P11.12 Consider the circuit pictured in Fig. 11.40, which is operating in the sinusoidal steady state. (a) Use phasors and AC mesh analysis to find vouT(t). not all (b) Check your answer using phasors and a voltage divider formula instead. and vs (t) + 10 Ω 1000 μF vs (t) = 50cos(10²t + 17°) V Figure 11.40 10 Ω www + VOUT (t)

Q: Design a controlled half wave rectifier circuit to produce an average of 30 V across a 250 ohm load…

A: In this question we need to design a controlled half wave rectifier circuit to produce an average of…

Q: Which of the following explanation is NOT TRUE? a. Recorder will be the most appropriate choice if…

A: 1)Recoder is used when an reading or observation is to be noted from an instrumet for high speed or…

Q: Please assist with question 1 with details on how to do it.

A: Given: To do: Identify all the blocks of Digital communication system and describe their operation.

Q: Do the following binary subtraction: 111001110.11111- 010000000.01111 (The final answer must be…

A:

Q: Write down the short note on Inter symbol interference.

A: In the telecommunication , Inter symbol interference is a methodology of distrotion,  in which a…

Q: Draw the output signal Q of the D-latch given the inputs Clock and D. The initial value of the clock…

A: Given:

Q: Question 2 Q. Calculate in binary 11111.11/11111.1*111.1

A: Given, 11111.11/11111.1*111.1 According to BODMAS, D means division and M means multiplication.…

Q: lo avold corruption during transmission, the code-word snould be Select one: O a. None of the…

A: The code-words should be far apart from one and another as possible  So even when the vectors…

Q: estion 4 ruction for each group of fallowing instructions Assuming no forwarding or hazard…

A: Assuming no forwarding or hazard detection, add the suitable number of NOP instructions for each…

Q: Which of the following is the simple shift register counter? A. Johnson counter. B. Ring counter.…

A: From the given counters, johnson or twisted register counter are same.

Q: Hello, Not sure if this is possible but am i able to delete his answer from the system?

A: The solution is provided in the following section.

Q: Quèstion 20 Consider a binary code 8,4,-2,-1, The decimal equivalent to the 8,4,-2,-1, coded number…

A:

Q: Multiply the following BINARY NUMBERS 10001.0001 X 101.11 (Note: The problem should be solved in…

A: First multiplying both the numbers without decimal and then adding the decimal.

Q: Ql: design and write the truth table for serial up counter and serial down counter with up edge?

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Answer it ASAP..

A: Two way multiplexer  It is defined as 2n×1 mux Here n=1 that means one selected line with this MUX…

Q: (b) Describe the role of IO devices with proper diagram.

A: 3. b) Input devices: These are the devices that collects the outer data and fed to the computer or…

Q: 6. A digital signal is sent using a Hamming code for error detection and correction. The signal…

A: The parity code is checked as shown below.

Q: 2. If the values of the date select lines (control inputs) A and B are 0 and 1 respectively, and…

A:

Q: Complete the number conversions indicated. Note that all binary numbers are two’s complement…

A: A binary number is a number which is expressed in base-2 system by using only "0" or "1" digits.…

Q: Implement the circuit f(x1,x2,x3,x4)=x1+(x2¹*x3*x4')+(x2*x3*x4) using NAND gates only.

A:

Q: Which of the statement is refers to call in progress tone? O Itis tone indicated as user call is…

A: progress tone includes the busy signal, ring-back, and dial-tone when we setup a call it include…

Q: an number. location. 19. Fill in the following blanks to identify what they represent in each I/O…

A: Step 1: Step 2: Step 3: Step 4:

Q: Which of the following statement is false for remote switching unit? O a. The size of the exchange…

A: consider the given question;

Q: give five (16 bits) numbers that doesn't represent instructions in the basic computer.

A: We have to give five (16 bits) numbers that doesn't represent instructions in the basic computer.

Q: Q- To transmit the data 1011000 to his friend using hamming code technique. Calculate the…

A: To transmit the data 1011000 to his friend using hamming code technique. Calculate the transmitted…

Q: QUESTION 19 To perform the operation (76425 – 28321) using 10's complement, we should first find the…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Add the following BINARY NUMBERS 101110111.10111 + 10100000 1.110 10 (Note: The problem should be…

A: The binary number system is a base-2 number system. So the numbers are represented using 1's and…

Q: Question 1 Choose the correct answer:  Which of the following line of code is correct?…

A: The code analogWrite is used to write an analog value to a pin, using the code analogWrite the pin…

Q: * Question Completion Status: - A Moving to another question will save this response. estion 15 The…

A: In this we will find binary of 37 decimal..

Q: Add the following BINARY NUMBERS 101100111.11011 + 100010111.00010 (Note : The problem should be…

A:

Q: When no key is pressed the input port (Port B) will read _____.  A) 0000 B B) 4567 C) 1111 B D)…

A: when no key is pressed all input of port B will connected to vcc through resistors vcc means logic…

Q: The flags are located inside the.

A: The flags are located in the,

Q: 8. What value does the Numeric indicator display after this code executes? 4.0 Feedback Node Numeric

A:

Q: QUESTION 19 The program which handles an interrupt is called the: O BIOS Int ox ISR IRQ QUESTION 20…

A: Dear student as per guidelines we are allowed to answer only first 3 MCQ, but for you I have…

Q: Do the following binary subtraction: 110011010.00011- 001001011.00110 (The final answer must be…

A:

Q: 9)The binary representation of the hex number (2A0B)16= Group of answer choices (10101000001011)2…

A: Given that hexadecimal number as follows. (2A0B)16.

Q: 3. Design an 8:1 multiplexer using two 4:1 multiplexer.

A: An 8 : 1 multiplexer,  has 8 inputs (i.e I0, I1... I7)  and only one output i.e F.  To implement 8 :…

Q: _______________________ register can be used to store base address. a. IP b. SS c. BP d. SP

A: The explanation is as follows.

Q: Digital information can be copied ______ times before it starts to change the original information.…

A: Digital information generally in the form of 0 and 1. it is necessary to convert the digital signal…

Q: Each symbol in 8-PSK consists bits. (write the number)

A: Each symbol in 8-psk consists of _____ bits

Q: 1) Convert the 8,4,-2,-1 sequence (01101011)84-2-1 to decimal

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: Write the VHDL code that will implement this function. Please respect the VHDL syntax and upload…

A:

Q: QUESTION 45 The offset address is bits wide.

A: The address and registers are the terms used in a microprocessor.every data has its location where…

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.