%3D The water in an aquarium will be drained for cleaning. A flexible tube (D = 4mm) w be used to drain the aquarium through siphoning. If the vertical distance between the end of the tube and the water surface is 60cm and there is a head loss of 10cn solve the volumetric flowrate.

%3D The water in an aquarium will be drained for cleaning. A flexible tube (D = 4mm) w be used to drain the aquarium through siphoning. If the vertical distance between the end of the tube and the water surface is 60cm and there is a head loss of 10cn solve the volumetric flowrate.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A capillary tube of 1.3 mm diemeter is immersed vertically in water exposed to the atmosphere.…

Q: Crude oil (with specific weight γoil = 55 lb/ft3 ) is pumped at a rate of 400 gallons per minute…

A: Given data, Q = 400 gallons/min = 4007.48×60ft3/s density of soil (γoil) = 55 lb/ft3pressure at A…

Q: Aliquid of density 900 kg/m³ rises to a height of 7 mm in a capillary tube of 2 mm Internal…

A: Density of the liquid, The angle of contact of the liquid in the glass, The diameter of the…

Q: Determine the pressure at the center of the pipe from the piezometer shown. 200mm WATER 75mmØPIPE

A: Given:- a piezo meter is attached to the pipe as shosn below

Q: An 8 in diameter (f=0.028) 500 ft long discharge a 3 in diameter water jet into the atmosphere at a…

A: Using the continuity equation calculating the jet velocity: AV=AjVj…

Q: Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two…

A: Given data Hydraulic head at 1 (h1) = 66cm Hydraulic head at 2 (h2) = 54cm Travel distance (L) =…

Q: COMPUTE THE CAPILLARY RISE IN mm. OF PURE WATER AT 10^0 C EXPECTED IN A 0.8 mm θ TUBE

Q: A semi-circular tube with a diameter of 20 mm is partially submerged on a fluid with a surface…

A: Diameter of tube, surface tension of liquid and specific weight of liquid have been given and it has…

Q: Flow rate of a fluid (density = 1000 kg/m³) in a small diameter tube is 800 mm³/s. The length and…

A: Given:Density of the fluidρ=1000 Kg/m3DischargeQ=800 m3/sQ=800×10-9 m3/sLength of the tube(L)=2…

Q: (4) Consider that we have a horizentral pipe, like shown in the sketh, which is carrying in this…

A: Elevation of tank (z1) = 100 mElevation of pipe (z2) = 20 mDiameter of pipe (D) = 20 cm = 0.20…

Q: In a pipe flow from an elevated tank, a control valve is placed adding minor head losses in the…

Q: EL 7 m (s, -0,75) EL 4.5 m EL 4.35 (s2 - 1.00) EL 2.15 EL 2 m (s3 1.50) EL O

A: The pressure at a different level, P = γH. γ - Unit weight of the fluid.H - Head of the fluid.…

Q: A valve is suddenly closed in a 200 mmø pipe. The increase in pressure is 700 kPa. Assuming that the…

A: compute the water hammer pressure in kPa at the valve if it is closed in 3 sec.

Q: Determine the weight of the block

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: An incompressible fluid flows through a horizontal pipe which tapers from a diameter of 2 cm to a…

Q: Flow of a liquid in a smooth 3 cm pipe yields a head loss of 2 m per meter of pipe length when the…

A: Given- a pipe carrying a liquid with the mean velocity of 1m/s. Required- to find friction…

Q: 10.8 For laminar flow in a tube calculate the position of the average cross-sectional velocity.…

A: Step 1

Q: The flow rate in a 300 mm diameter pipe is 0.226 m³/s. The flow is known to be turbulent and the…

Q: A pressurized tank discharges its alcohol through a square orifice (c = 0.64, cy = 0.97). If minor…

A: step 1-

Q: A viscous liquid (p = 1.2x10³kg/m³, u = 10m//s through a horizontal, 4 mm diamete a 1 m length of…

Q: O-0.13 Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two…

A: given- Hydraulic head at 1, h1=24 inchesHydraulic head at 2, h2=11 inchesdistance travelled, L=100…

Q: In a given setup, distilled water flows towards the inside and goes outside of the vessel as shown…

A: Velocity of inflow through pipe 1, V1=30ftsecdiameter of pipe, d1 =3in =312ft =0.25ftOutflow rate…

Q: A flow of liquid is discharged from a long horizontal pipe of circular cross-section into the…

Q: c) For the system shown in Figure 3.1, calculate (i) the volume flow rate of water from the nozzle…

A: To find (a)Q=? (b)Pa=?

Q: what will be the pressure gradient (kpa/m) at L=30 cm through the nozzle? At L=0, the liquid flows…

A: first finding pressure at respective sections by applying bernaulli's theorum and here given…

Q: A mixture of high pressure water and steam at a rate of 0.5 kgs-¹ flows up a vertical tube with an…

A: A vertical tube is basically used for carrying high-pressure water and steam at a specific pressure…

Q: Q1: A pressure of 10 kPa, gage, is applied to th surface of water in an enclosed tank as showi in…

A: to find actual discharge

Q: cylindrical liquids, (s=1.05) respectively. An orifice 100 mm at the bottom with a discharge of…

Q: Flow rate of a fluid (p = 1000 kg/m³) in a small diameter tube is 800 mm³/s. The length and diameter…

A: The density of the fluid, = 1000 kg/m3Flow rate = 800 mm3/sLength of tube = 2 mDiameter of tube =…

Q: 11. A 350 mm by 150 mm venturi meter is installed in a vertical pipeline carrying water as shown in…

Q: A 30m long, 20mm diameter steel pipe is used to drain an oil tank determine the discharge when the…

Q: What is the required pump power (Pa) for the system below?

