POINT NORTH/SOUTH DEGREES MINUTES EAST/WEST DISTANCE (M) 0-1 19 21 E 530.49 1-2 N 81 21 w 23.59 2-3 10 45 108.31 3-4 15 E 30.47 4-5 S 77 26 29.95 5-6 23 W 120.29 6-7 S 23 W 17.61 7-8 81 21 10.08 8-1 81 21 W 23.42

POINT NORTH/SOUTH DEGREES MINUTES EAST/WEST DISTANCE (M) 0-1 19 21 E 530.49 1-2 N 81 21 w 23.59 2-3 10 45 108.31 3-4 15 E 30.47 4-5 S 77 26 29.95 5-6 23 W 120.29 6-7 S 23 W 17.61 7-8 81 21 10.08 8-1 81 21 W 23.42

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Average-End Area Volume When the ground is irregular, to increase the accuracy of the volume…

A: Given : When the ground is irregular, to increase the accuracy of the volume calculations when using…

Q: Q3) Using a contour map without a scale (given one known distance) find the real distance between…

A: Determine the elevation of points A and B. The elevation of point A is EA=160 ft. The elevation of…

Q: Item 3 A highway survey PI falls in a pond, so a cut off line AB= 275.21 ft is run between the…

Q: 6. A closed traverse with 5 corners has field measured interior angles at each corner as follows,…

Q: 1.1 how to use a level 1.[Calculation] To calculate the elevation of some points, a leveling route…

A: surveying : The technique, profession, art, and science of identifying the two-dimensional or…

Q: INTERPOLATING CONTOURS ANALYTICALLY. Using a suitable scale, plot a rectangular area 5435 m (length…

A: line legth start point end point elevation difference between point number of meters per 1 m…

Q: Situation 3: Given PI @ 32 + 43, "I" angle =7° 29', Degree of Curvature = 9°. Compute Length of…

Q: Given the following data for a closed traverse in which the lengths of sides CD and DE are unknown

A: The values given in the question are as follows Lines Bearing Length (m) AB S 85o 58' E 541.56…

Q: In segment 2 of the second figure, is it not a semicircular arc? and how will you know if it is a…

A: Data Given: Asked: Difference between Semicircle and Semicircular arc

Q: Problem 1: The measured interior angles of a closed traversed shown are as follows: A = 87°25'51", B…

Q: URVEYING #1

A: Given- Width of road (w)=9 mSide slope (n)=1.5:1

Q: The data of a closed traverse is shown below. Create a table (in your solution sheet) showing all…

A: To compute the area of the traverse using the Double Meridian Distance (DMD) and Double Parallel…

Q: The given table shows the data for a certain closed traverse: Line Distance (m) Bearing AB N55°W BC…

Q: List some mistakes made in traverse computations.

A: 1. Mistakes with signs. 2. Wrong quadrant 3. error due to wrong azimuth 4. error in angle…

Q: What is the numerical value of the slope of vertical tangent line?

A: Slope of a line represents the rise and fall of a line and also tells about the steepness of line.

Q: Plz, answer this question as detail. Surveying-2 1. Explain Procedure for Layout of…

A: Curves:- A curve consist of a single arc connecting two straights or tangents. Curve is a simply…

Q: As per plan, the distance between two telephone poles is 2356.35 meters. If the location of one is…

A: Using tape length and slope correction formula

Q: A closed traverse has the following data below. Find the bearing of line BC. Show complete solutions…

A: To find out the bearing of AB and BC.

Q: The following data has been obtained for the sides of a traverse: Table 3: Traverse raw data Side…

A: Approach to solving the question: Detailed explanation: Examples: Key references:

Q: A complete solution to the problems below will include sketches as appropriate. 1. A five sided…

A: We know that sum of interior angles of a polygon is given by (n-2)*180where n = number of sideswe…

Q: 1. With the following data for a closed traverse, Find the latitude and longitude. The coordinates…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 12.30m irregular Boundary 10.80m 7.00m 7.50m 6.40m 6.20m 5.0 2.70m -Traverse Line AB 6.0 "6.0 6.0 60…

Q: Draw a cross-section and explain the Swedish circle method of analyzing slope stability for…

A: Answer Introduction When a landslide occurred in a curved manner concave is know as the Rotational…

Q: DATA AND RESULTS LINE AB BC CD PE EA OBS. DIST. 14.90m 15 m 15.52m 12.56m 13.84 m OBS BEARING N 43°…

A: To Determine :- The total area of the traverse using Double Meridian Distance (DMD) method.

Q: Describe the Computational Aids—Slope Stability Charts.

A: For preliminary research, slope stability charts are useful to compare transitions that may be…

Q: A closed traverse has the following data below. Find the bearing of line BC. Show all your complete…

A: Given data- To find- It is needed to find the bearing of BC.

