Networking What are the propagation time and the transmission time for a 50-Mbyte message (an image) if the bandwidth of the network is 1 Gbps? Assume that the distance between the sender and the receiver is 1,000 km and that light travels at 2.4 × 108 m/s ?

Networking What are the propagation time and the transmission time for a 50-Mbyte message (an image) if the bandwidth of the network is 1 Gbps? Assume that the distance between the sender and the receiver is 1,000 km and that light travels at 2.4 × 108 m/s ?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 27VE

See similar textbooks

Related questions

Q: Five Channels each with a 100 KHz bandwidth are to be multiplexed together using Frequncy division…

A: Answer is. The minimum bandwidth is 540 Khz.

Q: i. If there are n signal sources of same data rate, then the TDM link has slots.

A: Question i. If there are n signal sources of same data rate, then the TDM link has ______ slots.

Q: Calculate the minimum timeout value for a stop-and-wait algorithm running over a 50-meter…

A: A stop-and-wait algorithm is a flow control protocol used in data transmission between two nodes. In…

Q: Efficiency Principle: Ethernet V1 access protocol was designed to run at 10 Mbps over 2.5 Km using…

A: In V1 access protocol we have, Bandwith (B) = 10Mbps Distance (D) =2.5 Km Packet size (S) = 1500…

Q: The maximum data rate of a channel of 3000 Hz bandwidth and SNR of 30 db is

A: The correct answer is given below with an explanation and calculation

Q: An FM modulated signal has the form u(t)= 50 cos(pi107 t + 2 cos(4000pi t)) Determine 1. the average…

A: Required: An FM modulated signal has the formu(t)= 50 cos(pi107 t + 2 cos(4000pi t))Determine1. the…

Q: microwave data link has been designed to operate at 110,000 symbols per second while encoding 14…

A: Bandwidth refers to the range of frequencies or the frequency range that can be accommodated or…

Q: A line has a signal-to-noise ratio of 1000 and a bandwidth of 4000 KHz. What is the maximum data…

A: The maximum data rate supported by a communication line can be determined using Shannon's theorem,…

Question

Networking

What are the propagation time and the transmission time for a 50-Mbyte message (an image) if the bandwidth of the network is 1 Gbps? Assume that the distance between the sender and the receiver is 1,000 km and that light travels at 2.4 × 10⁸ m/s ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

A channel has a bit rate of 4 kbps and one-way propagation delay of 20 ms. The channel uses stop and wait protocol. The transmission time of the acknowledgement frame is negligible. To get a channel efficiency of at least 50%, the minimum frame size should be
A channel has a bit rate of 4 kbps and a propagation delay of 20 msec For what range of frame sizes does stop-and-wait given an efficiency of at least 50 percent?
What are the propagation time and the transmission time for an 8-Mbyte message (an image) if the bandwidth of the network is 1 Mbps? Assume that the distance between the sender and the receiver is 14,000 km and that light travels at 2.4 x 108 m/s. (7) (ii) Discuss any two network impairments? (3)
A line has a signal-to-noise ratio of 1000 and a bandwidth of 4000 kHz. What is the maximum data rate supported by this line? If the bandwidth of the channel is 5 kbps, how long does it take to send a frame of 100,000 bits out of this device? What is the maximum data rate of a channel with a bandwidth of 200 kHz if we use four levels of digital signaling?
A 20 Kbps satellite link has a propagation delay of 400 ms. The transmitter employs the "go back n ARQ" scheme with n set to 10. Assuming that each frame is 100 bytes long, what is the maximum data rate possible?
4. Satellite Transmission. Suppose there is a 12 Mbps microwave link between a geostationary satellite and its base station on earth (the distance between the two is 36,000 km). Every minute the satellite takes a digital photo and sends it back to the base station. Assume a propagation speed of 2.5 x 10³ m/sec. a. What is the propagation delay, dprop, of the link (in seconds)? b. What is the bandwidth delay product, R x dprop? c. Let X denote the size of the photo. What is the minimum value of X, in bits, for the microwave link to be continuously transmitting?
10. For a 10 Mbps data link using 12,000-bit frames, and assuming that electrical signals propagate at 2.5 x 108 m/s: a. How long does it take to introduce a single frame onto the link? b. How long does it take for the trailing edge of the frame to travel 1,620 km? c. What is the total transmission time of this frame, from start to finish?
A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps. What is the throughput if the system produces, (i) 1000 frames/sec (ii) 500 frames/sec
Suppose a 128-Kbps point-to-point link is set up between Earth and a rover on Mars. The distance from Earth to Mars (when they are closest together) is approx- imately 55 Gm, and data travels over the link at the speed of light-3 × 108 m/s. (a) Calculate the minimum RTT for the link. (b) Calculate the delay x bandwidth product for the link. (c) A camera on the rover takes pictures of its surroundings and sends these to Earth. How quickly after a picture is taken can it reach Mission Control on Earth? Assume that each image is 5 Mb in size.
Consider a communication channel with bandwidth B = 8000 Hz. Suppose the channel has a signal-to-noise ratio S/N = 541. What is the maximum data rate of this channel? ? What is the minimum number of signal levels needed to achieve a data rate of 64000 bps?
A 5 kHz channel transmits a signal experiencing SNR of 31. What is the maximum Bit Rate of the channel? 25,000bps 25Mbps 5Kbps 50Kbps
In a digital transmission, the receiver clock is 0.1percent faster than the sender clock. How manyextra bits per second does the receiver receive ifthe data rate is 1 kbps? How many if the datarate is 1 Mbps?