Prob.1. The speed regulations of two 800 kW alternators A and Tunning in parallel are 100% to 104% and 100% to 105% from full load to no-load respectively. How will the two alternators share a load of 1000 kW 2

Prob.1. The speed regulations of two 800 kW alternators A and Tunning in parallel are 100% to 104% and 100% to 105% from full load to no-load respectively. How will the two alternators share a load of 1000 kW 2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 5)This MCQ QUESTION FROM BASIC POWER ELECTRICAL ENGINEERING course.

Q: A 6 pole, 3.3 kV, 50 Hz dalta -connected three-phase induction generator has the following…

Q: please help how to know if they are given terminal voltage or phase voltate. what is the difference…

A: a) 1200 rpm, 125.66 rad/sb) Ea= 12.113 kV, Efficiency n= 90.78%c) 10kV since connected to infinite…

Q: calculate the line e.m.f.

Q: The winding data for three different alternators are as follows I. 60 slots, four poles, span 1 to 9…

A: pitch factor=cos(short pitch angle2). slot angle=180slot /pole.

Q: The shaft of a three-phase synchronous generator is rotating at 1800 RPM synchronous speed. This…

A: In this question , we will find total loss and torque induced in generator....

Q: The voltage regulation of an alternator having 0.75 leading power factor load, no-load induced emf…

Q: 3.Discuss the differences between Pelton, Francis, and Kaplan turbines.

Q: 3. A three-phase 60 Hz Wye connected, 2,000-kVA, 2,300-V alternator give a short circuit-test…

A: The solution is given below

Q: Above is the one-line diagram of a simple power system. Each generator is represented by an emf…

A: The Given symmetric fault occurs 1 through a fault impedance Zi=j0.08 perunit. To determine the…

Q: For a power station the yearly load duration curve is a straight line from 50,000 to 4000 kw. To…

A: Capacity of Generator 1 & 2 = 20,000 kW Capacity of Generator 3 = 7000 kW Pmax = 50000 kW Pmin =…

Q: A 400 v, 50 Hz, three phase alternators, rated at 75 kVA, is star connected and driven at 1000…

A: According to the question we have to find the smallest lagging power factor at which the alternator…

Q: In a three-phase star connected alternator it is necessary to generate 7200 line voltage at…

Q: A single phase 120V AC sourc controls power to a resistve load 202 using integral cycle control. a)…

A: Note: As per our policy, I have attempted the first three subquestions. Given data: The source…

Q: The rating of a three-phase star-connected alternator is 1750 KVA, 11 KV, The armature resistance is…

A: we need to determine voltage regulation at given load and power factor.

Q: 4- With the increase of the winding of a d.c. generator, terminal voltage wil c) Remain same a)…

A: (4) With the increase of winding of a dc generator, the armeture resistance of winding also…

Q: the mduced emf -

Q: An alternator rated for 490 kVA, 3.3kV, 10 poles, 3 phase, 50 Hz, Delta connected has 182 term per…

Q: Q6. Two identical Y-connected alternators are running in parallel. The generated phase voltages are:…

Q: 3. A 30, 25 kV, 500 MVA, 60 Hz alternator has a synchronous reactance X, = 1.5 pu. The alternator is…

Q: 12- Sketch the phasor diagrams of the following cases: i) Synchronous generator supplies both real…

A: GENERATOR/ALTERNATOR/SYNCHRONOUS GENERATOR: An alternator/Synchronous generator is a type of…

Q: The shaft of a three-phase synchronous generator is rotating at 1500 RPM synchronous speed. This…

A: Solve as below

Q: The winding data for three different alternators are as follows 1. 60 slots, four poles, span 1 to 9…

A: We will find the pitch factor in each case as shown below.

