18E. (a) An 11.0 kg salami is supported by a cord that runs to a spring scale, which is supported by another cord from the ceiling (Fig. 5-43a). What is the reading on the scale? (b) In Fig. 5-43b the salami is supported by a cord that runs around a pulley and to a scale. The opposite end of the scale is attached by a cord to a wall. What is the reading on the scale? (c) In Fig. 5-43c the wall has been replaced with a second 1.0 kg salami on the left, and the assembly is stationary, What is the reading on the scale now? Spring scale Spring scale 11 kg (b) Spring scale I1 kg (a) 11 kg 11 kg (6)

18E. (a) An 11.0 kg salami is supported by a cord that runs to a spring scale, which is supported by another cord from the ceiling (Fig. 5-43a). What is the reading on the scale? (b) In Fig. 5-43b the salami is supported by a cord that runs around a pulley and to a scale. The opposite end of the scale is attached by a cord to a wall. What is the reading on the scale? (c) In Fig. 5-43c the wall has been replaced with a second 1.0 kg salami on the left, and the assembly is stationary, What is the reading on the scale now? Spring scale Spring scale 11 kg (b) Spring scale I1 kg (a) 11 kg 11 kg (6)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Question 1) The figure shows a person wearing weight boots and doing lower leg flexion/extension exercise in sitting position to strengthen the quadriceps muscles and a simple mechanical model of his leg. W 1 is the weight of the lower leg, Wo is the weight of the boot, FM is the magnitude of the pulling force exerted on the tibia by the quadriceps muscles through the patellar tendon, F, is the magnitude of the reaction force acting on the tibiofemoral joint. Point O is the center of the tibiofemoral joint, Point A is the point where the patellar tendon attaches to the tibia, Point B is the center of gravity of the lower leg, C point of gravity is the center of gravity of the boat. The distances between point O and points A, B and C were measured as a = 10 cm, b=22 cm and c=43 cm, respectively. The angle between the long axis of the tibia and the horizontal is B=38°, the angle between the action line of the quadriceps muscle strength and the long axis of the tibia is a=18°. Points O,…
A box weighing 450N is being pulled at an angle of 38 degrees along a level floor. If the force applied by the rope is 260N, what is the normal force experienced by the box (assume equilibrium)?
Block B with a mass of 13kg A with a mass of 27kg stands on the corner as shown in the figure. The kinetic coefficient of friction between the block and the angle is 0.25 and the static coefficient of friction is 0.30, and there is no friction between the angle and the horizontal surface and the pulleys. (i) calculate the maximum mass of Block C, which will ensure that Block B does not shift over the corner a. (ii) if the mass of Block C is x %greater than the mass calculated in option (i), calculate the acceleration of Block B and C of the angle A in m/s2
A vertical column supports a body having a mass of6 Mg (or 6 tonnes). Calculate the approximate valueof the upward force in kN exerted by the column.
17-101. If the coefficient of static friction at C is µ, = 0.3, determine the largest force F that can be applied to the 5-kg ring, without causing it to slip. Neglect the thickness of the ring. 45° 30 0.4 m
A 5.00 [kg] block is pushed by a 30.0 [N] force against a rough wall that is inclined at an angle of 70°. What should be the minimum coefficient of static friction μsμs so that the block will not slide down the ramp?
A sphere of mass 5.0 × 10-4 kg is suspended from a cord. A steady horizontal breeze pushes the sphere so that the cord makes a constant angle of 16° with the vertical. Find (a) the magnitude of that push and (b) the tension in the cord. (a) Number Units (b) Number Units MO i
An initially stationary box of sand is to be pulled across a floor by means of a cable in which the tension should not exceed 1090 N. The coefficient of static friction between the box and the floor is 0.330. (a) What should be the angle between the cable and the horizontal in order to pull the greatest possible amount of sand, and (b) what is the weight of the sand and box in that situation? (a) Number i (b) Number i Units Units
5-61. If d = 1 m, and 0 = 30°, determine the normal reaction at the smooth supports and the required distance a for the placement of the roller if P 600 N. Neglect the weight of the bar. =
An initially stationary box of sand is to be pulled across a floor by means of a cable in which the tension should not exceed 1110 N. The coefficient of static friction between the box and the floor is 0.430. (a) What should be the angle between the cable and the horizontal in order to pull the greatest possible amount of sand, and (b) what is the weight of the sand and box in that situation? (a) Number i (b) Number i Units Units
Find the tension force T in the cable, and the compression force C on the strut (bar). Refer to Fig. 2 above.
(2) uhai block is resting (Kg mass 10) on a rough horizontal surface for which the coefficient of friction is (u=0.30). Determine the force P applied to the *.block 3 P 0=30°