O CHEMICAL REACTIONS Calculating molarity using solute mass https://www-awu.aleks.com/alekscgi/x/Isl.exe/1o_u-lgNslkr7j8P3jH-IvUrTNdLZh5A8CnG03PBGuXr8iC Pa7ZMmymzitEfUEi1wh55blns1... A Q to A chemist prepares a solution of barium chlorate flask and filling the flask to the mark with water. (Ba(ClO3)₂) by measuring out 4.63 g of barium chlorate into a 100. mL volumetri- Calculate the concentration in mol/L of the chemist's barium chlorate solution. Be sure your answer has the correct number of significant digits. A mol/L 3/5 x10

Q: When comparing two sets of data, which one is more precise? Select one: O The one with the smaller…

A: In the measurement of a set, accuracy is the closeness of the measurements to a specific value or…

Q: Ture or False The coefficent of vriance is the half of standard deviation

A: The coefficent of variance is the half of standard deviation.

Q: What factors determine the mass of a gross sample? (Select all that apply.) Othe technique used for…

A: b) the degree of heterogeneity of the wholec) the level of particle size at which heterogeneity…

Q: -3.57 was an incorrect answer for this. Please mark final answer and povide correct answer

A: A 1.00 M solution of CsI was electrolyzed using the inert electrodes. We are required t find out the…

Q: The number 39.00671 rounded to 3 significant figures is: The number 801.0013 rounded to 5…

A: The question is based on rounding of the given numbers using significant figures

Q: Read the length of the metal bar with the correct uncertainty error range (+/-). 5 10 15 20 cm

A: Length is measurement of anything from end to end.

Q: 1. Environmental component that restricts the number of individuals in a population (1 Point)

A: A limiting factor is anything that constrains a population's size and slows or stops it from…

Q: If the readings are 2 3 4 the average deviation is----- O 5.33 O 3.34 O 2.44 0.66

A: Calculate average deviation of the data, 2,3,4

Q: standard deviation

A: If there is two results having standard deviation Sa and Sb. Therefore standard deviation indicate…

Q: In question c, since the answer was confirmed to be -1420 J, why did you use a positive 1420 for the…

A:

Q: Compare the width of PI to the range of the y-value from the sample: min: 3.2% max: 9.0%, range =…

A: To compare the width of PI to the range of the y-value from the sample, we need to know what PI…

Q: The experimental error is due to sampling and method error only. tru or false

A: The question is based on the concept of analytical chemistry. we have to discuss about various types…

Q: A chemist prepares a solution of iron (III) chloride (FeCl₂) by measuring out 46.3 mg of FeCl, into…

A:

Q: Your answer can't be interpreted as a number or measurement in the correct format or is rounded…

A: The minimum no. of significant digits in the initial and final amount is 3, thus the answer must be…

Q: Determine the following number of significant figures in the following number: 3.5x10-5 cm Add your…

A: The significant figure refers to particular digits in a number. According to the measurement rule,…

Q: Evaluate the following expressions. Impose the rules for significant figures different ways for the…

A: Significant figures of value determine the precision and accuracy of a calculation. When expressing…

Q: view - Black X P12.5: Melting, Fre X PExercises X P Answers to Odd- X Email-Jessica Sa X C Solve 30.…

A: Given,  61.  The heat required to convert 2.55 g. of water at 28.0 °C to steam at 100.0 °C is:

Q: What is the relative standard deviation, for the following data: 3.80, 3.941, 3.107, 3.656 ,3.112,…

A:

Q: Please correct answer and don't use hend raiting

A: Step 1: Step 2: Step 3: Step 4:

Q: 0.09 1. Measure the value of the arrow mark and state its uncertainty: 0.08 0.07

A: Value of arrow mark is 0.075

Q: What is the uncertainty in the following centimeter ruler ? 1 2 3 4 5 6 7 8

A:

Q: The uncertainty in the measurement 13.560 mg is

A: The uncertainty in the measurement 13.560 mg given below.

Q: A material that is by a magnet is a magnetic O a attracted repelled

A: We know that, Attaraction means close to two substance and repelled means far from to two substance.

Q: Five blood samples got these results: 0.752, 0.756, 0.752, 0.751, 0.760 ppm The standard deviation…

A:

Q: Liquid hexane (CH. (CH₂(CH₂) CH₂) reacts with gaseous oxygen gas (O₂) to produce gaseous carbon…

A:

Q: You measure 35 turtles' weights, and find they have a mean weight of 72 ounces. Assume the…

A: True population mean turtle weight =  72 ± 1.35

Q: For the reaction A + B →→C+D, • Trial 1: [A] = 1.0 M, [B] = 2.0 M, rate = 0.0010 M/s 0.0040 M/s…

A:

Q: In the picture below, determine how many circles with a radius of 0.5" can fit into a 5.0" box.…

A:

Q: Perform the calculation and record the answer with the correct number of significant figures.…

A: We have been given a calculation and we have been asked to perform given calculation and record the…

Q: Suppose that a Gaussian population of measurements has a mean of 1000 and a standard deviation of…

A:

Q: gut V! htuわtaつunaYt S tolM How 100. in

A: The solution is as follows:

Q: Increasing the number of measurements will decrease the standard deviation increase the systematic…

A: Error formula is the absolute value of the difference of the measured value and the actual value…

Q: 2. A chemist performed an experiment to determine the melting point of sodium chloride with the…

A: Mean = (sum of all measurements)/ number of measurements.  Percent error =( |actual value - expected…

Q: Thank you! One of this was incorrect according to the platform I was uploading my homework in

A: g) the rate of a reaction typically gets ________as the reaction proceeds. We have to answer this…

Q: II. Problem Solving 1. A hollow cylindrical copper pipe is 1.50 m long and has an outside diameter…

A:

Q: Standard Deviation Problem The mass of an object was recorded using analytical balance in the lab.…

A: The mass of the object recorded in three trials is = 3.678 g, 4.988 g, and 4.541 g a) The average…

Q: What is  could be the calculated  lambda max of this compound?         285     280     275…

A: These rules provide a theoritical basis of determining the absorption wavelength (λmax) given by UV…

Q: From Experiment Correct Value % error Cs,metal |(J/goC) 0.2335 0.400

A: The given data is :

Q: What is compensation depth?

A:

Q: Evaluate 52.00 cm + 15.550 cm %3D Report answer to the correct number of decimal places and include…

A: According to the rule of significant figures, the number of digits that must be present after the…

Q: You're making an appetizer that requires 3 lbs of avocado puree. Avocados weigh 6 ounces before…

A:

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.