Note below network: PC1 192.168.1.0/24 000 Fa0/0 R1 192.168.2.0/24 S0/0/0 DCE S0/0/0 R2 192.168.3.0/24 Fa0/0 PC2 Select all the answers that are TRUE about this network: The Serial connection between R1 and R2 can be classified as a 'transit' network Presuming that Router interfaces are programmed with LOWEST AVAILABLE IP address, PC2's default gateway would likely be 192.168.3.1 Presuming that Router interfaces are programmed with HIGHEST AVAILABLE IP address, PC2's default gateway would likely be 192.168.3.254 PC1 and PC2 are in different subnets, and VLANs, and broadcast domains. PC1 and PC2 are in different subnets, and VLANs, but NOT broadcast domains. There are 24 bits turned to "ON" in the subnet mask used by PC1

Q: Configuring Inter-VLAN Routing. Legacy inter-VLAN routing (or per-interface inter- VLAN routing)…

A: a. List the commands including command syntax and prompt to configure a router for router-on a-stick…

Q: a) You have been hired by a startup company to design, plan, and implement an Ethernet network. The…

A: Given: You have been hired by a startup company to design, plan, and implement an Ethernet network.…

Q: (c) Figure 1 shows the routing in a wireless sensor network from source sensor node 0 to the…

A: Given wireless sensor network contains many nodes and node 0 is the source node and node 12 is the…

Q: What is the primary purpose of a router in the OSI model, and which layer of the model does it…

A: The primary purpose of a router in the OSI (Open Systems Interconnection) model is to enable the…

Q: 1. A router receives a packet with destination address (222.186.114.16) how how it finds the network…

A: In order for a router to find the network and subnetwork address for a given packet, it must first…

Q: Numerous weaknesses in the router layer 2 protocol have been discovered. Why does the ICMP request…

A: Layer 2 Protocol problems Data Link Layer, the second layer in the OSI architecture, builds frames…

Q: (d) Given the MPLS network shown below where R1 is the ingress router and R7 is the egress router.…

A: It is given that R3 and R6 are connected through R4 and R5. R4 and R5 might belong to another…

Q: Consider the following diagram where host A is communicating with host B using the TCPAP protocol…

A: switch A to switch B. switch A to node A. switch A to router . switch B to node B. switch B to…

Q: Q8) What is the maximum number of connections that can be ongoing in the network at any one time?

A: The maximum number of connections that can be ongoing in a circuit-switched network depends on the…

Q: Problem 1: An OC-192 network line has a bandwidth of up to 9.510912 Gbit/s. Ignoring delays through…

A: To calculate the maximum number of bytes that can be in transit on a link from Milwaukee to New…

Q: Does this circumstance need a certain network topology?

A: Network topology refers to the physical configuration of a set of connected computing devices. It…

Q: Host A Host B User types "Hello" Seq=100, ACK=200, data = "Hello" host ACKS Seq=X1 , ACK=X2, data =…

A: Here in this question we have given a tcp connection.there host A send seq and ack to the receiver…

Q: Design a leaky bucket (LB) scheme to police the traffic flow on a user line in an ATM network to…

A: Diagram to show the output traffic pattern of every leaky bucket.

Q: Consider a two-link network where Host A is connected to the router by a 1 Mbps link with 10 ms…

A: The answer is...

Q: (c) Assume a router has the following entries in its routing table (cf. Table 1). Table 1: Router…

A: The first destination subnet number given is 111.40.170.0 / 23 This means address is 111.40.170.0…

Q: An explanation of how a switch and a router's collision and broadcast domains function together is…

A: Answer:

Q: a) How do you distinguish between congestion and flow control? b) Which of the two may involve a…

A: a) Flow Control On the other hand, traffic management regulates the flow of information from the…

Q: Routers can do things for a network that switches can't, such as:

A: Routers and Switches are the Network devices which are used to transfer and route the data packets…

Q: d. The signal at the beginning of a cable with – 0.6 dB/km has a power of 11 mW. Calculate the power…

A: As per our guidelines, we are supposed to answer only one question. Kindly repost the remaining…

Q: 19 10 Mbps half-duplex ethernet network consists of two segments connected by a repeater. It…

A: According to collision detection in half duplex ethernet.  Tt >= 2* TP  Here we have given the…

Q: Question 3 Write a program that finds the equivalent series and parallel resistance for a collection…

A: Read the number of resisters from user And Resistances from user Then return the required in ohms.

Q: Q6) Assuming the router's buffer is infinite, the queuing delay is 1.2957 ms, and 1476 packets…

A: Given,Router buffer size = infinitequeuing delay = 1.2957 mspackets arriving = 1476formula for…

Q: Numerous weaknesses in the router layer 2 protocol have been discovered. Why does the ICMP request…

A: Layer 2 Protocol problems Data Link Layer, the second layer in the OSI architecture, builds frames…

Q: You have a network of four nodes and three links: A B C D A message of size 1,024,000 bits is to be…

A: Given that, Number of hops = 3 Size of message= 1,024,000 bits /8 =128000 Bandwidth for first two…

Q: Define per router control.

A: Per router control plane is routing algorithm used in computer networks. The definition of the…

Q: List four purposes of dynamic routing

A: The Answer is in step2

Q: When a router receives an ARP request that is meant for a distant host, it can respond with which of…

A: Introduction: An ARP request is necessary when a device wants to determine the MAC address of…

Q: What is the primary function of a router in the OSI model, and which layer does it operate at?

A: The OSI model is a framework that provides a way to organize network protocols and communication…

Q: What does UTP stands for? a. Unshielded Twisted pair b. Uniformly twisted pair c. Unshielded…

A: - In networking their are a lot of twisted pair cables . One of them is UTP commonly known as the…

Q: Given the diagram below, if OSPFV2 is adopted, how many networks that Router R2 needs to propagate…

A: The correct option is A) 3.

Q: Computer science What problems can be found in the protocol for router layer 2? Why do the ICMP…

A: Introduction: What issues may be identified in the router layer 2 protocol?Why does an ICMP request…

Q: (C) A router receives a packet with the destination address 10.128.64.0. Show how the router finds…

A: Network address is the first 8 bits of total 32 bits in a class A address, first 16 bits of the 32…

Q: An explanation of how a switch and a router's collision and broadcast domains function together is…

A: The statement given:- A switch and router's collision and broadcast domains function together is…

Q: One of the following is consider an advantage of static routing. No intervention is required to…

A: Static routing is a form of routing that occurs when a router uses a manually-configured routing…

Q: Assuming that routers are present on many OSI layers, what are the differences between these levels?

A: 1. A computer network refers to interconnected computing devices that can exchange data and share…

Q: I need this ASAP and please answer what the question as it is. Thank you See the following network…

A: Answer: We have explain your question very well so we will see in the more explanation.