P (kN)= 7     allow=45     Pin C=double shear     Pin D=single shear

Q: Bottom chord of truss is composed of two angle bars each having a dimension of 192 mm x 95 mm x 5.4…

A: Bottom Chord of Truss : The horizontal member at lower edge of truss which carries the applicable…

Q: Using Method of Joints determine the force in member EK. Hint: What is going on at N or H? 15 kips…

A: An overhanging truss with concentrated loads are given.Point I is supported by hinged support and…

Q: Determine the force in the bars BC, BF and EF, use the method of sections, draw and the solution…

A: Step 1: Step 2: Step 3:

Q: How many inches of 1/8-in weld are necessary to transfer a shear force of 6000 lb from one plate to…

A: The objective of the question is to find out the length of the weld required to transfer a shear…

Q: classify, the truss, and find the ndicaded bar force, and the reactions, 20k A Bd-? so 5k tok 6 @…

A: Consider the following free body diagram: The above truss is a two dimensional truss. Check for…

Q: Problem # 2: Determine the internal axial force in each member of the truss using the force method.…

A:

Q: 1. Identify zero force memeber. (Draw the FBD of Joint contain zero force member) B H|100 kN 60 kN K…

A: Identify the zero force member (Draw the FBD of joint contain zero force member).

Q: 2. The yoke-and-rod connection is subjected to a tensile force of 5 kN. Determine the average shear…

A: The force applied F = 5 kN. The average normal stress in a 40mm diameter rod     = 3.98(MPa)The…

Q: 5' Bk G E F

A:

Q: Prove if the truss below is determinate, stable, or unstable. P is 3 Kips. Assume A and D as pin…

A:

Q: Member BC in the truss below is a 300 mm wide, 10 mm thick steel plate attached to two other 12 mm…

A: Member BC: 300mm wide, 10mm plate attached to two 12mm plates at joint C, 3 A490 bolts, A36 plate

Q: FBD= FCD FCE- kips, kips, kips.

A:

Q: Correct the error and write one to two sentences explaining the error

A: The truss figure is shown in the above figure. We have to find out the member forces of JE, JI &…

Q: Determine the force in the bars BC, BF and EF, use the method of sections, draw and the solution…

A: Step 1: Step 2: Step 3

Q: Situation 1 | A built-up beam made from fastening two channels to a wide flange section carries…

A: Diagram;Draw SFD;Thus Vmax = 49.077 kn

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.