Q: Figure 1 shows an electric generator with 3 rotor windings as marked by a-1, b-2 and c-3. A…

A: The objective of the question is to design a 3-phase 3-wire connection for an electric generator…

Q: - A3-phase, star-connected alternator is rated at 15000 kVA, 11 k V. The armature resistanc and…

A: The alternator is an electrical device used for the conversion of mechanical to electrical energy. A…

Q: 12. Calculate the number of series turns per pole required on a compo generator to enable it to…

Q: A three phase synchronous generator is rated at 9 kW, 240 V working at unity power factor. The power…

Q: The voltage regulation of an alternator having 0.75 leading power factor load, no-load induced emf…

A: Power factor decides only the terminal voltages But once the voltages are known Power factor has no…

Q: a given field current produces an armature current of 250 A on short-circuit and a generated e.m.f.…

A: Given data, Armature current Ia=250 A Open circuit voltage Voc=1500 V Voltage V=6600 V power factor=…

Q: 2. What are the necessary conditions for successful operation of two single- phase transformers?

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: 9.a. If a 33% load increase is suddenly applied to an alternator having a 25% reactance, the initial…

A: According to question we have to, 9(a). If a 33% load increase is suddenly applied to an…

Q: An 11-kV, 1000-kVA, 3-phase, Y-connected alternator has a resistance of 2 0 per phase. The…

Q: 18. The speed at which a 6-pole alternator should be driven to generate 50 cycles per second is. (i)…

A: Given, Speed of the alternator, Ns=? Total number of pole, P = 6 Frequency, f = 50 cycles = 50 Hz

Q: Three single phase transformers each having a 240 V primary and two 250 V secondaries, as shown in…

A: The primary voltage of the single-phase transformer is 240 V and the secondary voltage is 250 V.…

Q: If a 3-phase short circuit occurs at the terminals of an alternator, the current in the armature…

Question

Prob.1. The speed regulations of two 800 kW alternators A and B
running in parallel are 100% to 104% and 100% to 105% from full load to
no-load respectively. How will the two alternators share a load of 1000 kW 2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For a power station the yearly load duration curve is a straight line from 32,000 to 3000 kw. To meet the load three turbo-generators are installed. The capacity of two generators is 16,000 kw each and the 3rd is rated at 4,000 kw. a. Draw the yearly duration curve b. Determine the load factor, annual capacity factor, and maximum demand
6
If the load is connected to the generator thgrough an inductive line and the voltage at the load side is the same as the voltage at the terminals of the generator, which of the following must be true? O A. The reactive power is flowing from the generator to the load and from load to the generator at the same time. O B. The load is disconnected, and no power is delivered to the load. O C. The load has a poor power factor and it's absorbing too much reactive power. O D. None of the other choices are correct O E. The generator is unable to produce reactive power; therefore, the reactive power is flowing from the load to the generator.
Two 60MVA, alternators operate in parallel. The setting of the governor are such that the rise in speed from full load to no load is 2% in one machine and 3% in the other, the characteristics being straight lines in both cases. If each machine is fully loaded when the total load is 120MW, what will be the load on the first machine (with 2% speed regulation) when the total load is reduced to 80MW?
Why are alternators connected in parallel? What are the conditions for parallel connection? Explain.
5
Two transformersA and B are connected in parallel to a load of (2+j1.5) ohm.Their impedances in Secondary terms ZA = (0.15+j0.8) ohm and Zb = (0.1+j30.6)ohm Their no-load termind voltages are EA=200<0 V and EB=210<0 Volt.Find the power and Power factor of each transformer? %3D %3D
A 9.9 kV, Y-connected, 3 phase alternator has a synchronous reactance of 8 ohms per phase and negligible resistance. At a certain field current the armature is known to induce 8.2 kV per phase. Calculate the power that can be developed by the alternator at this excitation.
A 30 MVA, 11KV, 50 Hz, star-connected three-phase alternator has an effective armature resistance per phase = 0.020 and synchronous reactance per phase = 2.252. Find the % regulation for a power factor of 0.707 lagging. What is the load angle of the alternator under this condition?
Please quick solution
pls solve in less than 30 min.
A three-phase star-connected alternator is rated at 1500 KVA, 11 KV, The armature resistance and synchronous reactance are 1.5 Q and 25 Q per phase respectively. Calculate the percentage regulation for a load of a) 45% load at 0.7 power factor lagging. b) 65% load at 0.65 power factor leading. a) b)