ll中国联通 4G9:07 PMweek 33. 简答题3.7Р3.7A unity negative feedback system has the open-loop transfer functionG(s) =sls+2k)(a) Determine the percent overshoot.(b) For what range of k the setting time less than0.75 s (using a 5% setting criterion).输入答案3/4< E-A下一题>

Given, Open loop transfer function is, Gs=kss+2k H(s) = 1 Closed loop transfer function is,…

P3.7 A unity negative feedback system has the open-loop transfer function k G(s) =+/2k) (a) Detemine the percent overshoot. (b) For what range of k the setting time less than 0.75 s (using a 5% setting criterion).

P3.7 A unity negative feedback system has the open-loop transfer function k G(s) =+/2k) (a) Detemine the percent overshoot. (b) For what range of k the setting time less than 0.75 s (using a 5% setting criterion).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Use any method you like to determine the limiting value of gain K for which the associated unity…

Q: Operational amplifiers or Op-Amp, has long been used. The early usage of this device were mainly for…

A: An Operational Amplifier is an analog Block which takes input as voltage and produces single ended…

Q: The closed loop gain of the system shown in the given figure is : R(s) çox 0.5

Q: 1.Which is an appropriate light source? a. 2. Which device may suit the block for the photodiode? a.…

A: Answer 1- Since photo diode absorbed the light emitted by the source ,here in the given options…

Q: In a feedback system, the basic amplifier open-loop low frequency gain is 400k and the open loop 3…

A: An operational amplifier is termed as an op-amp. Two inputs, a negative and a positive input is…

Q: Rs R 91 www R Rot

A: In the schematic shown, the feedforward amplifier is a voltage amplifier. The output voltage is…

Q: 1) Explain the concept of positive and negative feedback And derive the formula of closed loop…

A: Feedback can either be negative or positive. In negative feedback, a portion of output signal is…

Q: 6. In the negative feedback amplifier circuit, when the input impedance of the amplifier circuit is…

A: We need to select correct option for given feedback amplifier .

Q: For the following op-amp circuit RI (i) What is the function of the circuit? (ii) (iii) (iv) it R2…

A: We need to find out the function of given circuit , gain for given circuit . Cut off frequency for…

Q: Q2. Determine (a) the value of the feedback resistor and (b) the frequency for an inverting…

A: The gain in decibels is given by: Bandwidth = 10 KHz Input Resistance, Rin=20k gain in decibles =20…

Q: feedback system root locus graph shown in figure below. On the edge of stability, the gain K =

A: According to question: The open loop transfer function of the given system is calculated as…

Q: For the circuits shown below, determine the sense/return mechanisms, feedback factor k, and the…

A: Given circuits-

Q: ive an example of open loop and closed loop system (one example each). Also state the input, control…

A: System:It is nothing but the interconnection between the number of components to form a specific…

Q: What is closed loop gain?

A: Closed loop gain: To achieve stable operation, op-amps are used in negative feedback. Gain of an…

Q: Describe the series and shunt input connections of a feedback amplifier.

Q: -Prove that Z=hiel|(R/A,) and A=R/Rfor collector voltage feedback configuration circuit.

A: The collector voltage feedback configuration circuit is shown in the figure below. The input and…

Q: . The closed-loop voltage gain of an inverting amplifier is equal to to. The relationship between…

Q: 12. It is the ratio of the Open loop differential gain and the Common Mode gain Common Mode…

Q: 02 (B):- For the non-inverting operational amplifier circuit shown in Figure (3). 1) Derive the…

Q: State whether the following statement is true or false. “Voltage regulation in an LDO is achieved by…

A: In this question we will write voltage regulation in an LDO(low drop out voltage regulator)...

