Please give me introduction of IN VITRO RELEASE STUDY OF THE SUSTAINED-RELEASE FORMULATION

Q: What potentially dangerous byproducts are produced during the treatment of pulp mill effluent?…

A: During the treatment of pulp mill effluent, several potentially dangerous byproducts can be…

Q: In using LC-MS, compare advantages (disadvantages) of using full scan ions versus product ion from…

A: LC-MS stands for Liquid Chromatography Mass Spectrometer.This instrument is used for the…

Q: The solubility of a certain salt in 100 g of water is 25 g. 15 g of the salt is placed in 80 g of…

A: Given: The solubility of a salt in water is given as 25 g in 100 g of water. It implies that 100 g…

Q: Describe by drawing what are the three mechanisms of mass transport in porous membranes.

A: The mass transport in porous membranes takes places through the following three mechanisms: (a)…

Q: Expalin atomic absorption spectrophometry(AAS) method and Expalin how it works on minerals

A: Atomic absorption spectroscopy (AAS) is a spectroanalytical procedure for the quantitative…

Q: why do think it should not be exempted from raw honey from front-of-pack labelling in the…

A: To answer based on the original solution Why should raw honey not be exempted from front-of-pack…

Q: How is Cu2O nanoparticle synthesized in the laboratory?

A: The morphology of the Cu2O nanoparticles is mainly dependent on electrolytic media, stirring,…

Q: How can we determine the rate of mass transfer of component from a gas mixture in packed towers?

A: Figure below shows flow of gas and liquid through stages of packing: where, Vb, yb is bottom vapor…

Q: mmary of adsporti

A: Adsorption is linkage of atoms, molecules and ions from gases, liquid to the surface. Adsorption…

Q: What is the difference between biological, chemical and physical wastewater treatment?

A:

Q: How do polymer and solute size, and affinity ligand, affect partitioning in aqueous two-phase…

A: In an Aqueous two-phase extraction (ATPE) method, the solute is transferred from one liquid phase to…

Q: Explain the process of selective non-catalytic reduction (SNR) technique in dry flue gas treatment?

A: The process of selective non-catalytic reduction technique in the treatment of dry flue gas is to be…

Q: What are the advantages of crystallization relative to filtration or adsorption for bioproduct…

A: The advantages of crystallization relative to filtration or adsorption for bio-product purification…

Q: Determine influent wastewater characteristics for the pesticide industry wastewater from the…

A: Introduction The heavy metals such as arsenic, cadmium, copper, tin, nickel, zinc, and mercury act…

Q: How could we use (a) relative permeability- saturation relationship and (b) imbibition rate to…

A: Introduction Relative permeability is "a direct measure of the ability of the porous system to…

Q: Why mass transfer is studied in Chemical Engineering? Name 3 applications of mass transfer in…

A: Mass transfer is defined as the transfer of mass or molecules based the concentration, mol fraction…

Q: What happens if the temperature is too low in the selective non-catalytic reduction (SNR) technique?

A: Selective non-catalytic reduction is a technique that is used to reduce nitrogen oxide emissions…

Q: 1. What is the principle of UV-Vis Spectroscopy for polymers.

A: Introduction UV–visible spectroscopy (UV–Vis )refers to absorption spectroscopy or reflectance…

Q: Why is maintaining constant supersaturation important during bioproduct crystallization?

A: The reason for maintaining constant supersaturation during bio-product crystallization is to be…

Q: What chemical reactions take place in Westvaco process?

A: The chemical reactions that takes place in the Westvaco process are to be mentioned.

Q: what is the common problem and solution of BTX extractive distillation?

A: BTX extractive distillation is used to remove benzene, toluene and xylene from refinery, petroleum…

Q: What happens when VOC concentrations are too low for direct condensation?

A: VOC or Volatile organic compounds are solvents used in the industries like tri-chloroethylene, MTBE…

Q: The thickness of a synthesized catalyst is expected to be 1-10 nm. Which of these microscopic…

A: TEM ( Transmission Electron Microscopy) is the most appropriate technique that can be used here for…

Q: What is the best suitable extraction method for phenol in water and why Large volumes of water…

A: Phenolic compounds are mostly found in plant species with enormous structural diversities. They can…

Q: Compute for Albumin concentration Given: Absorbance of the standard = 0.484 Absorbance of the sample…

A: Given data : Absorbance of the standard = 0.484 Absorbance of the sample = 0.502 Concentration of…

Q: What’s the purpose of adding saturated NaCl to biodiesel after separating the top layer biodiesel…

A:

Q: Can the presence of ligand on a catalyst surface reduced the reactivity of its surface? If yes/no,…

A: Yes, The reactivity of a catalyst can be decreased by ligand present on its surface. This is due to…

Q: The effects on polymer addition to the mixture of colloidal particles has been widely reported. With…

A:

Q: How can I remove AlF3 from the Colloidal solution?

A: Removing AlF3 from a colloidal solution requires a careful and specific approach due to the unique…

Q: a flue gas dehydration unit for post-combustion carbon capture.

A:

Q: Calculate the density of the engineering polymer. 994 pas & 9900 Bay pop

A:

Q: Highlight the major difference between distillation absorption and liquid-liquid extraction

A: Distillation, absorption, and liquid-liquid extraction are unit operations which are used to…

Q: What are the disadvantages of pfr used in Chemical processing

A: Plug flow reactor is the type of reactor used in chemical industries to perform chemical reactions…