Please answer in complete and clear solution thank you Question A fluid is flowing into an inverted conical tank, 14in diameter on top and 24in deep at a rate of 7in3/min. Find how fast the water surface is rising when the fluid is 8in deep in the tank.

Q: A liquid having specific gravity of 2.0 is flowing in a 50mm diameter piper. The total head at a…

A: step 1-

Q: A large tank open to the atmosphere is filled with water to a height of 9.3 m from the outlet tap. A…

A: Discharge through the mouth piece= Q=Cd a2gH Velocity = Q/a= Cd2gH= 0.7072*9.81*9.3= 9.55 m/s So the…

Q: In a given setup as defined by the figure below, determine the rate of change in terms of h(t) given…

A:

Q: Answer within 3-5 sentences only. 1. What is the purpose of a Venturi meter? 2. What is a hydraulics…

A:

Q: Research on how to compute for Reynold's number when the fluid flow is not in a pipe. Give at least…

A: When the fluid flow is not in a pipe ,Reynold's number can be computed using different formulas.

Q: Transient Orifice Flow: Instructions Properly label the iterations. Take note of the tolerance value…

A: The flow of a fluid of a fluid is transient or unsteady if its flow  parameters [i.e. velocity and…

Q: 6. Fluid speed before the hydraulic jump is a) Coagulation chamber b) Pumn

A:

Q: 9. Fluid flow before the hydraulic jump is a) Normal b) Rough c) Smooth d) Zero

A:

Q: Make a flowchart showing the procedure on design of structural steel beams with doubly-symmetric…

A: We have to draw a flow chart for showing the procedure on design of structural steel beams with…

Q: In a two dimensional incompressible, steady flow, stream lines are drawn so that they are 20 mm…

A:

Q: lution so i c

A: Apply Bernoullis theorem P1γw+v122g+z1=P2γw+v222g+z2we knowP1=P2=Patm=0v1=0  (as large dia)

Q: An old pipe of diameter 2.5” is carrying water at a velocity of 4 ft/s. Determine the Reynolds…

A: Given data in question  Diameter of pipe  Length of pipe  Velocity of flow Kinematic viscosity  To…

Q: An open cylindrical tank contains two liquids with a specific gravities and depths as follows:…

A: Liquid 1 Specific gravity, S1 = 1.02 Depth, H1 =1.12m Liquid 2 Specific gravity, S2 = 1.02 Depth, H2…

Q: Question 3:- A tank with 100.58 kPa pressure is connected with manometer to measure the pressure.…

A:

Q: An old pipe of diameter 2.5” is carrying water at a velocity of 4 ft/s. Determine the Reynolds…

A: Given: Diameter of pipe, D = 2.5 in Velocity of flow, v = 4 ft/s Length of pipe, L = 200 ft…

Q: Water fows through 300mm diameter pipe ata velocit 3.0mls. Detemine the weight flow rte in Nis. For…

A:

Q: OPI P2 50 mm Ø 50 mm Ø 10 m P3 30 mm Ø

A:

Q: A 1.8-m rigid tank initially contains air at 100 kPa and 22°C. The tank is connected to a supply…

A: Volume of the tank, V=1.8 m3 Initial pressure inside the tank, P1=100 kPa Initial temperature inside…

Q: Calculate the maximum water-hammer pressure created in a rigid pipe with a starting water velocity…

A: Given data in question  Velocity of water Length of pipe Valve closure time Temperature  To find out…

Q: Energy losses in pipe: L = 1.3m, D= 14 mm, ε/D = 0.007 Type of Reynold's Calculated Calculated pipe…

A:

Q: Water at 20°C flows through a 3 cm ID smooth brass tube at a rate of 0.002 m³/s. What is f for this…

A: Given :

Q: 1) Water at 140 °F flows in a 3 inch diameter pipe. Calculate minimum velocity for which flow is…

A: Given data - Diameter (D) = 3 inch = 0.25 ftTemprature = 140 °F Find out - Minimum velocity for…

Q: 1. Water flows through a 12 inches by 6 inches venturi meter at the rate of 1.49 ft/s and the…

A:

Q: A 5-m container having the dimensions 1.2x1.2 m² has a sharp-edge offic 100mm located at its side…

A: H = 3 m deepa = C = 0.60g = 9.81height of the vessel = 5 m orifice from below = 0.4 m

Q: 8 A cast iron pipe (roughness = 0.010 in) connects two reservoirs. The pipeline is 1300 ft long and…

A:

Q: Kindly answer asap with neat solution and try to round off only at final answers thank you ( please…

A: In this questions 3 pipes are given of dia 400 mm and 350 mm and 300 mm and the change in elevation…

Q: Calculate the airflow velocity if the inner diameter of the pipe is 50 mm and the flow rate is a…

A: Q=100m3/hr D=50mm To find flow velocity

Q: The highest velocity (in cm/sec) for flow of water of viscosity 0.01 poise to be laminar in a 6 mm…

A: Laminar pipe flow- Viscosity=0.01 poise Pipe diameter=6 mm Highest velocity of flow of water=?

Q: If water at 180°F is flowing with a velocity of 4.50 ft/s in a standard 6-in Schedule 40 pipe,…

A:

Q: Urgent, need correct answer as soon as possible with complete solution. Box final answer in 4…

A: Diameter=10mm

Q: 300 mmø 150 mmø Hgi13.6)

A:

Q: A hilltop subdivision takes water from a river 500 ft below it during the night through a pump…

A:

Q: The flow measured with a d/p cell is 16,000 scfh. If the temperature correction factor is 1.4 and…

A:

Q: URGENT Please answer this problem in 30minutes. I need correct answers with complete and step by…

A:

Q: A 20 mm diameter pipe has a length of 80 m. Water with a viscosity of 0.04 Pa-sec is flowing thru…

A:

Q: In the chamber shown, section (1) has a diameter of 4 in., and the flow is 2.8 ft3/s. Section (2)…

A:

Q: A cylindrical tank 10 ft. high and 4 ft in diameter placed so that its axis is horizontal. It is…

A:

Q: Choose the correct answer 1- If the dynamic viscosity of a fluid is 0.5 poise and specific gravity…

A: Since the question number to be solved is not specified, the solution for Question 01 is as follows:…

Q: 1.0 ft /s of water flows through 100 ft of 6 in steel pipe at a temperature of 70 degrees F. The…

A: Given, Q=1 ft3/s L=100 ft of 6 in T=70°F rd=20ν=0.739×10-5 Diameter= 6 in=0.5 ft

Q: A U-tube with uniform legs and both open to the atmosphere has its bottom portion contains mercury…

A:

Q: 8. Fluid height after the hydraulic jump is a) Normal b) Low c) High d) Zero

A:

Q: Q2) the airflow system is measured with a venturi having dimensions a 5.0 cm-diameter pipe. The…

A:

Q: Determine the size of the control valve required to control the flow rate of water. The maximum flow…

A: Given Data: The maximum flow rate is Q=85 gal/min. The available pressure drop across the valve is…

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?