Q: With diagram, derive the transfer function of a close loop system with negative feedback

A: With diagram, derive the transfer function of a close loop system with negative feedback

Q: Q5- Sketch the polar plot of the open loop transfer function of 1 unity feedback control system:…

Q: Consider a system with no zeros and only one pole as +5. Place this system in the forward path of a…

A: Here the system has only pole at +5. So G(s)=1s-5 Also the PD controller has Kp=300 and…

Q: Explain how the Nyquist stability criterion can be used to determine the stability of a closed-loop…

A: Given data:

Q: Cunsider a general feedback system with parameters À = 10° and A,= 100. If the magnitude of A…

A: Amplifier is an electronic device whose output is amplified version of the input signal. The…

Q: Explain of E-MOSFET Feedback Bias Circuit.

Q: In PAM, an analog signal is sampled at equal intervals, with the resu Select one: True False

A: The above statement is false

Q: What is the overall transfer function of a negative feedback control system having a forward path 3…

Q: Common drain (source follower) amplifier configuration samples the output voltage and puts it as a…

A: SOLUTION: DETERMINE WHETHER STATEMENT TRUE OR FALSE: here explain statement of common drain…

Q: 2: P01C_Q30 For the ideal OP-Amp in negative feedback configuration shown in Figure Q30, calculate…

A: The given circuit is, Here, R1=10 kΩ, R2=5 kΩ, R3=2 kΩ, R4=2 kΩ, R5=5 kΩ, R6=1 kΩ and RL=10 kΩ

Q: List the characteristics of a good 360-degree feedback system.

A: Important characteristics of effective 360 degree feedback system is given below. ownership of the…

Q: Discuss the difference between the Current series negative feddback amplifier and voltage shunt…

Q: A feedback system signal flow graph diagram shown in figure below. Then, the denominator of total…

A: Mason's Gain Formula: It is used to compute transfer function of a system from signal flow graph.…

Q: (a) The open loop gain of a voltage amplifier is changed from 850 to 1000 due to temperature…

A: Open Loop system The gain AS is subjected to variations from 850 to 1000 we need to obtaon the…

Q: State whether the following statement is true or false. “Dominant pole compensation increases the…

A: Dominant ple compenstaion is used to increase the stability of the system by introducing a pole…

Q: 1. Discuss the advantages and disadvantages of negative feedback system in details. Elaborate each…

A: The explanation is as follows.

Q: Discuss the merits and demrits of feedback.

Q: The negative feedback closed-loop system was subjected to 15V. The system has a forward gain of 2…

A: It is given that:

Q: Vcc a) Design the circuit such that tränsistor remaiks In active b) Define the type of feedback.…

Question

ll中国联通 4G
9:07 PM
week 3
3. 简答题
3.7
Р3.7
A unity negative feedback system has the open-loop transfer function
G(s) =
sls+2k)
(a) Determine the percent overshoot.
(b) For what range of k the setting time less than
0.75 s (using a 5% setting criterion).
输入答案
3/4
< E-A
下一题>

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A feedback system signal flow graph diagram shown in figure below. . Then, the denominator of total gain is X(5) H1 G4 2 H 3 OY(s)
what will happen to the feedback fraction and frequency of oscillation of the circuit when the feedback inductor increases?
* For the figure shown, the closed-loop voltage gain (Av) is
4. An inverting summing amplifier can haveto. No more than two input signalsb. Two or more input signalsc. An infinite closed loop input impedanced. A small open loop voltage gain.
Derive the closed loop gain for negative feedback
Derive the differentiator and integrator equations using op-amp based circuits.
. Design collector feedback biasing circuit.Parameters: VCC = 15 V, ICQ = 2 mA, β = 90
5.Consider the feedback system shown in figure. Determine system parameters (a, K, z, p, Ko) to guarantee closed-loop system stability. K. (s+z) K (s +p) e RO E O Y (s² – a²)
* For the figure below, the closed-loop voltage gain with feedback (Avf) is
For the ideal OP-Amp in negative feedback configuration shown in Figure Q30, calculate the closed-loop gain, AvCL = VONS = (correct to 2 decimal places) Assume R1 = 10 kO, R2 = 5 kN, R3 = 2 kQ, R = 2 kN, R5 = 5 kQ, R6 = 1 kQ, RL = 10 kQ. Vs Vo R2 R R3 Rs Figure Q30.
None