One phase of a 3-phase alternator consist of 12 coils in series. Each coil has an rms voltage of 10V induced in it and the coils are arranged in slots so that there is a successive phase displacement of 10 electrical degrees between the emf in each coil an the next. Find by calculation the rms value of the total phase voltage developed by the winding. If the alternator has six pole and is driven at 100 rpm.

One phase of a 3-phase alternator consist of 12 coils in series. Each coil has an rms voltage of 10V induced in it and the coils are arranged in slots so that there is a successive phase displacement of 10 electrical degrees between the emf in each coil an the next. Find by calculation the rms value of the total phase voltage developed by the winding. If the alternator has six pole and is driven at 100 rpm.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Steam enters an adiabatic turbine at 6 MPa and 550 °C and leaves at 10 kPa and 50 °C. If the environment temperature and pressure is 0 °C and 103.325, what is the second law efficiency of the turbine? O a. 0.70 O b. 0.75 O c. 0.81 O d. 0.72 O e. 0.78
The rotating part in an alternator is ................
A small 4-pole generator with a six-turn rotor coil generates the following voltage wave: e = 169.706 sin(40t). Determine the (i) Maximum pole flux (in weber) and (ii) The frequency of the induced voltage (in Hz)
Your company is to supply a 50 Hz alternator to a European company. The stator is wye connected with each phase winding having 28 turns of wire. The rotor is supplying 0.173 Wb of flux in the center of pole face. What is the RMS value of the output voltage if measured line to neutral?
A 3-phase, 12 pole alternator is coupled to an engine running at 500 rpm. The alternator supplies power to an induction motor which has a full load speed of 1455 rpm. Find the slip and number of poles of the motor.
One phase of a three-phase alternator consists of twelve coils in series. Each coilhas an rms voltage of 15 V induced in it and the coils are arranged in slots so thatthere is successive phase displacement of 20 electrical degrees between the emfin each coil and the next. Find the rms value of the total phase voltage developedby winding. If the alternator has six poles and is driven at 200 rpm, calculate thefrequency of the emf generated.
A 60 Hz alternator stator is wye connected with each phase winding having 24 turns of wire. The rotor is supplying 0.103 Wb of flux in the center of pole face. What is the rms value of the output voltage if measured line to neutral
1. Sinewave A lags sinewave B by 30°. Both have peak values of 15V. Sinewave A is the reference with a positive going crossing at 0°. Determine the instantaneous value of sinewave B at 30°, 45⁰, and 200⁰.
How do we increase or decrease the generated voltage output in the operation of a factory finished Alternator?
The ripple factor for pure dc is Answer:
9.a. If a 33% load increase is suddenly applied to an alternator having a 25% reactance, the initial voltagedrop will be aboutA. 8.25%B. 13.25%C. 3.3%D. 2.5%9.b. At what speed must a four-pole alternator operate to produce a 100-cps alternating voltage?A. 3000 rpmB. 12,000 rpmC. 1500 rpmD. 6000 rpm
A 3-phase, 16 poles alternator has a star connected winding with 144 slots and 10 conductors per slot. The flux per pole is 0.03 Wb, sinusoidally distributed and the speed is 375 rpm. Find the line emf between lines. Assume full-pitched coil.