Power in a three-phase star-connected balanced inductive load is measured by two wattmeter method. The phase voltage and phase current are 200 V and 10 A respectively. The power factor of the load is 0.866. Which of the following is/are true regarding the wattmeter readings?

Q: . When SW2 is closed, the motor will spin and D1 will light. The current through 1.______ will flow…

A:

Q: g Technology- Toronto CHAPTER 7: SOLDERING TECHNIOUES ES 7.5 QUESTIONS Which tools will you need for…

A: Note: According to bartleby guidelines, we have to answer only first question. 1) Soldering is the…

Q: Does NEC provides maximum guidelines or minimum guidelines

A: The solution has been provided in the following section:

Q: Draw a simple block diagram of 'Open-Loop Control System' and 'Closed-Loop Control System' Not…

A: Note -  CS - control system

Q: Short answer. Explain meter loading and why it is important to consider.

A: Meter Loading  Meter loading is generally seen in electrical devices used to measure the voltage and…

Q: I am handling a junction boxes where we are having pre-charge circuit, why is it being used here?

A: A pre-charge circuit is commonly used in electrical systems, especially those involving high-power…

Q: How to turn-off a current source? A) Set it to zero. B) Replace it with a short-circuit. (C) You…

A: What is the process to turn of the current source  : Options are : Set it to Zero. Replace it with…

Q: What is voltage padding?

A: In the given questions we need to discuss about the voltage padding and it's importance.

Q: Does the guidelines provided by NEC is maximum

A: The solution is provided in the following section:

Q: What are words for being stable

A:

Q: What is the electrical-resistance strain gage?

A: The electrical resistance strain gage is as follows: - Electrical resistance strain gages are…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.