Consider the circuit shown in (Figure 1), with the bar moving to theright with speed v. The bar has length 0.380 m, R = 50.0 N, andB = 0.670 T.FigureR.B●1 of 1Part AIs the induced current in the circuit clockwise or counterclockwise?O clockwisecounterclockwiseSubmitPart BV =At an instant when the resistor is dissipating electrical energy at a rate of 0.940 J/s, what is the speed of the bar?Express your answer with the appropriate units.Request AnswerSubmitValueProvide FeedbackμARequest AnswerUnits?

Answered: Image /qna-images/answer/1ee797fd-cbe1-429e-be70-f57c846d9052.jpg

Part A Is the induced current in the circuit clockwise or counterclockwise? clockwise counterclockwise Submit Request Answer Part B At an instant when the resistor is dissipating electrical energy at a rate of 0.940 J/s, what is the speed of the bar? Express your answer with the appropriate units.

Part A Is the induced current in the circuit clockwise or counterclockwise? clockwise counterclockwise Submit Request Answer Part B At an instant when the resistor is dissipating electrical energy at a rate of 0.940 J/s, what is the speed of the bar? Express your answer with the appropriate units.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: As shown below, a wire loop (that is immersed in a 0.43 T B-field) grows from a radius of 4.2 cm to…

Q: R₁ R₂ Vemf,2 + Vemf,1 The single-loop circuit shown has Vemf, 1 = 17.37 V, Vemf,2 12.69 V, R₁ =…

A: Given, The voltage, Vemf,1=17.37VVemf,2=12.69V The resistances, R1=29.49ΩR2=13.59Ω Let the current…

Q: c) the rate at which energy is being stored in the capacitor ate = nW

Q: In the circuit of the figure below, the switch S has been open for a long time. It is then suddenly…

A: When the battery is connected to the capacitor for a long time then the potential difference across…

Q: A battery with Ɛ = 4.00 V and no internal resistance supplies current to the circuit shown in the…

Q: Part A An 2200 W arc welder is connected to a 660-Vrms ac line. Calculate the peak voltage. Express…

Q: The circuit shown in the figure below is connected for 1.50 min. (Assume R, = 7.60 N, R, = 1.60 N,…

A: Given: R1 = 7.6 ΩR2 = 1.6 Ωtime =t = 1.5 min = 90 sec

Q: A low-pass RC filter has a crossover frequency fe = 300 Hz. Part A What is fe if the resistance R is…

A: For a Low pass filter Given the frequency constant, fc=300 Hz ωc=2πTcωc=2πfc =2π×300 =600 π…

Q: What is the rate at which the current through a 0.3-H coil is changing if a voltage of 0.18 V is…

A: Given in question: Inductance of coil (L) = 0.3 H Voltage induced(E)…

Q: The figure provided shows a switch that has been in position 1 for a long time. If n is changed to…

A: Given L=9.7mH=9.70x10-3H C=44.4μF=44.4x10-6F V=1.26V, R=2.32Ω

Q: It takes 2.91 ms for the current in an LR circuit to increase from zero to 0.75 its maximum value.…

Q: 7. In the figure below, the switch S is closed for a long time such that the system reaches a steady…

A: E = 20 V R1 = 10 kΩR2 = 15 kΩC = 0.4 μF

Q: A battery with E = 3.00 V and no internal resistance supplies current to the circuit shown in the…

Q: Problem 6: In the questions below there are 6 induction processes. The circle with the dot 000000000…

A: According to Lenz's law, the induced electric flows in such a direction that it opposes the change…

Q: Question 5 For the following circuit, write out and simplify the equations for the current in each…

A: Using mesh analysis to solving the following circuit, The circuit has three mesh or loops. taking…

Q: Consider the circuit shown in the figure. Suppose that E = 24 V. What is the current through the…

Q: In Fig.30.11 in the textbook, suppose that E = 54.0 V , R = 200 N and L = 0.150 H . With switch S2…

A: On discharging the decay current is given as i=i0e-RtL where i0 is the maximum current. Part A The…

Q: R Sliding contact Ro The figure above shows a battery connected across a uniform resistor Ro. A…

A: Through an electrochemical oxidation-reduction reaction (redox), a battery converts chemical energy…

Q: Save Am An RC circuit is powered by a 40V-DC battery. The charging circuit loop is in series with…

Q: In the circuit shown in (Figure 1), S₁ has been closed for a long enough time so that the current…

Q: 100 A of rms current is incident on the primary side of each transformer. Rank the transformers on…

A: The secondary winding turns to primary winding turns ratio, often known as the secondary voltage to…

Q: Part A For an RC circuit, find an expression for the angular frequency at which Vc = 0. Express your…

