n solar cell shunt resistance (Rsh) is mainly affected by the following factor_______________ impurities near the junction metallic contacts interconnections bulk resistance

Q: 10) In carrier current protection the purpose of the wave trap is for trapping power frequency waves…

A:

Q: What are the possible faults in underground cables. Illustrate the methods of fault localization.

A:

Q: The value of symmetrical short circuit current is ___________________ at time t=0. Zero Minimum…

A: In this answer let us discuss the concept of short circuit current and try to find its value at t=0.

Q: Most residential general lighting circuits are wired with 14-AWG copper conductors and are protected…

A: Generally, the electricians follow the table wherein the calculated values of circuit breaker size…

Q: In a string of suspension insulator with three units, the line unit has 20kV and k=0.35. The voltage…

A: Given: Voltage across line unit, V3=20 kVk=0.35

Q: The current zero interruption, in oil and air blast circuit breakers, is achieved by a. Lengthening…

A: Curve is a starting current in the electrical switch when its two contacts are open. There are two…

Q: Voltage sags due to short circuit and earth faults are the cause for the vast majority of equipment…

A: Power Quality Problems Voltage sag Voltage swell Voltage spike Voltage fluctuation Harmonics Long…

Q: h.1. In an alternating-current system, the maximum size for a copper grounding electrode conductor…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: what is the introduction for MEASUREMENT USING DC BRIDGES

A: In this question we will write about DC bridges .

Q: 3. The zero sequence current is times the current in neutral wire.

A: Zero sequence current in all phase are in phase and same magnitude . Neutral current sum of three…

Q: Parallel conductors must be installed in sizes no smaller than A. 1/0. B. 2/0. C. 750 kcmil. D. 4/0.

A: Given To determine minimum size of conductors  that must be used in parallel conductors

Q: Approximately 75 percentage of the fault are either _____ or permanent LG Faults. a. LLG b.…

A: There are different types of faults occurs in transmission line.     1) LLG   When two lines come…

Q: Identify the temperature range of Nickel wired RTD a. -100°_C to 300° C_ b. -80°_C to 200° C_ c.…

A: In this question we will write range of Nickel wired RTD..

Q: If the charging resistor was twice as large as the discharging resistor in Figure 4, the amplitudes…

A:

Q: Describe how a fault in long cable can be detected and located using partial discharge technique…

A: The partial discharge technique of high voltage is the best technique for the detection of failure…

Q: Formation of arc during circuit breaking The phenomena of Arc During opening of current carrying…

A: The solution is given below

Q: Compared to the original circuit that it replaces, an equivalent circuit will always have:a. the…

A: The objective of the question is to understand the properties of an equivalent circuit compared to…

Q: . The three bus-bar conductors in an outdoor sub-station are supplied by units of post insulators.…

A: The solution can be achieved as follows.