Shaft alignment is the process of aligning twoor more shafts with each other to within atolerated margin. It is an absolute requirementfor machinery before it is put into service. Forall occasions, it is important that the shaftmeet the specifications first. Consider 0.650 ±0.005 cm as the specifications for the shaftdiameter. If the measurements for thediameter of a shaft has a mean value of 0.65Ocm and a standard deviation of 0.003 cm, whatpercentage of the total number of shafts willbe tolerable?87.6%90.5%none of these83.1%

Answered: Image /qna-images/answer/38026729-e4b8-42ef-9f96-e2284340e938.jpg

Answered: percentage of the total number of…

A First Course in Probability (10th Edition)

10th Edition

ISBN:9780134753119

Author:Sheldon Ross

Publisher:Sheldon Ross

Chapter1: Combinatorial Analysis

Section: Chapter Questions

Problem 1.1P: a. How many different 7-place license plates are possible if the first 2 places are for letters and...

See similar textbooks

Similar questions

show full and complete procedure. HANDWRITTEN only
The µ is less than 10 mins per day
A 30-second commercial during Super Bowl XXXVII in 2003 cost advertisers 2.2 million. For the first Super Bowl in 1967, an advertiser could have purchased approximately 26.19 minutes of advertising time for the same amount of money. (a) Assuming that advertising cost is proportional to its length of time, find the cost of advertising, in dollars/second, during the 2003 Super Bowl. cost= dollars/second. (round to nearest cent and do not enter commas) (b) Assuming that advertising cost is proportional to its length of time, find the cost of advertising, in dollars/second, during the 1967 Super Bowl. cost = dollars/second. (round to nearest cent and do not enter commas) (c) How many times more expensive was Super Bowl advertising in 2003 than in 1967? times more expensive (round to nearest whole number)
A bucket that weighs 4.6 pounds and a rope of negligible weight are used to draw water from a well that is 78 feet deep. The bucket is filled with 35 pounds of water and is pulled up at a rate of 1.5 feet per second, but water leaks out of a hole in the bucket at a rate of 0.25 pounds per second. Find the work done pulling the bucket to the top of the well. Your answer must include the correct units (You may enter Ibf or Ib*ft for ft-lb.) Work =
(Vx - 1/Va)
Length and width of a rectangle are measured with errors of +3% and ±5% respectively. Estimate the maximum percentage error in the area.
(please solve within 15 minutes I will give thumbs up thanks)
Give the average rate of the cost of milk from 2011 to 2013 and show your work. (label as a rate using the word “per”) Assuming the transfer from 2011 to 2013 continues, give an estimate of the cost of 2020
2.) An underwater drone is being used to explore ancient ruins at the bottom of the ocean. It begins at sea level. The underwater drone dove at a rate of 8 feet per minute. What is the elevation of the underwater drone after 13 minutes?

Recommended textbooks for you

A First Course in Probability (10th Edition)

Probability

ISBN:

9780134753119

Author:

Sheldon Ross

Publisher:

PEARSON

A First Course in Probability

Probability

ISBN:

9780321794772

Author:

Sheldon Ross

Publisher:

PEARSON

A First Course in Probability (10th Edition)

Probability

ISBN:

9780134753119

Author:

Sheldon Ross

Publisher:

PEARSON

A First Course in Probability

Probability

ISBN:

9780321794772

Author:

Sheldon Ross

Publisher:

PEARSON

SEE MORE TEXTBOOKS

percentage of the total number of shafts will be tolerable?