Prob. "3 The converter in Figure 2 (above) has load resistance, R = 0.22; input voltage V = 220 W; and battery voltage, E=10 V. The average load current, Ia = 200 A, and the chopping frequency is f=200 Hz (T=5 ms). Use the average output voltage to calculate the value of the load inductance L, that would limit the maximum load ripple current to 5% of Ia Hint: For the worst ripple condition, the duty cycle, k = 0.5]

Prob. "3 The converter in Figure 2 (above) has load resistance, R = 0.22; input voltage V = 220 W; and battery voltage, E=10 V. The average load current, Ia = 200 A, and the chopping frequency is f=200 Hz (T=5 ms). Use the average output voltage to calculate the value of the load inductance L, that would limit the maximum load ripple current to 5% of Ia Hint: For the worst ripple condition, the duty cycle, k = 0.5]

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A step down converter is operated with a duty cycle of k = 0.75. The input voltage is Vs = 20V, and the load is: L = 5mH, R = 1502. The minimum inductor current is I₁ = 0.1A. The maximum inductor current is: Select one: a. 1.9 A b. None of these OC. 0.9 A O d. 1.1 A Oe. 2 A
need quick solution please
For the buck-boost converter, determine the duty cycle, the switching frequency, and the inductor current ripple. The output voltage ripple is about 1%. vs 10 V, mH, C 0.5 micro.F, Vout=-20 V, R-IO Q
Q2) A 3-phase, half-wave thyristor converter is connected through a voltage source 150 V as input voltage and used to supply resistive load of 10 2. Determine rsm voltage, rms current, ripple factor and dissipated power in the resistor R. If a = 45° and f = 50 Hz. %3D
Calculate the rms value of the output voltage of an AC-AC converter with the following specifications. Vs—110*sqrt(2)*sin(wt), Alpha Pi/6
A buck-boost converter operates with an input battery. It converts +12 V to –12 V at apower level of about 75 W. the switching frequency is 120 kHz. The switches have200 ns switching time. The battery has an internal series resistance of 0.2  and seriesinductance of 200 nH. (a) What is the operating value of the duty ratio? What power is lost in the battery resistance? (b) Propose an interface structure to improve operation and decrease losses. What are the duty ratio and battery resistance loss with your interface in place?
18. A dc-dc converter is to be built with the following specifications: Allowed dc input voltage range: +8 V to +18 V +24 V Output average voltage: Output voltage ripple: ±0.06 V maximum at rated load 300 W, resistive ±250 mA maximum at rated load 100 kHz Rated load: Input current ripple: Switching frequency: Common ground between input and output. a. Draw a circuit which can perform this function. b. What is the necessary range of duty ratio for each switch? c. Find circuit part values (R, L, and C) which will meet the stated specifications.
4. A DC/DC step down converter is supplied by 96 V DC supply and produces average 24 V DC output. The switching frequency is 1 kHz, Al = 10 A, R=16 Ohm a. Draw equivalent circuit and obtain the duty cycle and the value of inductance. b. How do you reduce the voltage ripple below AV=5 V.
Sub:power electric
Calculate the equivalent resistances Rin of the following circuits. (The resistance value of the diodes in the conduction will be 0, the resistance value of the diodes in the insulation will be taken as infinity. R1=10ohm
The ripple factor for pure dc is
For a buck converter, the following specifications are given: Vin = 600 V, L = 10 mH, and R =1 Q. a) Calculate the duty cycle required to deliver 200 A de into the load. b) Derive an expression for the peak-to-peak current ripple seen by the load. c) Estimate the switching frequency necessary to limit the peak-to-peak current ripple to no more than 5 A.