On a separate piece of paper, complete the following calculations. A 50.0 mL sample of ocean water required 271.3 mL of 0.10 M AGNO3 to reach the end point of the titration. Determine the molarity, g/L and % of Cl in the sample of ocean water. mictu

On a separate piece of paper, complete the following calculations. A 50.0 mL sample of ocean water required 271.3 mL of 0.10 M AGNO3 to reach the end point of the titration. Determine the molarity, g/L and % of Cl in the sample of ocean water. mictu

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A second titration is performed using the same 0.250 M NaOH in a buret. This time 25.0 mL of anH2SO4 soln is titrated At the end point 47.8 mL of NaOH has been added to the H2SO4 soln. What is the molarity of the H2SO4?
A student performed titration to determine the concentration of potassium permanganate solution with oxalic acid. The net ionic equation is as follows: 2MnO4– + 16H+ + 5C2O42- → 2Mn2+ + 10CO2 + 8H2O The titration consumed 42.31 mL of 0.1001 M oxalate solution to reach the endpoint. Determine the concentration of permanganate (M) if 25 mL was used.
Do not give answer in image and hand writing
A 31.00 mLmL sample of an H2SO4H2SO4 solution of unknown concentration is titrated with a 0.1372 MM KOHKOH solution. A volume of 41.22 mLmL of KOHKOH was required to reach the equivalence point. What is the concentration of the unknown H2SO4H2SO4 solution?
A 5.20 mLmL sample of an H3PO4H3PO4 solution of unknown concentration is titrated with a 1.050×10−2 MNaOHMNaOH solution. A volume of 7.22 mLmL of the NaOHNaOH solution was required to reach the equivalence point. What is the concentration of the unknown H3PO4H3PO4 solution?
Two 25.0-mL. samples of unknown monoprotic weak acids, A and B, are titrated with 0.100 M NAOH solutions. The titration curve for each acid is shown below ACID A ACID B 14 14 12 12 10 10 10 15 20 25 30 35 40 45 30 5 10 15 20 25 30 33 40 45 30 Vohume of NaOH added (ml) Volume of NaOH added (ml ) Part A Which of the two weak acid solutions is less concentrated? B A. Submit Bequest Answer
An alkaline earth hydroxide, M(OH)2, was taken to lab for analysis. The unknown powder was poured into a flask and swirled in room temperature DI water until a saturated solution formed. This solution was then slowly filtered to remove the undissolved solid hydroxide. 11.9 mL of this saturated solution was titrated with 0.148 M HCI (ag). Endpoint required 15.6 mL of the HCl (ag) solution. Calculate the Kan for this alkaline earth hydroxide.
Use an acid-base titration to calculate the molar mass of an acıd. A 0.6758-g sample of an unknown monoprotic acid is dissolved in water and titrated with standardized barium hydroxide. The equivalence point in the titration is reached after the addition of 30.31 mL of 9.152x10 ² M barium hydroxide to the sample of the unknown acid. Calculate the molar mass of the acid. g/mol
Consider the titration of a 40.0 mL sample of 0.150 M CH3NH2 (Kb=4.4×10−4) with 0.200 M HBr. Determine each quantity:Part A:What is the volume of acid required to reach the equivalence point?Express your answer using one decimal place.V = mL Part B:What is the pH at the equivalence point? Express your answer using two decimal places.pH = Part C:Select an appropriate indicator for this titration. - pic
When pure sulfuric acid is dissolved in water, heat is evolved. 10.65 g of pure sulfuric acid at 20.00 °C was added to a calorimeter containing 300 g of water at 20.00 °C. The temperature of the solution increased to 26.35 °C. If the specific heat of the mixture is 4.184 Jg1°C1, the density of water is 1 g/mL, and the heat capacity of the calorimeter is ignored, what is the heat evolved per mole of sulfuric acid? a. -83.2 kJ O b. -73.6 kJ O C. -76.0 kJ d. -80.8 kJ e. -78.4 kJ
30. Indicate the FALSE statement about pH indicators and their use in titrations: A) A pH indicator suitable for titrations of strong bases with strong acids cannot be used for titrations of strong acids with strong bases. B) pH indicators should be used sparingly (in small amounts) as they are weak acids/ bases, and thus could affect the volume of titrant used. C) An indicator should be selected such that its pKits value matches the equivalence point pH. D) pH indicators all contain at least one acidic group that can be deprotonated to form a differently colored conjugate base. E) The colours of the acid and base forms of a given pH indicator depend on their chemical structures.
An unknown acid is dissolved in 25.0 mL of water and titrated with 0.100 M NaOH. The results are shown in the titration curve above. Determine the molar mass of the acid if 0.200 g were dissolved.