ösaly äbäi On the circuit board in figure below, what happens if the middle lead (wiper) of the 100k potentiometer is * ?broken VRI Broken wire 100K +12V4 INPUT R2 IC 1 741 10K R3 OUTPUT 10K -12V The circuit will be a unity- gain amplifier The circuit will be an infinite gain amplifier The circuit will be a zero gain amplifier The circuit will be a fixed gain amplifier

Q: .Create a fu

A: For operating the relays sometimes light can also be used. LDR is a device also known as light…

Q: What is the effect of connecting a battery in series to a diode in a clamping circuit?

A: Connecting a battery in series to a diode in a clamping circuit can have specific effects, depending…

Q: Determine Zener diode voltage value as well as the ripple percentage of the circuit below. (Show…

A: The circuit diagram is shown below,

Q: 11. Connect the circuit of Figure 2-13. Place CM switch 3 in the ON position to change the value of…

A: Given the circuit  using the CM switch 3 in the ON . R1=100 Kohm

Q: 3- What will be the diode resistance if the current in the circuit is zero?

A:

Q: State the difference between center tapped and bridge rectifier

A:

Q: 22. a) Describe how the following sensors are used to measure temperature. i) RTD

A: Any system can be autonomous or manual. A system is called autonomous if the output is independent…

Q: Whether the given statement is true or not that if the one diode is open in the bridge rectifier…

A: Drawing the circuit diagram for the one open diode in the bridge rectifier:

Q: Which one of the following rectifier mostly used in a DC regulated power supply? half-wave rectifier…

A: Which rectifier is mostly used in a DC regulated power supply

Q: What is DF04m? How to use in lighting dimmer system?

A: DF04m is a single-phase bridge rectifier. It has 4 pins having a peak reverse voltage of 400 V and a…

Q: The voltage out of a bridge rectifier flows for

A: Output voltage of bridge rectifier is unidirectional in nature. Due to that average value of the…

Q: write a short note on balance modulator.

A: Introduction A balanced modulator is a circuit that produces double-sideband suppressed-carrier…

Q: Three phase 110 V, 50 Hz supplies three phase half wave rectifier with 50 ohm resistance. Calculate…

A: Given: Voltage VL=110 V Frequency f = 50 Hz Resistance R=50Ω

Q: Question 6 Vin R1 Vb n D1 Given a diode circuit with Vin= 1.5 V, R1 = 1.8 kOhms, Vb = 5.9 V.…

A:

Q: Q1/ What are the difference between bridge uncontrolled rectifier and bridge-controlled rectifier

A: Difference between controlled rectifier and uncontrolled rectifier is given in below table Sl.No…

Q: If a resistive load is supplied from a single phase half wave rectifier, if a supply voltage is…

A: we will derive Rms and average voltage for output voltage. power output=Vrms2R.

Q: Which one of the below device is not constructing by silicon a. Zener Diode O b. LED O c. Transistor…

A: Which one of the below device is not construction by silicon

Q: 2 a) Name of the Circuit? (Assume Silicon Diodes) 4:1 D b) Find the peak input voltage to the 120 V…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: E I Ax D R

A:

Q: Sketch a diagram showing the ohmmeter face for a reading of 1.2k ohms. Indicate the setting of the…

A: Ohmmeter:- An ohmmeter is a piece of electrical equipment used to measure electrical resistance.…

Q: What is the minimum wire size for a 30 amp circuit?

A: To determine the minimum wire size for a 30 amp circuit. For the minimum wire size refer the NEC…

Q: Why can't two diode work transistor work?

A:

Q: Draw the schematic symbol of Shockley diode and explain how it is triggered.

A: The schematic symbol of Shockley diode is shown below:

Q: can act as switch in half controlled rectifier circuit.

A: SCR ( silicon controlled rectifier) can acts as switch in half controlled rectifier circuit.

Q: wave rectifier has Vin of 5sinwt volts and forward voltage of 0.7 volts, what is the average Vo?

A: We need to find out average value of given rectifier

Q: Define 5 applications where voltage regulators are used.

A:

Q: ) How to calculate the value of Peak to peak voltage in a CRO? a. Vp-p = number of vertical…

A:

Q: A 20 kW compound generator works on full-load with a terminal voltage of 230 V. The armature, series…

A: consider the given question;

Q: Ex: 6 :MOSFET Switch Example -Power Dissipation Calculation Flywheel Diode +Vin G R +VDD D S Lamp Ov…

A: The circuit diagram,

Q: 3. For the circuit shown Figure 2, determine the range of the input voltage that will maintain the…

A:

Q: 3. Explain the differences between the zener diodes and normal diodes?

A: Diode: Two layers of semiconductor material, a P-type layer and an N-type layer, are joined to…

Q: In the circuit shown in Figure 3 used for full-wave rectification, which of the diodes is connected…

A:

Q: Using a digital multimeter, what are the indicators if a diode is defective and is considered…

A:

Q: Compare a three-phase half-wave controlled rectifier with a three-phase full-wave controlled…

A:

Q: using a half wave rectifier circuit and connected to a

A:

Q: Interpret what is in the figure

A: Control systems are represented by transfer function. This  can be written in both time domain and…

Q: Question 2-) Write the state equations for the circuit shown below. 36 V 12 02 M i 3 H ele 6Ω www…

A: In this question, we need to determine the state equation for the circuit shown in the circuit. We…

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.