Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. A power source supplies three different loads with the following ratings: Load 1: 4 kW, 2 kVAr inductive Load 2: 5 kVAr, 0.95 leading Load 3: 6 kVA, 0.85 pf lagging What is the total apparent, reactive and real power of

Q: A 274 V, 53 Hz single-phase system supplies power to a fully loaded 14 kW motor running at an…

A:

Q: A given load takes 40 kVA at 50% lagging power factor, while another load is connected in parallel…

A: Given: A load takes 40 kVA at 50% lagging power factor. Other load takes 80 kVA 86.7% lagging power…

Q: In a system of 132 kV, the circuit phase to ground capacitance is 0.2 uF and the circuit inductance…

A:

Q: A single phase AC motor draws 4.5 A from the 220 V, 50 Hz network. The active power drawn by the…

A: 1-ϕ AC motor draws current=4.5AI=4.5AV=220VP=720WSolving by the formula-P=VIcosϕPutting the values…

Q: 200/0°V L In the circuit in the figure; • Ly load draws 15 kVA with lagging power factor 0.6. • The…

A:

Q: For the following circuit, determine the maximum power, PMax in Watts that can be transferred to the…

A:

Q: Three phase power supply load R is 1699 VA, S is 15584 VA and T is 12818 VA. Find (a) the…

A:

Q: A voltage and current applied to a single phase load is v= 26 cos (300t+25°) and i= 12 cos (250t-…

A: Voltage and current signals are given  Find the active power and reactive power ?

Q: A voltage of 2500 is applied to an inductive circuit of impedance (5+j10)Q Determine circuit current…

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: Q1/ Find the RMS value of lo in the unbalanced three-phase circuit. 0.40 j20 a 1.60 j4 A 780 1540…

A: The solution can be achieved as follows.

Q: 7. Three sinusoidal voltage source of three phase generator have a. Inverse frequencies b. Random…

A:

Q: A load of 60 -j80 has a current of 9.60 A with a phase angle of 30°, the total reactive power is:

A:

Q: In matlab, To obtain voltage and current waveforms from transmission line which tool can be used O…

A:

Q: The following AC power source connected to two impedances and one resistive load. Analyze the…

A: The Given circuit is To analyze the circuit reactive components and reactive power developed…

Q: If the true power = 4W and the reactive power = 0VARs the power factor is ____________.     answer…

A: Power factor is defined as the cosine of angle between the voltage and current phasor in a circuit.…

Q: For the circuit shown in figure beside, find the total average power delivered to the circuit? * J5…

A:

Q: A lagging system with a complex load has a power factor of 0.75 and an applied voltage of 200V. if…

A: Given data, A lagging system has, Power factor cosϕ=0.75. Voltage, VL=200 V. Apparent power, S=10…

Q: A balanced three phase star connected load is supplied from a 400 V, 50 Hz supply. The per phase…

A:

Q: 13. A circuit is composed of a resistance of 22 ohms, an inductance of 0.11 henry and a capacitance…

A:

Q: In the circuit shown in Figure 3, the load consumes 600 VA with a power factor of 0.8. Determine the…

A: Given data, VA consumed by load S = 600 VA Circuit diagram is given by,

Q: 32) Bypass diodes are MOST often located in which PV system component? O Ihverters O Modules O…

A:

Q: Consider the following circuit, the value of Ris 2 220V f=50HZ Draw the power triangle indicating…

A:

Q: There phase power supply load R is 1699 VA, S is 15584 VA and T is 12818 VA. Find (a) the…

A:

Q: If the frequency were doubled, what would be the new impedance? R www R = 121 ohms XL = 41 ohms Xc =…

A: given here a circuit of RLC series circuit and asked to find the impedance of the circuit when…

Q: evalue of real

A:

Q: resistance of 20 Ω, an inductance of 0.2H and a capacitance of 100μF are connected in series across…

A: In this question , series RLC circuit is given....We have to find out impedance , current , voltage…

Q: A 30 kVARS capacitor bank is

A:

Q: asor voltage across a certain load is V = 1000/2 Z30° V, and the current I = 19/2 Z 50° A. Part A…

A: In this question , we will find power factor and power consumption in load...

Q: on A Load absorbs 10 KVA at a leading power factor of 0.6 The complex power is: Select one: O a…

A: The is a problem of circuits.  Given:- Load power |SL|= 10 kVA  Power factor, cos(phi)= 0.6 leading…

Q: An electrodynamometer type wattmeter is used to measure power in 1-o circuit. The connected load…

A: The solution is given below

Q: Consider the following parallel connected loads with the following characteristics L1: 1.2kW purely…

A: In this question we need to find the reactive power (in kVAR) needed to be supplied by a capacitor…

Q: d. The rms value of load current equals to 10.8 A 7.64 A 2.4 A O 16.97 A

A: 19. The given data from the question is as follows: Single phase half wave uncontrolled…

Q: What is the capacitance to be connected in parallel with the load to increase the power factor to…

A:

Q: 5. Box A consumes 1 kW at power factor 0.8 lagging. Box B consumes 1 KVAR at power factor 0.6…

A: The complex power in an AC system is defined as the product of rms value of applied voltage and…

Q: A Load absorbs 10 kVA at a lagging power factor of 0.6. The complex power is: Select one: a. 2000+…

A: The correct solution is given below

Q: Calculate the current total complex power and power factor ST= ST= pf = untis lagging, leading, or…

A: Voltage V = 240VFrequency f = 60 Hz The loads areLoad 1: 10 kVA @ pf = 0.55 laggingLoad 2: 5 kVA @…

Q: The 75 kW load in the circuit below has a lagging power factor of 0.85. What size capacitor must be…

A:

Q: Correct the power factor seen by the voltage source in the following circuit so that it is better…

A: It is given that:

Q: In three phase power measurement using star connected system, reactive power can be calculated…

A: In star connection Line voltage Vph  = VL (line voltage )/ √3 Line current IL = phase current Iph

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.