The (Figure 1) shows two thin beams joined at right angles. The vertical beam is 16.0 kg and 1.00 m long and the horizontal beam is 21.0 kg and 2.00 m long. Neglect the lateral dimensions of the beams. Fi Figure 1 of 1 Part Calcu Expr 00m 수。 2.00 m Find the center of gravity of the two joined beams. Express your answer in the form r, y, taking the origin at the corner where the beams join. Express your answers in meters separated by a comma. Vη ΑΣφ I, y = Submit Previous Answers Request Answer X Incorrect; Try Again; 5 attempts remaining Part B Calculate the gravitational torque on the joined beams about an axis through the corner. Express your answer with the appropriate units. μΑ Value Units T =

Q: The three concurrent force acting in the beam can be replaced with a single force , R, compute the…

A: This is a problem regarding the resultant of forces. The figure for the problem can be given as: The…

Q: There are two forces on the 1.45 kg bax in the averhead view of the figure but anly one is shown.…

A:

Q: A uniform plank of length 2.00 m and mass 31.0 kg is supported by three ropes, as indicated by the…

A: Given, Mass of the plank (m) = 31.0 kg Weight of the person (W)=680 N d=0.500 m

Q: A professional athlete tears their Achilles tendon. There are two muscles in the back of the leg…

A:

Q: Test No Weight (N) H, (cm) H2 (cm) P.E. (initial) (J) P.E. (final) (J) Loss in P.E. (J) 1.0 50 30.5…

A:

Q: A sign is held by the following beam and cable. The sign has a mass of 11 kg. The beam has a length…

A: The objective of the question is to find the tension in the cable that is holding a sign and a beam.…

Q: Two spheres are cut from a certain uniform rock. One has radius 4.45 cm. The mass of the other is…

A: Given data:  Radius of sphere 1 (r1) = 4.45 cm Mass of sphere 2 (m2) = 6 m1 Required: The radius of…

Q: 1:) Find the resultant using componunt method. ti- loo N ; GO N ofE f2= 200 N; NNw Fs : 300 N, 40°…

A: Solution:-Given that

Q: Two forces are applied to the construction bracket as shown. Determine the angle which makes the…

A: Solution:-

Q: 10. Two forces, one of magnitude 5.3 N and the other of 11.9 N act on an object. The angle between…

A: Two forces are magnitude of 5.3 N and other are 11.9 N act on an object. The angle between is 44°

Q: 1. Problem 1: Determine the resultant in Newtons of the two forces acting on the screw using…

A: Given that:

Q: The leg and cast in the figure weigh 220 N (w;). Determine the weight w, and the angle alpha needed…

A:

Q: To keep the calculations fairly simple, but still reasonable, we shall model a human leg that is…

A: Disclaimer: “Since you have asked posted a question with multiple sub-parts, we will solve the first…

Q: At what angle should the two forces 2P and √2 Pact so that the resultant force is P√10 ? A) 45% B)…

A: Given data, Resultant force F=P10 Forces are given F1=2P, F2=2P

Q: B) (22M Two rods are attached at A to lever AB. If the resultant of two force are 1200N, vertically…

A: By arranging the force vector to form a triangle, where R is the resultant force of two forces F…

Q: Three forces act on the bracket. Determine the magnitude and direction (?) of F1 so that the…

A:

Q: 1.56 The vertical post is secured by three cables. The cables are pre-tensioned so that the…

A:

Q: One cubic meter (1.00 m3) of aluminum has a mass of 2.70 x 103 kg, and the same volume of iron has a…

A: Details Given: Mass of Aluminum = 2.70*103kg Volume of Aluminum = 1.00m3 Mass of iron = 7.86*103kg…

Q: Figure 1 shows TwO (2) forces acting on the pulley with FA = 400 N with angle 30º from y axis. If…

A: Given FB=400 N Resultant force F=400 N The angle between FA and FB from the figure is ϕ=300+900=1200…

Q: Two forces are applied to the construction bracket as shown. Determine the angle e which makes the…

A: Given :  F1  = 800 Ib F2= 425 Ib θ1 =700θ2 = ?  and Magnitude R

Q: Needs Complete solution with 100 % accuracy don't use chat gpt or ai plz plz plz plz plz.

