Part B: What Celsius temperature, T2, is required to change the volume of the gas sample in Part A (T1 = 5 ∘C , V1= 1600 L ) to a volume of 3200 L ? Assume no change in pressure or the amount of gas in the balloon.   Express your answer with the appropriate units.   Part A if needed is this but i just need part B   A sample of gas in a balloon has an initial temperature of 5 ∘C and a volume of 1600 L . If the temperature changes to 59 ∘C , and there is no change of pressure or amount of gas, what is the new volume, V2, of the gas?

Q: Water at 20°C is flowing at steady-state through a piping system asshown. The velocity distribution…

A:

Q: A water bath is laboratory equipment made from a container filled with heated water. It is used to…

A: Given Initial pressure of gas =33 bars Initial volume of gas = 10 m3    The gas expands isothermally…

Q: tanks in series

A:

Q: En a heat exchanger with steam outside the tubes, a liquid gets heated to 45°C w ts flow velocity in…

A: This problem is based on heat transfer.  The initial flow velocity is given by v= 2 m/s. The…

Q: Measured P -V data for an internal combustion engine is obtained. The data is given in Table below.…

A: Given: P, V data for internal combustion engine Computing work done by analytical and graphical…

Q: One mole of methane occupies 22.4 L at STP. Two moles of methane occupy _____ at STP. (A)11.2 L…

A: The volume of methane for 2 moles of gas at STP is to be determined.

Q: A 800 m deep mine is connected to the surface via a vertical shaft. At the top of the shaft, the…

A:

Q: Which among the statement is incorrect. (A None of the choices B Bernoulli's equation is an…

A: The fluid flow problems are solved with a general energy equation. The elevation head, pressure…

Q: Moisture content wet basis (MC wb) is the amount of water per unit mass of moist sample.…

A: (According to the guidelines of Bartleby, we can only attempt the first question, you have to post…

Q: 03: The lower half of a (10m) high cylindrical container is filled with water (p =1000 kg/m³) and…

A:

Q: 11. The function C described by C(°F)=(°F-32) gives the Celsius temperature corresponding to the…

A:

Q: For water, estimate the specific volume (m³/kg) for following condition, (answer to 4 decimals)…

A: At T = 136 C vf = 0.001075 m3/kg vg = 0.5640 m3/kg therefore, vfg = vg - vf

Q: (i) Calculate the following parameters that describe the flow through the pipe: the velocity V of…

A:

Q: Q1/A) A mercury thermometer having a time constant of (25106nh) is initially at (600 °C), it is…

A: Step 1: To solve this problem, we can use the exponential decay formula for the temperature of the…

Q: Two stream of water

A: Given data: Mass flow rate of water in feed stream 1 = 120 kg/min Mass flow rate of water in feed…

Q: You should calculate weight and volume hydrogen storage capacities of a standard steel gas cylinder…

A:

Q: A 25.5-L glass vessel is to contain 1.42 g moles of nitrogen. The vessel can withstand a pressure of…

A: Assume Nitrogen gas (Given)- Ideal gas Volume=25.5L moles=1.42 g mole P=29000+101325 Pa = 130325 Pa

Q: The volume of a propane cylinder used in joels gas grill is 0.960 l. When filled the cylinder…

A: P=745torr1atm=760torrP=0.9803atmT=25∘C=298KV=0.960LR=0.082atm.L/mol.K

Q: Liquid propane, at its bubble point, is to be pumped from a reflux drum to a depropanizer. The…

A: To find:The pump power required.Given:The maximum flow rate of the liquid propane is v= 82 m3/h.The…

Q: A 5 ft' tank is initially evacuated (total vacuum). A leak develops and air enters the tank at a…

A: Initially, there is vacuum in the tank and then air start to enter into the tank, pressure at the…

Q: 3-The reading on a mercury manometer at 25°C (open to the atmosphere at one end) is 56.38 cm. The…

A: Given,

Q: 6.154 Water at 20°C flows through the orifice in the figure, which is monitored by a mercury…

A: An orifice meter is a device that is used to measure the flow rate of a fluid, either liquid or gas.…

Q: A water tower (vented to the atmosphere) sits on top of a hill and a pipe from the water tower goes…

A: The water tower is given which is on the top of the hill.  It is given that the top surface of the…

Q: A 15kg sample of water is held at 200°C in a variable-volume container (a piston-cylinder…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: 4. Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

A:

Q: The tallest building in the world (excluding TV towers, which are not buildings in the common sense)…

A: To find the required pressure in the supply line at street level, we can use the hydrostatic…

Q: Qs: A tharmometer having a time constant C=1 is reading the ambient temperatur 20°c. At time t=. the…

A: performing calculation for the time when thermometer is removed from oil bath- For step change- Y(t)…

Q: You have 1.4 Langley's available in your area. Assuming about 11 hours of sunlight per day and a…

A:

Q: A young child is holding two balloons, separately filled with SF6(g) and C2H4(g), each to a pressure…

A: A balloon will float or sink, it totally depends on the density of the gas which is filled in the…

Q: 04: A balloon initially deflected and flat is connected by a valve to a tank containing helium gas…

A:

Q: A mercury thermometer, which has been on a table for some time, is registering the room temperature,…

A: Given that Ti=50 FTf =176 F at t=10 second

Q: A. Show that dp Determine the final density and enthalpy of the water: P (a) if it is heated to 50°C…

A: Initial conditions are given as, Also,

Q: One mole of an ideal gas is confined in a 0.3-m diameter cylinder by a piston on which rests a…

A:

Q: QUESTION 3 Figure 3 shows the initial state of a system. Container A of 1 m3 contains Air at 300 K…

A: Given : Initial volume Initial pressure Temperature Gas constant Specific heat at constant volume

Q: 5- Fill in the blank cells using the thermodynamic Press. Temp. Enthalpy (MPa) (°C) Specific (kJ/kg)…

A:

Q: Complete the following tables for water. (v is specific volume and u is specific internal energy) P…

A: The given property tables of water to be completed.

Q: In winter, a canal in Canada has an ice layer on its surface. The depth from the surface to the…

A:

Q: According to the experiments, the change in entropy of 200 g of water when heated from an unknown…

A: Given : Mass Temperature Entropy Specific heat

Q: Saturated Steam ait an abseluben of 5 bar is Used 0 heat a Stream of Nitroyen- Nibroyen enters a…

A: Given that, The absolute pressure of saturated steam = 5 bar The initial temperature of Nitrogen T1…

Q: What is the reading of the thermometer at t = 1 min? How long will it take for the thermometer to…

A:

Basic Chemical Calculations (Process and Variables)

A basic chemical calculation involves the application of the law of chemical proportions to various reactions and material and energy balance calculations on various chemical processes. Basic chemical calculation helps students analyze various chemical processes and develop problem-solving skills. The chemical manufacturing processes are divided into unit operations involving physical changes of material and unit processes involving the chemical transformation of materials. For instance, fluid flow, heat transfer, and mass transfer are unit operations, and oxidation, reduction, and pyrolysis are unit processes.