one - According to the AC current expression given below, what is the angular frequency of the current? i(t) = 5 sin(160 nt – 10º) A O a) 160z rad/s O B) 80 rad/s OC) 16 rad/s OD) 160 rad/s O TO) 16T rodle

one - According to the AC current expression given below, what is the angular frequency of the current? i(t) = 5 sin(160 nt – 10º) A O a) 160z rad/s O B) 80 rad/s OC) 16 rad/s OD) 160 rad/s O TO) 16T rodle

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Question 9 Find the (a) amplitude (b) phase (c) angular frequency (d) period (e) frequency from v(t)…

Q: What is the rms-current Irms in the circuit when Vrms 30.0 V, C = 2.7 µF, and f = 4.0 kHz? Irms =…

A: Given data: The voltage is Vrms=30 V The capacitor is, C=2.7 μF=2.7×10-6 F The frequency is, f=4…

Q: ermine the output wave-form for the network in the figure below then calculate the average and the…

A: Fig: Given diode circuit and input waveform

Q: In AC sinusoidal waveform, the effective value is less than the peak value. Select one: True O False

A: Effective value is the RMS value in sinusoidal waveform. Effective value =RMS value = peak value…

Q: 6) In the circuit below, determine the voltage at Point B if the frequency is 100hz

A: In this question, We need to determine the voltage at Point B if the frequency is 100hz ? We are…

Q: a) frid Vens ter this periodic wave form Uo(e) RMS b) find the burned power in the load Rc ) Change…

A: The RMS voltage value is the effective value of a varying voltage. It is the equivalent steady D/C…

Q: the sinusoidal current i using phasors.

Q: HW 1- For the following waveform, determine the average and effective values. 1 cycle 10 () -10

Q: نقطتان (2) * the value of the frequency of the sinusoidal waveform in the figure is equal to

Q: 1- For the following waveform, determine the average and effective values.

A: 1- The average of the above waveform is Vavg=110∫02-10dt+∫24 4dt +∫46 0dt +∫68 -2dt+∫8100dt…

Q: An alternating current of frequency (60Hz) has a maximum value of (70A), the time taken to reach…

Q: Determine the lag angle between the input AC and the output AC of the circuit in the figure below

A: we will use voltage division rule to output voltage phase angle. impedance of capacitor = 1j2πfC

Q: If duty cycle is 25 % and amplitude is 3.96 V, then pulse with (tw) and the period (T) should be O…

Q: Given the period T = 1.09 sec, find the frequency in rad/sec. Provide your answer in rad/sec to the…

Q: Given the equation, Ve = 42. 1 V sine, What is the value of Voltage at 151.6° A 42.1 V 84.2 V 59.54…

A: Consider the expression for the voltage is, Vθ=42.1sinθ V Consider the value of the angle is,…

Q: An AC source has an output rms voltage of 78V at a frequency of 80Hz. If the source is connected…

Q: Referring to figure 3, determine the rms voltage at j5N reactance (inductor) using KVL(Answer must…

Q: Determine the output wave-form for the network in the figure below then calculate the average and…

Q: What will be the magnitude and phase angle of impedance when a 50 ohm resistor and 500 mH inductor…

A: Given; Resistor and inductor are connected in series R=50 ΩL=500 mHω=100 rad/s

Q: (a) Perform binary addition of the following numbers: 110111101.10011+ 100010101.11110 (b) Represent…

Q: +5 0 -5 -10 10 20 30 40 50 60 70 80 90 100 : (us)

Q: R 200 Vs 120Vrms }60HZ 0° C. -j10 Calculate the magnitude of the voltage drop across the inductance.

A: Using voltage division rule we will find voltage across inductor. Given inductive reactance = j5…

Q: a student is doing work on circuit in which he employs a voltage af 60 sin(314t+60) by observing…

A: Given data, Voltage, V = 60 sin(314t+600). Here, Vp = 60 V.

