Please help solve. Homework

Q: The figure shows the soil profile at a site where you plan to lower the water table. You have…

A:

Q: 2. Three reservoirs A, B, and C are connected respectively with pipes 1, 2, and 3 joining at a…

A:

Q: A test car was used on a North-South road 0.75 km long, and the following data, for the moving car…

A: A test car was used on a North-South road 0.75 km long, and the following data, for the moving car…

Q: 3. A water jet that comes out of a pipe, exits into the air and strikes a plate. If the force is…

A:

Q: The steel propeller shaft ABCD carries the axial loads shown in Fig. (a). Determine the change in…

A:

Q: Determine the horizontal displacement of joint C of the truss. The cross-sectional area of each…

A: E = 200 GPa = 200 × 103 N/mm2  A = 200 mm2  Determine the horizontal displacement of the joint-C.…

Q: 1. Determine the force in bars BD, CD, and DE of the nacelle truss shown below. Indicate whether…

A:

Q: Question 1 A rectangular building with a length of 50' and a width of 30' that is 16" wide and 8"…

A: Given  Length = 50 ft  Width= 30 ft

Q: nswer all the questions

A:

Q: Hydrology . Thanks for the help

A: Given data : Area of Woodland  (A1)=5 acresArea of Cropland  (A2)=20 acresRunoff coefficient of…

Q: Calculate the displacement in volume for a life buoy with the following characteristics. D: - 0.5 m…

A: The given figure is shown below:

Q: system) Determine the resultant of the three cable tensions that act on the flagpole if T = 680 N,…

A:

Q: The rate of flow of water through a pipe of length 2000 m and diameter I m is 2 m'/s. At the end of…

A: Given: Length of pipe, L = 2000 m Diameter of pipe, D = 1 m Discharge, Q = 2 m3/s Diameter of…

Q: Differentiate Track from Field events.

A: The main difference is the way in which the events are conducted, and where they take place. For…

Q: Question 4 The DO in an unseeded sample of diluted waste having an initial DO of 9.5 mg/L is…

A:

Q: The planar structure RST shown in the figure is roller supported at S and pin supported at R.…

A:

Q: 2. The second floor of a light manufacturing building is constructed from a 125-mm-thick stone…

A: Thickness of concrete slab(tslab) = 125 mm = 0.125 mThickness of cinder concrete (tcinder) = 100 mm…

Q: Write a short note about couple.

A: Forces which are not concurrent and don not same line of action which are parallel to each other…

Q: Water is flowing at a rate of 8 ft³/s in a rectangular channel with a 2 ft water depth and a 4 ft…

A:

Q: Using Double Integration Method, determine the equation of the elastic curve of the beam below and…

A:

Q: Line P to Q intersects the street alignment as shown in the sketch below. What is the length of line…

A:

Q: Kitchen Bathroom Living Room Dining Room Library Entry Above is the floor plan for a new house. The…

A: The given floor plan is labeled which is shown below: Given scale: 1 inch: 8 feet

Q: A simple beam of length L- 5 m carries a uniform load of intensity = 5.8 kN/m and a concentrated…

A: Given Data A simply supported beam is given with the following data Span length is 5 m  A uniformly…

Q: 2. A column in a building is subjected to the following load effects: 9 kips compression from dead…

A: Dead Load (D) = 9 k)ips Roof live load (Lr) = 5 kips Snow load (S) = 6 kips Load due to rain…

Q: A rigid bar ABCD is pinned at end A and supported by two cables at points B and C (see figure). The…

A:

Q: Copy the table and find the missing data. Use two (2) decimal places. LINE LATITUDE DEPARTURE DMD 2A…

A:

Q: Air at 1000 mb and 18°C has a mixing ratio of 6 g/kg. What is its relative humidity and dew point…

A: Pressure, Temperature, Mixing ratio,

Q: A soil profile is provided below. The estimated stresses from a spread footing overlying a 10 meter…

A: Average overburden pressure at the center of the clay layer, σ0'=17.3×3+19.82×5-9.81×5=101.95 kPa…

Q: Use the diagram shown below to calculate the Effective Stress at Point A. Assume the unit weight…

A:

Q: allowable recovery array asymmetric membrane concentrate concentration polarization dense membrane…

A: Brief concept- Water Treatment- Water treatment is done to improve the quality of the water. The…

Q: elp with this question.

A:

Q: Problem IlI. A beam shown in Figure 1 is subjected to loads as shown. 59 kN 38 kN/m B 120 kN.m 68 kN…

A:

Q: An office building is planned to be built on the site shown below. The total weight of the building…

A:

Q: Y F1=200# Problem # 3 (7 points): The bent pipe resists forces as shown. Determine the moment of…

A: Consider the following given diagram: The moment at a point is the sum of forces acting…

Q: 1. Give two (2) reasons why Pneumatic Systems are used in industry. 2. What controls the instroke of…

A: A hydraulic actuator is made out of a cylinder or fluid motor that uses hydraulic power to perform…

Q: give me all three answers otherwise leave it.. Remember give me all answers. Thank you

A: The binder from the separated mix was extracted and recovered using AASHTO T319. The amount of…

Q: 4. The wide of the dam is x m. a.Find the hydrostatic force on surface AB and its moment about C.…

A: Question is based on the gravity dam . Width, Height and specific gravity of dam are given in the…

Q: 1. For both options document the relative suitability of each option in meeting the stated State…

A: Since the question number to be solved is not specified, the solution for Question No.01 is as…

Q: Question 4: The frame consists of right-angled triangles of base 2 m with angles as shown in Figure…

A: a) Support reaction:-                          ΣMD = 0-(20×6)-(30×4)-(40×2)+(RF×4) =0⇒            RF…

Q: Let a=4 ft, b=7 ft, c=2 ft and w-6.5 kips/ft. Construct the shear-force and bending-moment diagrams…

A:

Q: 18. A 30-sec transit was used to measure a horizontal angle reading was 125 35' the average value by…

A:

Q: Problem no. 2 Determine the equations of the elastic curve using the coordinates and , and specify…

A: Determine the equations of the elastic curve using the coordinates and, and specify the slope at B…

Q: the DO meter showed a concentration of 8.8 mg/L. m RPD of 9% what is the saturation concentration c

A: Given:- concentration=8.8mg/L Maximum RPD=9% To find:- saturation concentration

Q: 1. Give at least 5 importance of engineering utilities for civil engineering students and explain…

A: Since multiple questions are asked. Therefore, as per the guidelines  only the first part will be…

Q: The symbol cfs in plumbing, is the . abbreviation of : colored fixture sink

A: Given the symbol cfs in plumbing is the abbreviation of colored fixtures sink. Cfs stands for Cubic…

Q: create a hyetograph of the storm event. What is the maximum rainfall intensity? b) Plot the rainfall…

A: Area of dirt lot = 2 acretime steps = 0.5 hrrunoff coefficient =0.7time, intensity table is given…

Q: Discuss the determinancy of the beams,frames and trusses. (1) (3) N (4)

A: Static indeterminacy = No. of unknowns - No. of Equations If S.I = 0, structure is determinate S.I…