On a road with a width of B = 10 m and a horizontal curve with a radius of R = 400 m, a elevation with a ramp length of k = 56 m is applied while keeping the centre line fixed. inimum slope equals 2%, and the applied superelevation is 7%. termine the length of the Clothoid transition curve and the design speed for this cation, considering a value of p' = 0.4 m/s³. termine the Clothoid's parameters and investigate the superelevation's design, showing perelevation's application on the plan and cross-section.

On a road with a width of B = 10 m and a horizontal curve with a radius of R = 400 m, a elevation with a ramp length of k = 56 m is applied while keeping the centre line fixed. inimum slope equals 2%, and the applied superelevation is 7%. termine the length of the Clothoid transition curve and the design speed for this cation, considering a value of p' = 0.4 m/s³. termine the Clothoid's parameters and investigate the superelevation's design, showing perelevation's application on the plan and cross-section.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Please provide solution and need drawing
Problem-1 If the laminar velocity profile is approximated by the cubic-order polynomial ū = a1 + a2ỹ+ azy² + a4ÿ³ where, ū = u/Ue and y = y/8 with U, and & being the edge velocity and boundary-layer thickness, respectively. a) Find out the velocity profile, by determining the unknown coefficients a1, a2, az and a4. Plot the velocity profile. b) Find out the analytical expression for the boundary layer, displacement and momentum thickness and also find out their stream-wise variation as a function of x. Specifically %3D prove that 8/a = 4.64/VRe,, 8./x = 1.74// Re, and 0/x = 0.646//Re,
A Civil Engineer used a 50m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long. The difference in elevation between the initial point and the end point was found to be 1.25 m. The 50 m tape is of standard length at a temperature of 10°C and a pull of 50 N. During measurement the temperature reading was 8°C and the tape was supported at both ends with an applied pull of 70 N. The cross-sectional area of the tape is 6 mm2 and the modulus of elasticity is 200 GPa. The tape has a mass of 0.075 kg/m. Coefficient of thermal expansion is 0.0000116 /°C. Determine the magnitude of the correction per tape length in meters due to temperature. Round off your answers to 4 decimal places. Determine the magnitude of the correction per tape length in meters due to pull. Round off your answers to 4 decimal places. Determine the magnitude of the correction per tape length in meters due to sag. Round off your answers to 4 decimal places. What is…
Determine the intensity of shear of an oil having viscosity 2 poise. The oil is used for lubricating the clearance between a shaft of diameter 15 cm and its journal bearing. The clearance is 2.5 mm and the shaft rotates at 150 rotation per minute.
A 25-mm-diameter shaft is pulled through a cylindrical bearing as shown in Figure. The lubricant that fills the 0.3-mm gap between the shaft and bearing is an oil having a kinematic viscosity of 8x10 m²/s and a specific gravity of 0.91. Determine the force P required to pull the shaft at a velocity of 3 m/s. Assume the velocity distribution in the gap is linear. Bearing Shaft 0.5 m Lubricant
A 2-m long concrete traffic barrier is used to provide safety for workers, pedestrians, and motorists during highway construction. The concrete has 0.024 N/cm3 specific weight. The interface between the barrier and pavement has static and kinetic coefficients of friction of 0.45 and 0.4, respectively, and h = 45 cm. Determine the force P that will cause motion of the barrier. 60 cm 60 cm 3 @ 18 cm
A 0.15-kg glider is moving to the right on a Frictionless, horizontal air frack with a speed oF 0-8 ms it has a head-on collision with a 0.3- kg glider that is noving to the left with a sped f 2.2 m/s. Find the firal velocity (magnitide & direction) glider ir the co\lision is elastic. each OF