Primary star connected three-phase operating at 200kVA power, 15/0.4 KV 50 Hz frequency It has been observed that the transformer draws 550 W in the experiment performed when it is idle. of the transformer the relative open giant current i0 = %1, 9. a) Iron and magnetizing current, no-load power coefficient and no-load draw Calculate the reactive and active power. b) Calculate the iron resistance and magnetization reactance of the transformer.

Primary star connected three-phase operating at 200kVA power, 15/0.4 KV 50 Hz frequency It has been observed that the transformer draws 550 W in the experiment performed when it is idle. of the transformer the relative open giant current i0 = %1, 9. a) Iron and magnetizing current, no-load power coefficient and no-load draw Calculate the reactive and active power. b) Calculate the iron resistance and magnetization reactance of the transformer.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What conclusions we come up with after doing open circuit test on single phase transformer.
Centage resistance and percentage reactance of a transformer are 1% and 4%, respectively. What is voltage regulation at power factor 0.8 lagging and 0.8 leading?
If we increase the load than core loss and copper loss will... Decrease Increase Remain same
None
During the load test of single-phase transformer, when the secondary terminal voltage increases, the regulation of the transformer will ................?(complete)
please answer in short....please....i will like.
B/ Fill in the blanks: 1. The purpose of providing the iron core in the transformer is to 2. A transformer transforms... 3. Power transformers are designed to have maximum efficiency at 4. The transformer ratings are usually expressed in terms of menm
Core losses of a single phase 440/240 V, 24 kVA, 50 Hz transformer is 750 W. Maximum efficiency of the transformer is 90% at 15 kVA load and a certain power factor. Find the efficiency of the transformer at the same power factor and full load.
Define all the losses in the transformer with the diagram and then define the hysterisis loss with thw graph.
Efficiency at full-load and half the full-load at 0.8 p.f. lagging current. Equivalent reactance referred to primary & referred to secondary..........ohm , ..........ohm Equivalent resistance referred to primary & referred to secondary..........ohm , ..........ohm Regulation of transformer at 0.5 p.f. lagging current The magnetizing current and reactance component of no-load are.........amper , .........ohm The working current and resistance component of no-load are.........amper , .........ohm *
A single phase 220/6 Volt, 50 Hz transformer has a rated primary current = 0.5 A. its maximum efficiency is at load current = 15 A and equal to 94% at unity p.f. Its efficiency at rated load, 0.65 p.f. lagging is: 087.8%. 092.3%. 090.9%. ONone.
Q5:Choose the correct answer from the given alternatives (answer five only) 1.In an ideal transformer, (a) windings have no resistance (b) core has infinite permeability (d) all of the above. (c) core has no losses 2. The primary and secondary induced e.m.fs. El and E2 in a two-winding transformer are always: (a) equal in magnitude (b) in-phase with each other (c) antiphase with each other (d) determined by load on transformer secondary. 3. In relation to a transformer, the ratio 20 : 1 indicates that (a) there are 20 turns on primary one turn on secondary (b) secondary voltage is 1/20th of primary voltage (c) primary current is 20 times greater than the secondary current. (d) for every 20 turns on primary, there is one turn on secondary. 4. A transformer has negative voltage regulation when its load power factor is: (a) zero (b) lagging. (d) unity (c) leading