%3D ווו The following data were obtained when a hydrate was heated: crucible + sample 31.781 g 30.501 g empty crucible crucible + sample after heating 31.100 g 1. Calculate the % water in the hydrate. SHOW WORK. -30.S01g 0.6819x100=8. 618L18 31. 781g-31-109 %3D mas of nater lost 6se.8 2. Decide whether the sample was BaCl2 2H20 or MgCl2 6H20 by calculating the theoretical % water in each compound and comparing to your answer in #1. SHOW WORK. Formula weights: MgCl2 95.218 g/mole BaCl2 208.25 g/mole 18.0153 g/mole O'H 68

Q: 2 2) The rate constant for the reaction O (g) +03 (g) > 2 O₂ (g) at 298 K is expressed in…

A:

Q: Information: A student performs an experiment with three unknown liquids. The following measurements…

A: The mass per unit volume of a substance is known as the density of the substance. The density of a…

Q: 2. Draw the Lewis structure of the dipeptide that results when histidine reacts with valine. 3. Draw…

A: In Lewis structures atom and its position in the molecule are shown using its chemical symbol. Lines…

Q: 1. Calculate the missing density given the following: Mass Volume Density 4.609 kg 0.5800 L ? g/mL

A:

Q: What is the total number of nitrogen atoms on the right-hand side of this chemical equation? 3…

A: To understand fully chemical equation reaction must be balanced. In any balanced chemical equation…

Q: 4. It seems like hydrogen and oxygen can bond the way salts do, but let's look a little deeper. Fill…

A: The nature of the atoms or the elements that make up the molecule defines the bonding of the atoms…

Q: question 4

A: The Gibbs Duhem equation for binary mixture is written as follow:

Q: 2. If you want to produce 85 g of silicon, how many grams of magnesium will you need? How many grams…

A: The chemical reaction that takes place between sand and magnesium metal to produce elemental silicon…

Q: Calculate the value of [OH] from the given [H3O*] in each solution and label the acidic or basic: a.…

A: Given : We have to calculate the concentration of hydroxide ion.

Q: Question 4

A: A nucleophile is always in situ to attack an electrophilic center. As carbonyl carbon is…

Q: Draw the major organic product for the reaction shown. (CH3)2CULI

A:

Q: 2. Report the bond lengths and energies for C-C bonds with bond order of 1, 2, and 3. Explain any…

A: The average bond energies of the different bonds are shown below: C-C : 347 kJ/mol , C=C : 619…

Q: 2) A three gram sample containing an unknown amount of Sn² is titrated with 37.5 mL of a 0.015 M…

A: #2: Total mass of the unknown sample containing Sn2+ = 3.00 g  Volume of 0.015 M dichromate…

Q: A gas mixture contains HBr, NO,, and C,H, at STP. If a tiny hole is made in the container, which gas…

A: Effusion rate and kinetic energy of gas depends on the temperature and the molar mass of gas.

Q: 2. When 1.3 g of C4H9NO is dissolved in 150 mL water, the resulting solution is 0.50% ionized at…

A:

Q: 3. A sample of the inhalation anesthetic gas Halothane, in a 500-mL cylinder has a pressure of 2.3…

A:

Q: Be sure to show your work. 1. What is the molar mass of CO2?

A: NOTE : Since you've asked multiple questions,we'll solve only first question for you. If you want…

Q: 4. In three separate trials, you determine the density of an unknown object to be: Trial 1: 11.579…

A:

Q: Chapt 6,7 1. Give the complete electron flow of the SN2 reaction, be sure to clearly show the…

A:

Q: 4. When titrating 0.150 M HCI with a calcium hydroxide solution of unknown concentration, 35.0 mL of…

A: (a) when HCl and calcium hydroxide react they give Calcium Chloride and water as - 2HCl(aq) +…

Q: Question 2

A: Given,The molarity of sulphuric acid in a fully charged car battery is 5.2 M.  When, fully…

Q: 4. What is the volume percent of a solution prepared by adding enough water to 200. mL of acetone to…

A:

Q: Draw the major organic product for the reaction shown. NH2 HCI (cat.)