A: Approach to solving the question:As given in the answerDetailed explanation:Given Data:Total mass =…

Q: The mast of a ship supports forces from three cables as shown. If F= 350 lb, determine the value of…

A:

Q: A round trunk duct fitting has a branch that forms an angle of 30° with themain duct. The main duct…

A: We know, Sine of an angle is given by: sin(θ) = perpendicular hypotenuseGiven:θ =30°, perpendicular…

Q: A square steel plate is 14.0 cm on a side and 0.800 cm thick. Assume that the plate is oriented with…

A: Side of square plate = 14.0 cm thickness of square plate,t = 0.8 cm Magnitude of force,F = 5.0×105N…

Q: The upper leg muscle (quadriceps) exerts a force of Fo= 1300 N, which is carried by a tendon over…

A: It is given that,The upper leg muscle exerts a force of FQ=1300 N.

Q: Two forces of 70 N act on an object. The forces form an angle of 57o between them. Calculates the…

A: The magnitude of each of the two same forces, F=70 N The angle between the forces, θ=57°

Q: A sign is held by the following beam and cable. The sign has a mass of 11 kg. The beam has a length…

A: The objective of this question is to calculate the tension in the cable that is holding a sign and a…

Q: Four forces are exerted on the eyebolt as shown. If the net effect on the bolt is a direct pull of…

A: Vector.

Q: SAP..

A: Given, True value of weight= 5.00 g Measured value of weight = 5.5983 g Percentage error is…

Q: Given the vectors: A=7i-8j+3k ,B=2i-4j-7k , C=5i+3j+4k  a) The possible dot products of the…

A:

Q: The measurements x1 = 10m, x2 = 8m, and x3 = 6m represent the sides of a rectangular parallelepiped…

A:

Q: Consider the chicken shown in the figure, which is balancing itself against a strong wind. Part A:…

A: With respect to the center of mass of the chicken, it experiences two forces, (i) the force due to…

Q: It seems there is an technical issue with engineering subjects like civil and mechanical ,As i am…

A: Step 1:

Q: Forces with magnitudes of F₁ - 165 newtons and F₂- 254 newtons act on a hook (see figure). The angle…

A:

Q: The leg and cast in the figure weigh 220 N (w1). Determine the weight wz and the angle alpha needed…

A: Given: The weight of the leg and cast is 220 N. The tension in the left rope is 110 N. The free-body…

Q: Jamal and Dayo are lifting a large chest, weighing 264 lb, by using the two rope handles attached to…

A: Visualize the Problem:

Q: One cubic meter (1.00 m3) of aluminum has a mass of 2.70 x 103 kg, and the same volume of iron has a…

A:

Q: The two structural members, one of which is in tension and the other in compression, exert the…

A: Solution:-Given thatJoint O of the structural member;

Q: Two forces are applied to the construction bracket as shown. Determine the angle which makes the…

A: Vector components.

Q: Two forces are applied to the construction bracket as shown. Determine the angle which makes the…

A: Free body diagram gives whole idea of the forces acting. Force brings about motion and changes in…

Q: 2.90 The dimensions are b = 3 ft and h 1 4 ft and F = 300 lb. The vector sum of the forces acting on…

A: The dimensions are: b=3 ft, h=4 ft.The force is F=300 lb.The vector sum of the forces acting on the…

Q: A 392 N force parallel to the plane is required to support a body on an inclined plane of the height…

A:

Q: given A = 3i-4k and B = 2i-j-k How do I find the angle subtended by (A-B) and (A cross B)

A:

Q: A cable stretched between the fixed supports A and B is under a tension T of 2.3 kN. Express the…

A:

Q: A wire can be broken by applying a load of 20 kg wt. Then force required to break the wire of twice…

A: We are aware that a load of 20 kg wt can break a wire.The next step is to determine the force…

Q: Two rods and one cable are attached to the supports at O. If two of the forces are as shown…

A:

Newton's First Law of Motion

If a very smooth ball is rolled down an inclined surface with zero friction, the ball will continue to roll indefinitely for an infinite time, in an attempt to reach to the same height on the opposite hill!