Q: Sinusoidal AC Voltage displayed on the oscilloscope There is a value from the top to the top.…

Q: 23 Given: Vrms = 120 V, what is its peak voltage 84.85 V 169.71 V -169.71V O 339.41 V

A: In this question we need to choose a correct option

Q: For the circuit below, find Vo (separate magnitude and angle by a comma, e.g. Vo = 10 V, -25.8…

Q: None

Q: The alternating voltage is given by v = 30sin160t. What is its average value?

A: To solve above problem what average value is and how it can be found mathematically. Average value…

Q: The following are four signals' plots. Please choose the plot that represents an AC signal with…

A: In the given question we need to find the ac signal with dc shift.

Q: a) Sketch the o/p waveform of the circuit shown in Figure (1), when vi-2sinwt. Vec ΣΚΩ vb 3ΚΩ Va 1kΩ…

Q: A 3V sinusoidal signal with frequency 100 Hz amplitude is applied to channel A of an oscilloscope. A…

Q: For the half-wave controlled rectifier shown, the thyristor is fired at an angle of 35° (firing…

Q: 3) An alternating current of frequency (60Hz) has a maximum value of (100A), the instantaneous i is…

A: Given, the frequency of the signal is f=60Hz The maximum amplitude is Im=100A And, the given signal…

Q: Based from the number 1 precaution of our experiment, what is the main reason why while doing the…

A: Diodes are very sensitive instruments even the slightest change of parameters will affect its…

Q: Find the half-cycle average value of the current through a resistance R connected directly across a…

A: Given data: The value of source voltage is: v(t)=9sin ωt. The expression for the current is given…

Q: Calculate the active power P, reactive power Q, apparent power S and it's phase-shift angle p. Give…

Q: Calculate the following váalues a) Period 5m s to the frequency b) Frequency 5k Hz to the period c)…

Q: page Z O ΧΩ www j20 ΤΩ ww Oa. Z=20.71-j0.82 ohm b. Z=25.88 + j0.82 ohm Oc. Z=24.71 +0.71 ohm Od.…

Q: (a) Vp (b) Vp.P (c) Frequency (d) Period

A: Note :- As per guidelines we are supposed to answer only first 3 sub-parts of a question. So I…

Q: The angular frequency of 30cos(56t + 50-) O 30 radians/sec O 50 radians/sec O 56 radians/sec O 106…

A: For given signal , we need to find out angular frequency .

Concept explainers

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.

Question

one - According to the AC current expression given below, what is the angular frequency of the current? i(t) = 5sin(160 t – 10°) A
O a) 160a rad/s
O B) 80 rad/s
O C) 16 rad/s
OD) 160 rad/s
O TO) 16a rad/s

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What will be the average value of given waveform: V +15V 0.2 0.6 0.8 1.2 t(s) -3Vt--- T
An alternating current is given by i =150 sin(450 Tt +0.25) A. Find the following: (i) Peak to Peak Value = (ii) r.m.s Value = (iii) Average value = (iv) Frequency =
In an experiment, the oscilloscope displayed the figure below, determine the frequency of each waveform, and the phase shift between the two waveforms and which leads or lags. Vertical sensitivity = 0.5 V/div. Horizontal sensitivity = 1 ms/div. O 125 Hz (both), and e lags i by 107° O 25 Hz (both), and e leads i by 153° O 125 Hz (both), and e leads i by 207° O 125 Hz (both), and i leads e by 207° O 125 Hz (both), and e leads i by 53°
Which one of the following is correct for Form factor of a sine wave. O 1.41 O 1.73 O 2.41 O 1.11
Equality of an alternating current signal e=350 sin= 785t what is the frequency and period value of this signal a) 250 4 20180 b) 4 250 C) 1.27 785 d) 785 1.27 e) 125 f) 125 00 00
8253° c) V = -10+ j5
Find C
ANS:70
Referring to figure 3, determine the rms current at j5Ω reactance (inductor) using KCL(Answer must be in polar formand should be in 4 decimal places).
A= (lollolol B 11111010 and C:ololll00 CLK 8 DYaw the waveform of: i) A+B+C ii) ABC ) AB
Question 3 Not yet answered The maximum value of 50 Hz an AC voltage is 100 V. Its value after 1/300 second will be O a. 66.8 V b. 68.6 V c. 88.6 V d. 86.2 V