Page view Read aloud Draw 9 Highlight Erase

Q: Based on the front view and the right side profile view shown, use any projection method to find the…

A: Given Front and right view of the object To find Top and isometric view

Q: 2) The ballistic pendulum is a simple device to measure projectile speed v by observing the maximum…

A: Given data :- Mass of projectile = 40 g Mass of box = 16 kg Maximum angle = 23° Brief introduction:-…

Q: Please answer questions 12

A: as per our guide lines 1solved 12th question only

Q: Develop a CSG chart for the following component. Is this a solid object? C3 B3 G B₁ B₂ B4

A:

Q: What term describes a numerical value that can be applied to a dimensional constraint in a technical…

A: Variation process arranging approach is some of the time called an information recovery strategy.…

Q: 8. What is collimation and is this done (and if so where is it done) in the JASCO 730, the FTIR…

A: Collimation refers to making light rays parallel to each other by passing them through collimating…

Q: What are some of the important principles of statics and show how they are used to determine the…

A: Statics: It is the branch of Mechanics which deals with the loads or forces acting on the body that…

Q: 3. Can the kinematics of a particle be regarded as the same as the kinematics of a point?

A: This question is conceptually based on the particle and point.

Engineering Drawing

Technical drawing has been around since ancient times. As in the ancient Renaissance, complicated drawings were created, including Leonardo da Vinci's drawing. Modern engineering drawing, including its specific orthographic projection with scale conventions, began in Europe (France) during the early stages of Industrialization. L.T. C. Rolt also made some of Marc's drawings for its block-making machinery (in 1799) that also may have contributed significantly to British engineering technology. Since he learned the art of presenting three-dimensional(3D) items in a two-dimensional(2D) plane, as we now term mechanical drawing.