-P 38 63 63 38 252 63 63 63 63

Q: The member is connected to a gusset plate with 10 inch longitudinal welds. Fin el shape to carry the…

A:

Q: Situation 8. The given angle bar L125x75x10 is connected to a 12 mm gusset plate using 20 mm…

A: Given, L125 x 75 x 10 t = 12 mm  db = 20 mm  Fy = 248 MPa Fu = 400 MPa   NOTE : As per guidelines,…

Q: A 2L 3 x 2 x ¼ LLBB tension double angle, A36 steel is subjected to a dead load of 12 kips and a…

A: For the given double angle member,

Q: 1-66 Figure P1-69 shows a bolt subjected to a tensile load. One failure mode would be, if the…

A: Force = 22.3 kN or 22300 NDiameter of shank, d = 12 mm Thickness (t) = 8mm

Q: 10 mm 20 mm The assembly above is comprised of a 10mm-diameter steel bolt, and a 20mm-diameter,…

A: option (d) or last option is correct  the explanation is given below

Q: Found solutions, steel structure

A:

Q: The pin support at A has a double-shear steel bolt as shown. Determine the required diameter of the…

A:

Q: Given: A-in-thick. ASTM A36 eyebar member as shown in Figure D.8, carries a dead load of 25 kips and…

A:

Q: 1-66 Figure P1-69 shows a bolt subjected to a tensile load. One failure mode would be, if the…

A:

Q: Determine the maximum tensile capacity of a L 178 x 102 x 19 angle as shown below if bolt diameter =…

A:

Q: 2. The figure shows a plate having a width of 400mm and thickness of 12mm is to be connected to…

A:

Q: PROBLEM NO. 2: Two plates each with thickness t = 16mm are bolted together with 6-22mm diameter…

A: Data Given:S1 = 40 mmS2 = 80 mmS3 = 100 mmt = 16 mmBolt diameter (db)= 16 mmAsked:Allowable strength…

Q: A tension member is composed of two 4x10 plates. They are connected to a gusset plate with the…

A: A tension member is composed of two 34×10 plates. A36 grade of steel used Diameter of bolts, d = 1…

Q: A double-angle shape is shown in the figure. The steel is A36, and the holes are for 2-inch-diameter…

A: Double angle section is shown in the figure above. Grade 60 steel is used. Diameter of bolts= 1/2…

Q: 2. For the figure shown, calculate the net area of the 10 x 200 mm plate. The plate is connected at…

A: We are given chain pattern of boltingNet area for chain pattern of bolting is given by An = Ag -…

Q: . For the figure shown, calculate the net area of the 10 x 200 mm plate. The plate is connected at…

A: We are given chain pattern of boltingNet area for chain pattern of bolting is given by An = Ag -…

Connections

In steel structures, connections are the members that join two or more steel members. The connections are the most important members of any steel structure, and hence, they are designed more carefully. The majority of the construction cost of steel structures is incurred due to the connections. The design of connections is done as per the recommendations and specifications of the American Institute of Steel Construction (AISC).