Q: What is the adjusted coordinate along the Y axis of Sta B based on the following conditions: Sta B…

A: Given Data: Error of closure along x-axis is ex=0.05 m. Error of closure along y-axis is ey=0.30 m.…

Q: Problem 2 Draw a profile line in the three main planes. Find its slope, the "percent grade" and make…

A: Engineering Scale: In the engineering scale, the relation between the dimension on the drawing and…

Q: The following data has been obtained for the sides of a traverse: Table 3: Traverse raw data Side…

Q: What is the adjusted coordinate along the X axis of sta B based on the following conditions; Sta B…

A: Arbitrary method Bowditch's rule Graphical method Transit rule Axis method

Q: As per plan, the distance between two telephone poles is 3566.35 meters. If the location of one is…

A: Given, Horizontal distance between poles = 3566.35m Designated length of tape = 50m…

Q: List the three basic requirements to determine an angle?

A: Angles Angles are regularly used & straight measured in the field with the compasses &…

Q: The data in the table below is for a closed-polygon traverse. Balance the traverses by coordinates…

A: CourseLengthBearingAB403.73N 8o17'02"EBC622.63N 87o02'05"ECD653.16S14o47'06"WDA550.84N 68o43'20"W

Q: b. Determine the length of course BC. c. Determine the length of course CD.

A: Length of Line BC = 556.77 m Length of line CD = 638.73 m

Q: It want to define a tunnel between two points (A and B) that cannot be seen between them. To…

Q: What is Radial traversing?

Q: Compute the area of the given traverse using DPD method.

Q: Q2. In one word, what can we check in a closed traverse compared to an open traverse? (use lower…

A: what check can be done in closed as compared to open traverse

Q: The data of a closed traverse is shown below. Complete the table below and determine the area using…

Q: The following data has been obtained for the sides of a traverse: Table 3: Traverse raw data Side…

A: Approach to solving the question: Detailed explanation: Examples: Key references:

Q: Compute the area of the given traverse using DPD and DMD method. COURSE LENGTH (m) BEARING AB 495.85…

A: Latitude=Length of AB×cosθLatitude=Length of AB×sinθ

Q: Please show complete and detailed solution for the table 2 and double check table 1. Also, show the…

A: To find. Bearings, Latitudes, Departures, and corrected Latitude and corrected Departure.

Q: As per plan, the distance between two telephone poles is 4350.35 meters. If the location of one is…

Concept explainers

Area Computations

The area is the mathematical estimation of the inner space occupied by any shape or object and area computation is the evaluation of how much inner space that particular shape or object has utilized. Simple applications include calculating the area of wall for the quantity of paint or plaster to be applied on it, area calculations for construction of a trapezoidal dam and how much material is required, calculating the area of a circle to determine the range or distance of wheels that they are capable of covering due to varied radii and so on.

Question

Please show the complete solution. Thank you.

Compute the area of the given traverse using DPD and DMD method.

POINT
NORTH/SOUTH
DEGREES
MINUTES
EAST/WEST
DISTANCE (M)
0-1
S
19
21
E
530.49
1-2
N
81
21
W
23.59
2-3
10
45
108.31
3-4
15
6
E
30.47
4-5
S
77
26
29.95
5-6
S
23
120.29
6-7
23
W
17.61
7-8
81
21
W
10.08
8-1
N
81
21
23.42

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

INSTRUCTIONS: Provide your COMPLETE solution, including illustrations and sketches, legibly. From the OBSERVED set of data of a closed compass traverse shown, determine the: a. Bearing of each line b. Linear error of closure, the direction of the side of error, and the precision of the survey made Adjusted distance and bearing C. d. Area of the traverse using DPD method COURSE DISTANCE (m) AZIMUTH FROM SOUTH 1-2 475.48 180° 50' 2-3 649.13 116° 06' 3-4 867.34 25° 54' 4-5 522.48 315° 20' 5-6 504.90 213° 27' 6-1 311.25 275° 39'
What does Slope Inclination Indicator used to determine?
List the steps involved in making elementary traverse computations.
Cite advantages or disadvantages of laying out a curve with the instrument set at the beginning of curve (BC).
Please provide correct answers, thanksss
Show your complete solution and illustration (if applicable)
As per plan, the distance between two telephone poles is 450.35 meters. If the location of one is known in the field and the second is to be laid with a 100 m tape known to be 0.02 meter too short, along an average ground slope of 2%. Determine the actual length to be laid along the ground surface.
Show complete solutions. Please answer is ASAP. Thankyou.
Which of the following method of drawing circle will be used when a circle is to be drawn so that the circle will circumscribe a given triangle? 1.Center, Radius 2.Center, Diameter 3. 2-Point 4. 3-Point 5.Tan, Tan, Radius 6.Tan, Tan, Tan O 4 & 6 only 6 only 5 only 3 only O 4 only Next »
ROUTE SURVEYING
Which methods are applied to adjust the angles of a closed traverse to correct the geometric total?
2. Given the data below of a closed traverse, Balance the traverse using Transit Rule, Compute area by DMD and DPD COURSE DEPARTURE LATITUDE AB -50 +490 BC +600 +590 CD +790 -320 DA -1300 -700