Portions of a 0.25 × 0.25-in. square bar have been bent to form the two machine components shown. Knowing that the allowable stress is 9 ksi, determine the maximum load that can be applied to each component. (a) 1.1 in. (b)

Q: H h d

A: To solve this, we need to find the permissible load at critical section that is at the section where…

Q: 17. A rectangular bar is loaded as shown. Find the maximum tensile stress developed ove section A-A.…

A: Given : Max. tensile stress developed over section A-A ?

Q: *2-16. The nylon cord has an original length L and is tied to a bolt at A and a roller at B. If a…

A: Applied forceOriginal lengthTo find:           Normal strain at C and D.          Show .

Q: A solid brass shaft is loaded as shown below by two torques TB segments are LAB = 750 mm and LBC =…

A:

Q: The axially loaded steel material shown below has E = 29.000 ksi and vitel =0.30. Assuming that e, =…

A: As per Bartleby policy i can answer  only one question at a time. Please upload other questions…

Q: The pin-connected assembly consists of aluminum rods (1) and (2) and steel rod (3). The aluminum…

A: The given data is shown below: Diameter of aluminium rod=19mmElastic modulus=69 GPaDiameter of steel…

Q: 1. Determine the nominal load P that will cause failure of the beam shown below. As part of your…

A:

Q: The 1.16-in. diameter rod in (Figure 1) is subjected to the loads shown. Determine the state of…

A:

Q: Two Steel Rods (ASTM A36) and One Aluminum Rod (1060 0) are assembled to two rigid cover plates. The…

A:

Q: hat have an outside diameter of 135 mm and a wall thickness of 9 mm. Determine the normal stress in…

A: From a given question it is required to calculate stresses in each member of truss.

Q: Question 4. Three wires are used to suspend the plate shown. Aluminium wires used at A and B with a…

A:

Q: 1 1 Portions of a x-in. square bar have been bent to form the two machine components shown. Knowing…

A: A square section of dimension  in2 is bent into two sectionsSquare sectionDiamond sectionThe…

Q: The bronze bar 3.08 m long with a cross-sectional area of 629 mm2 is placed between two rigid walls.…

A:

Material Properties

Construction in civil engineering demands high strength, durability, and longevity. These targets can be achieved by better design and analysis, along with the correct choice of materials. Different materials have different properties and hence, they respond and performs differently under the various condition of external loadings. It is therefore a critical task of an engineer to select the right material based on the property that the material is supposed to function in real-time. When speaking about the property, there are different categories of material properties like chemical property, physical property, mechanical property, electrical property, magnetic property, thermal property, etc. These material properties form the basis of material selection in various applications.