Can this soil be compacted to 2.11 Mg/m³ at OMC? Why? 22 0% 2.1 5% 2 10% 1.9 1.8 1.7 1.6 1.5 1.4 1.3 - 1.2 8 9 10 11 12 13 14 15 16 17 18 19 moisture content [%] 20 dry denslty [Mg/m³]
The unit weight of the soil in the field was recorded as 126.360 lb/ft3 with natural water content of 16.020 %. In the laboratory, the soil is tested for its maximum and minimum void ratio which were 0.910 and 0.380, respectively, and the specific gravity of soil solids to be 2.780. Determine the following: in situ void ratio , relative density of the soil , percentage decrease in the void ratio if the relative density is increase by 10%
A soil sample is having void ratio 0.9 and volume 5 m3. Upon compaction, void ratio of the sample is reduced by 0.2. Determine the percent change in volume due to compaction.