|Rupture lifetime 1Е -4h %3D Stress = 20 MPA 1000 TIT 800 600 _650°C 400 730°C 200 925°C 815°C 100 80 60 40 10-4 10-3 10-2 10-1 1 10 102 103 104 105 Rupture lifetime (h) Stress (MPa)

Q: QUESTION 5 Which of the following represents the location of the horizontal plastic neutral axis (X,…

A: Solution Find the location of horizontal plastic neutral axis

Q: Q1. Draw N,V &M diagrams 10 kN/m A to B 3m KN 40 2″m 3m 4m

A:

Q: A 3 ft x 3 ft square footing is to be placed over the following soil profile to support 18kips…

A: Soil profile below the footing: Depth of the Sand layer = 2 ft  Depth of the clay layer = 4 ft The…

Q: Name this force system Question 18 options: Non-planar concurrent…

A: To name the force system.   Coplanar force system, is one in which all the forces lie in the same…

Q: 6 in Gin Gin 9 in 3in

A: Schematic diagram of the given problem:

Q: XXXX W₂ W₁ Which of the following most nearly gives the external degree of indeterminacy? 2 4 O 1

A:

Q: What does it mean if a beam is “non-compact

A: Beam is defined as a structural horizontal element which is used for resisting loads which are…

Q: Arc command and its abbreviation is A character is the only command can be used to draw an arc in…

A: It is required to state whether true or false statement.

Q: BEGO AV 6 MM CM X 2 2 5 24 INCH Styles Title 1 No Spac..... Question 2: Given that this soccer field…

A: Given Goal to goal distance = 100 m Required  Representative factor,RF of image

Q: 2. For a dimension requirement of 4 3/8 " +/- 1/8", what is a practical figure?

A: Solution; Given that; 43"8+/-1"8

Q: P₁ 3 m E B P₂ 3 m- D 4 m

A: Given TrussLoadsTo find out Zero force members

Q: 3. Is Iust be par PROBLEM 1: The frame shown is supported with hinges at A and C and a pin at B.…

A: Both the hinges will have the two supports, they are :- RAx and RAy at A and RCx and RCy at C. Then…

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.