Opposing axial torques are applied at the ends of a straight bar ABCD. Each of the parts AB, BC and CD is 500 mm long and has a hollow circular cross-section, the inside and outside diameters being, respectively, AB 25 mm and 60 mm, BC 25 mm and 70 mm, CD 40 mm and 70 mm. The modulus of rigidity of the material is 80 GN/m2 throughout. Calculate:(a) the maximum torque which can be applied if the maximum shear stress is not to exceed 72 MN/m2 ;(b) the maximum torque if the twist of D relative to A is not to exceed 3 degrees. *

Opposing axial torques are applied at the ends of a straight bar ABCD. Each of the parts AB, BC and CD is 500 mm long and has a hollow circular cross-section, the inside and outside diameters being, respectively, AB 25 mm and 60 mm, BC 25 mm and 70 mm, CD 40 mm and 70 mm. The modulus of rigidity of the material is 80 GN/m2 throughout. Calculate:(a) the maximum torque which can be applied if the maximum shear stress is not to exceed 72 MN/m2 ;(b) the maximum torque if the twist of D relative to A is not to exceed 3 degrees. *

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please help. Do not just guess. Prove your answer. I will give a good feedback.
The requirement in the specification for the design of components and materials are no need to meet requirements. Select one: True O False
Kindly help with this " material science and engineering " question
The standard for materials provides the composition and properties of materials. Select one: True False
Conclusions about types/classification of Engineering Materials
1. “The grain size of metal sheet influences its formability in two opposing ways. The yield strength of a metal increases as the grain size decreases. So, the formability of a component may decrease if the grain size gets too small. Larger grained metals have better formability, but the roughened surface that results from stretching metal with grain sizes that are too large is unacceptable for many applications. During a recrystallization anneal new grains form in the metal. The final grain size depends on the annealing temperature and annealing time.” As shown in the figure below (1"x1" area under a 50Xmagnification microscope), a cold-rolled metal has been annealed at 550 degrees C for one hour. Calculate the ASTM Grain Size Number for the following condition: image attached
DIRECTION: Identify the following term. 3. It is the study of the relationship between the external loads applied to a body and the stress and strain caused by the internal loads within the body.
different types of mechanical processes