P6.59 The following data were obtained for flow of 20°C water at 20 m/h through a badly corroded 5-cm-diameter pipe that slopes downward at an angle of 8°:P1 = 420 kPa, z, = 12 m, 2 = 250 kPa, Z2 = 3 m. Estimate (a) the roughness ratio of the pipe and (b) the percentage change in head loss if the pipe were smooth and the flow rate the same. %3D %3D

Q: A 4 inch Sched 40 steel pipe carries crude oil at 80°C. The crude oil has a dynamic viscosity of 1.2…

A: Given: 4 inch Schedule 40 steel pipe dynamic viscosity μ =1.2 x 10-2 Pa·s density ρ= 680 kg/m3

Q: Q2 // The diameter of a pipe at section 1 and 2 are 10 cm and 15 cm respectively. Given velocity of…

A: Given that, The diameter of the pipe at section 1 D1 = 10 cm = 0.1 m The diameter of the pipe at…

Q: Q3) Water flows through a 10-mm diameter pipe at a flow rate of 1.33×104 m³/s. Find (a) Velocity (V)…

A: As water is flowing through the pipe with a flow rate of Q. Reynold's number is the dimensionless…

Q: 4. Two vessels are connected to a differential manometer using mercury, the connecting tubing being…

A:

Q: Determine diameter of galvanized pipe needed to make the water flow along 180m with flow rate 85L/s…

A: Given data: Length of pipe = 180 m Volumetric flow rate = 85 L/s Head loss = 9 m Kinematic viscosity…

Q: Water at 30°C is being pumped through a 30 m section of 19.49 cm. diameter steel pipe at a mass flow…

A: Given data: Length of the pipe = 30 m Diameter of pipe = 19.49 cm Mass flow rate = 0.07 kg/s Density…

Q: A lab problem showed the flow through a ½ in pipe was 5.4 PSI at 7.5 GPM. At 5 GPM it was 0.8 PSI.…

A: There is no relationship between pressure and mass flow when we talk about flows in pipes. For any…

Q: Consider the flow of a fluid through the piping system shown below in Figure 1.

A:

Q: 6. Compute the hydrostatic pressure (psi) that a drilling mud with relative density equals 1.4…

A: The hydrostatic pressure exerted by a fluid at a certain depth is given by the formula: P = ρgh…