NOTE This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Two rods ABD and DE are connected to three collars as shown. The angular velocity of ABD is 3.4 radis clockwise.

Q: The crankshaft has loads as shown. Determine the vertical (y-direction) reaction of the bearing at…

A:

Q: Determine the maximum value of b (lb/ft) if the roller at point A can only support upto 148 lb. The…

A:

Q: the hole of radius 16 mm and thickness 18 mm. Dimension A = 52 mm; B = 51 mm.  determine its volume…

A: Volume can not be negative.

Q: Answer the following questions include directions: 1. What is the magnitude and direction of the…

A:

Q: The J-shaped member shown in the figure (Figure 1) is supported by a cable DE and a single journal…

A: Given DataThe cylinder has a weight of WB=5.60lbThe Vertical force applied to member C, F=1.50 lbThe…

Q: A 5 ft DU B 5 ft -3 ft-

A:

Q: Consider the pipe shown in (Figure 1). The forces F = 650 N, F = 700 N , and F3 = 700 N are paral…

A:

Q: The volume of the syringe’s reading read as 4cc when the weight (pressure) was 600 g. Determine the…

A: Initial Volume, V1=4 ccWeight for 4 cc volume, M1= 600gFinal Volume, V2=2.5 cc

Q: force (R) representing the forces applied to the rod, and away from B Specify Lee (h).

A: Given: To determine resultant force

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.