Pipe (2) is supported by a pin at bracket C and by tie rod (1). The structure supports a load P at pin B. Tie rod (1) has a diameter of 10 mm and an allowable normal stress of 175 MPa. Pipe (2) has an outside diameter of 48 mm, a wall thickness of 6 mm, and an allowable normal stress of 165 MPa. Assume x₁ = 3.2 m, x2 = 2.4 m, and y₁ = 3.1 m. Determine the maximum load Pmax that can be supported by the structure without exceeding either allowable normal stress. 3₁ (1) Answer: Pmax= i B P KN

Q: A prismatic steel bar of square cross section 3 in. x 3 in. is subjected to a tensile load P = 135…

A: Solution: Given Data: P=135 kipsAn=6 in2θ=45o

Q: Rigid bar ABC is supported by a pin at bracket A and by tie rod (1). Tie rod (1) has a diameter of…

A:

Q: The metallic hollow pipe shown in Figure Q2 is fixed at its lower end and free at its top end, and…

A:

Q: A circular nylon pipe supports a downward load PA= 10 kN. which is uniformly distributed around a…

A: Given, PA=10 kN, PB=20 kNd1=50 mm, d2=60 mm, d3=55 mm, d4=65 mmL1=300 mm, L2=400 mm

Q: 2. Two elastic bars are connected and supported as shown. The thermal load is a 10°C temperature…

A:

Q: The bell-crank mechanism is in equilibrium for an applied load of F₁ = 12 kN applied at A. Assume a…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.