Q: decide if the given statement is true or false,and give a brief justiﬁcation for your answer.If…

A: Express the relation for the current as: I=PV Here, I is current, P is the electric power and V is…

Q: A battery with E- 9.00 v and no internal resistance supplies current to the circuit shown in the…

Q: Problem 3. A DC circuit consists of an ideal 4.5-V battery and six resistors, connected by ideal…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Consider the circuit shown in (Figure 1), with the bar moving to the
right with speed v. The bar has length 0.380 m, R = 50.0 N, and
B = 0.670 T.
Figure
R.
B
●
1 of 1
Part A
Is the induced current in the circuit clockwise or counterclockwise?
O clockwise
counterclockwise
Submit
Part B
V =
At an instant when the resistor is dissipating electrical energy at a rate of 0.940 J/s, what is the speed of the bar?
Express your answer with the appropriate units.
Request Answer
Submit
Value
Provide Feedback
μA
Request Answer
Units
?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Current

VIEW

Step 2: Velocity

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

For the circuit shown below, which of the following equations is Kirchoff's loop rule applied to the right loop circuit counterclockwise? 4Ω 12 V 13 15 V 4 N None of these choices. а. O b. -15V + I,(42) -I3(2N) = 0 O C. 12V + I,(4N) +I,(42) +15V = o O d. 12V + I,(42) +I,(20) = 0 e. 15V - L,(42) -I3(20) = 0
A generator consists of a 15-cm by 12-cm rectangular loop with 500 turns of wire spinning at 60 Hz in a 25 mT uniform magnetic field. The generator output is connected to a series RC circuit consisting of a 180 a 35 μF capacitor. resistor and Part A What is the average power delivered to the circuit? Express your answer with the appropriate units. ▸ View Available Hint(s) ? Pavg = Value Units
a https://session.masteringphysics.com/myct/itemVie PHYSIC 221: E & M, Prof. David Martinez (COC), Spring 2019 CHW #7 Ch. 31, DC Circuits Problem 31.42 de Feedback Show a 励回 pdf ,ヘ Syllabus-,SPR-2019 cheatsheet (1).pdf
For the lower loop of the circuit below, which equation is resulted from a correct use of Kirchhoff's loop rule? Assume the clockwise direction is used for the loop. 18.0 V 5.00 N 8.00 N 12.0 V 11.0 N 7.00 N 5.00 N 36.0 V O -11 I2 + 12 7 I2 + 36 + 5 I3 = 0 O -11 I2 - 12 - 7 I2 - 36 - 5 13 = 0 O 11 I2 + 12 + 7 I2 - 36 + 5 I3 = 0 O -11 I2 + 12 - 7 I2 - 36 + 5 I3 = 0 O -11 I2 + 12 7 12 - 36 - 5 I3 = 0
Part A A model-train transformer plugs into 120-V ac and draws 0.32 A while supplying 7.8 A to the train. What voltage is present across the tracks? Assume 100% efficiency Express your answer to two significant figures and include the appropriate units. Vs = Value Units Submit Request Answer
Please solve this question! The answer is NOT 39.1 watt!!
In the circuit of the figure below, the switch S has been open for a long time. It is then suddenly closed. (Use the following as necessary: E for E, R,, R,, t, and C.) R1 R2 (a) Determine the time constant before the switch is closed. (R1 + R2)C (b) Determine the time constant after the switch is closed. (R2)C T = (c) Let the switch be closed at t = 0. Determine the current in the switch as a function of time. 一劍 I = R, R.
Part A An 1800 W arc welder is connected to a 660–Vme ac line. Calculate the peak voltage. Express your answer using two significant figures. V ΑΣφ ? Vpeak = V Submit Request Answer Part B Calculate the peak current. Express your answer using two significant figures. Bνα ΑΣφ Ipeak = A Submit Request Answer
Problem 4 A circuit with a Vị = +5.0 V voltage supply is shown below. The resistors have resistance values R1 = 330 kN and R2 = 660 kN. The capacitors have capacitance values C1 = 42.0 µF and C2 = 84.0 µF. Both capacitors are initially uncharged. The switch, which had been open, is closed at t = 0 seconds. (a) What is the current measured by the ammeter at t = 0 seconds? (b) What is the current measured by the ammeter at t = 60 seconds? (c) After the switch has been closed for a long time, what is the energy stored by each сараcitor? V1 R, R2
A 1.80 cm x 1.80 cm square loop of wire with resistance 1.10×10-² has one edge parallel to a long straight wire. The near edge of the loop is 1.20 cm from the wire. The current in the wire is increasing at the rate of 100 A/s.
1