A: Given reaction is imine formation reaction.  Aldehyde reacts with amine to form imine. Let's see…

Q: 2. Two emissions of light were observed. One emission (A) was at 410 nm and the other (B) was at 690…

A:

Q: Question 4

A: Given data:

Q: 4. Write the full electron configuration for phosphorus, atomic symbol P, then draw an orbital box…

A:

Q: (a) Create a table to rank the following pure substances from highest to lowest boiling point. Add a…

A: The temperature applicable to break the available intermolecular forces in given molecules is said…

Q: 2. A student doing this experiment was puzzled by the fact that while each of the individual…

A: Hazardous Solution contains toxic ,hazardous chemicals that are harmful for nature.

Q: 2) What are the structures of A, B, and C? NBS hv CH₂=CHCO₂H C A NaOCH₂CH3 CH3CH₂OH, A 1. 03 2.…

A: Question 2: N-Bromosuccinimide (NBS) is used as an allylic/benzylic brominating agent.

Q: Question 2

A: The specific heat capacity for a given chemical substance or a solution refers to the amount of heat…

Q: A 2073 g sample of ground water is found to contain 0.0522 g of arsenic. Calculate the concentration…

A: Given: Mass of water sample = 2073 g. And mass of arsenic = 0.0522 g.

Q: 4. Citric acid was found to contain 37.51% C, 4.20 % H. and 58.29% O by mass. What is the simplest…

A:

Q: Base your answer to the question on the information below and on your knowledge of chemistry. A…

A: The significant digits are the ones used to accurately express a data value.

Q: 4. From the following list, choose the correct reagents and calculate the volumes needed to make…

A: Answer: Buffer capacity would be good if we use the pKa close to the pH. Hence we should use the…

Q: 2) How would the solubility of BaF2 change with the addition of a strong acid? Explain your answer.

A: Answer:- this question is answered by using the simple concept of solubility of the given salt in…

Q: 2 KOH + H2SO4 --> K2SO4 + 2 H2O If 131mL of 0.324M KOH are used, what molarity was H2SO4 if 73mL was…

A: Given data contains, Volume of KOH is 131mL. Molarity of KOH is 0.324 M. Volume of H2SO4 is 131mL.

Q: Question 2

A: H3PO4 – weak acid

Q: A generic solid, X, has a molar mass of 83.5 g/mol. In a constant-pressure calorimeter, 29.5 g of X…

A: Data given: The mass of generic solid (X) = 29.5 g Molar mass of the generic solid (X) = 83.5 g/mol…

Q: 2. Give the complete electron flow of the E2 reaction, be sure to clearly show the electrons that…

A: The answer to the given question is as follows------------ The problem in question 2 is an example…

Q: Help with question 2

A: Electron configuration: The distribution of electrons of an atom or molecule in atomic or molecular…

Q: Question 2

A: Molarity of a solution is defined as the number of moles of solute present in one-liter solution,…

Q: 2. What type of reaction would have a positive AT value? Explain.

A: Positive ∆T (Change in temperature) indicates that the temperature of a system is increasing due to…

Q: Question 2

A: The reaction between a weak acid, HA and NaOH takes place as follows: Calculation of no. of moles…

Q: Write out a plausible Lewis structure for the carbonate ion CO32. Assign formal charges to each…

A: Solution for Question 2 is asked specifically.   In order to explain the formation of chemical bond…

Q: Question 2

A: Given information:Density of copper = 8.97 g/cm3Mass of pure copper = 1.00 kg

Matter and Measurement

In the universe, there is matter, energy, and void space. The universe contains energy and void space. The definition of matter can be considered as something which possesses mass and consumes space. Chemistry is that branch of science which deals with the study of matter. Under chemistry, nature, composition, and the changes occurring to matter are discussed.