On a segment of A1 motorway in Casablanca, Morocco, traffic flow data was collected. The measured maximum flow was 1750veh/h for one lane when the averge spacing was 26.3 m/veh. We are assuming that speed and density are linearly related. Obtain the critical density and speed values to show them on the speed-density, density-flow and speed-flow equations. Please also obtain the speed and density values when the flow is 850 veh/h during rush hour

Q: If the model In us = In uf-k/kj is applicable to depict the correlation between speed (mi/h) and…

A:

Q: 6. Using the follo a model for speed 'S 68-0.59D,' calculate and / or complete the following: ( ) a.…

A:

Q: If the model in us = In uf-k/kj is applicable to depict the correlation between speed (mi/h) and…

A:

Q: The acceleration of a vehicle takes the form du, -= 3.6-0.06 u₂ dt where u is speed in ft/sec. The…

A: Given Data: The accleration of vehicle: dudt=3.6-0.06uAt time (T) the speed of the vehicle=45 ft/sec…

Q: 2.33 A test of a driver's perception/reaction time is being conducted on a special testing track…

A: The initial speed of the vehicle, vo= 50mi/hrThe distance between the vehicle and the object when…

Q: vay tm= 2.5 seconds (gap) in sQ = 200 vehicles per hour,

A:

Q: Vehicles are driving at 35 miles/hour in a roadway. A slow truck joins the traffic at 15 mile/hour…

A:

Q: Answer the following questions a) Derive an equation to estimate speed of shockwave.

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 7. When becomes possible to have a high density on a highway, but a flow of approximately 0 veh/hr?

A: Traffic flow is defined as the total number of vehicles passing a given point  in a given time. It…

Q: 5) In contrast to the Greenshield's model of traffic flow that considers a linear relationship, the…

A: Given that :-The Greenberg model of traffic flow assumes a non-linear relationship between…

Q: pts) In a section of highway 200ft long, three vehicle A, B, and C are traveling at constant speeds…

A:

Q: 8. The following figure shows an example of an aerial photo taken of 500 ft of roadway. It shows…

A:

Q: Question 2 If the model in us = ln uf-k/kj is applicable to depict the correlation between speed…

A:

Q: a) Among speed, flow, and density, which value helps to define the flow condition better? Why? k b)…

A: We can derive capacity from free flow speed and jam density by understanding that traffic flow (q)…

Q: QUESTION 10 One lane of a uniform section of highway has an optimum density of 70 vehicles per mile…

A:

Q: 4. C per The maximum flow rate on a road is 1000 vehicles hour and the free flow speed is 80 km/h.…

A: (i) The two possible speeds are 2424 km/h and 5656 km/h. (ii) The two possible spacings are 1/700​…

Q: Problem 2 A project by some to monitor the traffic safety at a busy intersection. They measure (with…

A: Given -

Q: Problem Statement Consider isentropic supersonic flow around the sharp expansion corner illustrated…

A: Step 1:Iteration 1: M2_old = 1.5 f(M2_old) = 10 - 1/2 * 6^(1/2) * [ tan^(-1) ( (1.5^2 - 1) /…

Intersection Design

An intersection is a location where two or more roads or railways meet or join. The traffic movement is controlled at the intersection that depends on its design and type. It governs the operation, efficiency, speed, capacity, and safety of the highways, airways, and railways. The movement of the pedestrian causes hazards and delays at the intersection.