Name the principal.components of aninduction motor.

Q4/B/ What are the principal characteristics of a series DC motor? What are its uses? Core Mc

L-1). The 3-phase wound-rotor induction motor has .... . a) high starting torque b) low starting current c) both "a" and "b" d) neither "a" nor "b" L-2). The 3-phase wound-rotor induction.........a) motor has a wire wound rotor b) motor's rotor can be connected to an external resistive load by way of slip rings and brushes c) motor requires more maintenance than the 3-phase squirrel-cage induction motor d) all of the above L-3). The 3-phase wound-rotor induction motor's rotor circuit's resistance should be adjusted so it is__________ during starting. a) low b) high c) either "a" or "b" d) neither "a" nor "b" L-4). Will a 3-phase wound-rotor induction motor start with no external circuit connected to its rotor leads? a) yes b) no

Design a LabVIEW program that sweep Servo motor from 0 degrees to the specified angle and repeat Design a LabVIEW program to demonstrate a 28BYJ-48 stepper motor operating in both directions: 5 seconds anticlockwise and 5 seconds clockwise

Explain the construction of AC servo motor, also draw its diagram

A series motor runs at 800 rev/min when the voltage is 400V and the current is 25A. The armature resistance is 0.4 ohm and the series field resistance is 0.2 ohm. Determine the resistance to be connected in series to reduce the speed to 600 rev/min with the same current.

8. A dc series motor develops a torque of 20 Nm at 3 A of load current. If the current is increased to 6A, the torque developed will be (a) 10 Nm (b) 20 Nm (c) 80 Nm (d) 40 Nm

Colve asap

A 100 hp, 1750 rpm, d.c. shunt motor has an armature inductance of 1.15 mH, a resistance of 0.0155 2 and an armature voltage constant of 1.3V.s/rad. The motor is operated from a three-phase half-wave controlled-rectifier at rated armature current of 35 A. Find the firing angle a, assuming that the supply voltage is 400 V and the motor speed is 1750 rpm. Consider the thyristors to have a forward voltage drop of 1.5 Volt and assume continuous conduction.

A 200V, 875rpm, 150 A separately excited dc motor has an armature resistance of 0.06Ω. It is fed from a single phase fully controlled rectifier with an ac source voltage of 220V, 50Hz. Assuming continuous conduction. Determine motor speed for α = 160o and half rated torque.