a) Each cylinder in a four-cylinder car engine has a bore diameter of 63.53 mm and the stroke for each piston is 175.00 mm. Calculate the cubic capacity of the engine in cm and calculate the clearance volume per cylinder for a compression ratio, r, of 6.25.

Q: The viscosity of chloroform at several temperatures is given on the table. Determine the viscosity…

A: Given data, T1 = 40°C     v1 = 4.64  mp T2 = 30°C     v2 = 5.10 mp Find v at T = 50°C

Q: The hydraulic press is filled with oil (p= 800 kg/m³), as shown. The piston at B has a diameter of…

A: Density of oil, ρ=800 kg/m3Piston diameter at B, DB=20 cm=0.20 mPiston diameter at A, DA=1.5…

Q: 1. For given distributed loads, see figure below, determine resultant and moments around load ends…

A: As per the guidelines we are subjected to solve only three subparts of a question.Please repost the…

Q: a1) The vectors Cand M are given by C--si+j-3k and M-i+zj+ 2k. Determine: a) The vector product of C…

A: Those physical quantity which have both mass and direction, is known as vector quantity. Some…

Q: 1. When a 1.2 kN resistor and a 100 Q resistor are connected in parallel, the total resistance is a)…

A: GivenR1=1.2k ohm=1200 ohmR2=100 ohmAsked Total resistance=RT

Q: Calculate the heating value of coal in Btu/lb a received having the following composition by weight…

A:

Q: Questions 18, 19 and 20 For the beam shown in the figure, if W is to be 500 Ib/ft and P is 2000 Ib.…

A:

Q: Question 8 The ladder AB, of mass 30 kg, is positioned as shown. What is the B direction of the…

A: The direction of friction is opposite to the direction of movement.

Q: 6) A pin is on the left and a roller is on the right. 200 N/m A) and B. B) A₁ = Ay= By= 400 N/m Show…

A:

Q: Questions 18, 19 and 20 For the beam shown in the figure, if W is to be 500 lb/ft and Pis 2000 Ib.…

A: The given information in the problem is represented in the following attached image:

Q: The diaeram below shows a solid cyinder or ma M spinning around an axle attache to one of its ends.…

A:

Q: In an isentropic process, P1 = 200 psi, P2 = 300 psi and T1 = 700oR. Find T2 using k = 1.4 a) 576oR…

A: Given data: T1=700°R=388.74 Kp1=200 psip2=300 psik=1.4 Need to determine the value of temperature…

Metrology of surface finish

In general terms, the application of scientific principles in the study of measurements is known as metrology. When speaking about measurement, it could be of time, length, microstructures, grain structures, internal crystal discontinuities, surface roughness, measurements of angles, height, width, and so on. While coming to the domain of mechanical engineering, metrology is considered the science of measurements of surface finish, length, surface texture, and angles.