1 Us = -Vout RF/Rs' AvOL) RF/R$ ' AvOL). (8.18) O Consider an inverting amplifier with open-loop gain 105. With reference to equation 8.18: a. If Rs = 10 k2 and Rp = 1 M2, find the voltage gain Av(CL)- b. Repeat part a if Rs = 10 k2 and Rp = 10 M2. c. Repeat part a if R$ = 10 k2 and Rp = 100 M2. d. Using the resistor values of part c, find Av(CL) if AvOL) → 00.

1 Us = -Vout RF/Rs' AvOL) RF/R$ ' AvOL). (8.18) O Consider an inverting amplifier with open-loop gain 105. With reference to equation 8.18: a. If Rs = 10 k2 and Rp = 1 M2, find the voltage gain Av(CL)- b. Repeat part a if Rs = 10 k2 and Rp = 10 M2. c. Repeat part a if R$ = 10 k2 and Rp = 100 M2. d. Using the resistor values of part c, find Av(CL) if AvOL) → 00.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Sketch the AM modulated signal (assume sinusoidal signal modulating a sinusoidal carrier) in both time and frequency domain. Remember, graphs with missing labels and values will be graded with zero.
A) For the drauit of Figure 8, determine the following parameters: Ig, Ip, Vas, VD. VBc and then state the mode in which the BJT is operating. Useeither the gaphical (using a graph paper) approach or the mathematical approach Vcc Given: RC Vcc = 20 V R3 IDss = 8 mA %3D Vc p =-4 V Vss =-1V B =100 Vo RB = 470 2 %3! Rc = 36 k2 Rs =1 k2 RG RG = 2 MN Rs Vss
9.4. The signals in Figure P9.2 are zero except as shown. (a) For the signal x ln] of Figure P9.2(a), plot the following: () xl-n]ufn] (iii) xn}u[n + 2] (v) xn)oln - 21 x,[n]ul -n] (iv) x-njul-2 - n] (vi) x,ln|(8[n + 1] + 6ln - 1) (b) Repeat part (a) for the signal x,ln] of Figure P9.2(b). (e) Repeat part (a) for the signal xn] of Figure P9.2(c). (d) Repeat part (a) for the signal xfn] of Figure P9.2(d). -2-1' 101 2 3 456 (a) (b) ... 6-5-4-3-2-1, 01 23 4567 (d) Figure P9.2
Kindly choose the correct answer. Please answer it ASAP if you can, thanks
The gain of vertical deflection amplifier in CRT is 90. If an input signal of 110mV is applied, it will produce electrical field of 33V/cm and vertical deflection of electrons beam on the center of plates of 4.31x10-3 cm with an angular deflection given by arctan (0.0137). The electrons enter the plates with a velocity of 3.2479x109 cm/sec, and deflection sensitivity of 0.055cm/V. Determine: 1) The dimensions of vertical deflection plates {long, a part (l,d)}. 2) The distance from the end of deflection plates to the screen. { 2.5cm, 0.3cm, 38.49cm}
Design an LCC I network that will match 42 internal resistance to a 550 load at 60 MHz. Assume a Q of 8. Cevap:
Noise level is measured in ... a) millimeters b) decibels c) watts
Emitter stabilized polarization BJT DETERMINE, FIND: a. IBQb. ICQc. VCEQd. Vce. VBf. VE
Q-2: The Si transistor circuit of the figure shown, find the emitter resistor (RE) that would bias for operating about VcEo = 5V. Let ICEO = 0, B-80, Rg = 220KN, RC = 2KN and Vec = 12V, where Ic # Ig. %3D Vec Re RF Ce RL Rs Vs RE
Electronics Circuit: BJT biasing A fixed bias NPN BJT (Beta = 80) circuit is connected to a 12VDC supply. The current flowing through the Base is 40 microAmp while the Collector Voltage (Vc) = 6V. Determine the value of Base Resistor (Rb). а. 2.825 KOhms b. 2.825 MOhms с. 282 500 Ohms d. 0.2825 micro Ohms
Q-2: The Si transistor circuit of the figure shown, find the emitter resistor (Rg) that would bias for operating about VeEo = 5V. Let IcEo = 0, p-80, R; = 220KO, R. = 2KA and %3D %3D %3D Vec = 12V, where Ie # Ig. Re RF tho Ce RL. Rs Vs RE
Q2) Do not explain but compare again do not explain but compare and only compare among the methods used in the detection of FM signals.