Q: open tank contains 5.7 m of water covered with 2.8 m of kerosene with unit weight of 8.0 kN/m³. Find…

Q: Compute the capillary rise in mm of pure water at 10 Celsius expected in an 0.8 mm diameter tube.

Q: Show complete solutions and figures. The shown tank with an attached manometer contains water unit…

Q: 2.5 m A -3.0 m Orifice 1 Water B -7.5 m- 2.0 m

Q: Oil (relative density or specific gravity of 0.8) flows through a pipe. the diameter is 50 cm. The…

Q: -8.33 -0.12 8.33 (1) 0.12 -L Darcy Experiment A set-up of Darcy Experiment involves measuring the…

A: Given data Hydraulic head at section-1 (h1) = 66cm Hydraulic head at section-2 (h2) = 54cm Length…

Q: Water is pumped up from a reservoir to a smaller holding tank. If the flow rate through the pipe is…

A: NPSH is the net positive suction head, which is measured in the centrifugal pump.If the local…

Q: An le Volve Pump open P=150 kPa Water sprotruding entrance

A: Given data in question Diameter of pipe Density of water Dynamic viscosity of water Length of pipe…

Q: 6. A liquid having long. The head loss of the pipe due to friction is 22 m. a. Compute the friction…

A: Given the fluid flow through pipe with Reynolds number less than 2000. The flow is Laminar. So…

Question

The water in an aquarium will be drained for cleaning. A flexible tube (D = 4mm) will
be used to drain the aquarium through siphoning. If the vertical distance between
the end of the tube and the water surface is 60cm and there is a head loss of 10cm,
solve the volumetric flowrate.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

15. If the pressure in pipe A is 6 kPa, the SG = 0.85 pressure in pipe B =. ........... psig. Water 90 mm 30% a. 1.27 70 mm b. 8.73 40 mm C. 60.17 SG = 13.6 Mercury d. None of all these
4. The pressure intensity at a point in a fluid is given 4.9 N/cm². Find the corresponding height of fluid when it 5. An oil of sp. gr. 0.8 is contained in a vessel. At a point the height of oil is 20 m. Find the corresponding m [Ans. (a) 5 m of water, (b) 6.25 m of cil is : (a) water, and (b) an oil of sp. gr. 0.8. (Ans. 16 m) and pbove it an oil of sp. gr. 0.8 for a depth of 2 m height of water at that point.
A 76-mm diameter orifice discharges 0.022 m3/s of liquid under a head of 3.5. The diameter of the jet at the vena çontracta is found by calipering to be 64 mm. Calculate the coefficient of discharge, Cd.
A cylinder is placed in a steady water flow as shown. Calculate the pressure difference PB - PA in psi if the flow speed at A is 10 ft/sec. .A O 1.04 O 1.53 0.67 1.92 0.82 O 1.74
2. Given the figure below, solve for flow rate in the venturi meter. (C = 0.984) 2 (ø - 250mm) 0.3m oil (as2) 0.8m - glycerin (1.86)
A cylindrical tank of water is 20 m in diameter and 3.5 m tall. There is a 1.0 cm diameter hole at the bottom from which water is leaking. A feeder pipe at the top of the tank, 4.0 m above the ground delivers water at a rate of 0.02 m/min. Ir the tank is initially half full, tal what is the water flow rate in m^3/sec from the top feeder pipe? (bi what is the pressure at the bottom of the tank? (Hint: Bernoul's principle) () what is the water speed at the bottom? (d) what is the leaking flow rate at the bottom? fe) at what rate is the volume of water changing? (Assume the tank is open to air at the top)
Consider the tank shown in (Eigure 1). Take po = 900 kg/m³, Pu=1000 kg/m³, and pHg = 13 550 kg/m³. 0.6 m 0.8 m 100 mm h 1 of 1 > P Part A Determine the level of water in the tube if the depths of ol and water in the tank are 0.6 m and 0.8 m. respectively, and the height of mercury in the tube is h=0.075 m A Express your answer to three significant figures and include the appropriate units. PA h = 240 Submit + Provide Feedback → OF ? mm Previous Answers Request Answen X Incorrect; Try Again; 4 attempts remaining Next > 1231 AM 0
5-64. A thin rubber tube of 25 mm inside diameter is used to siphon water from the large tank of Figure 5.56. To prevent the tube from collapsing, the pressure inside the tube can not be less than 50% of the pressure outside the tube. Determine the smallest value of h to prevent the siphon from stopping due to collapsing of the tube. 2.5 m 5 m Figure 5.56 System for Exercise 5-64. THANK SUNTETICE Full Michifo Nas s itset SCH
Q-Water flows through a pipe having an inner radius of 10 mm at the rate of 36 kg/hr at 25° C. The viscosity of water at 25°C is 0.001 kg/m.s. The Reynolds number of the flow is