My son built a symmetric tent last Christmas season of 2020. The frame for the tent is shown with two-force structural parts BC, BE, CE, and EF which were made up of aluminum poles. The ropes AB and CD were made of flexible materials that are effective in tension only. Which of the following best describes the nature of forces in the parts of the frame? See figure 01 below. * O EF is in compression and others are in tension EF is in tension and others are in compression BC is in compression and others are in tension BC is in tension and others are in compression Figure 01 B E A F D TENT ELEVATION

My son built a symmetric tent last Christmas season of 2020. The frame for the tent is shown with two-force structural parts BC, BE, CE, and EF which were made up of aluminum poles. The ropes AB and CD were made of flexible materials that are effective in tension only. Which of the following best describes the nature of forces in the parts of the frame? See figure 01 below. * O EF is in compression and others are in tension EF is in tension and others are in compression BC is in compression and others are in tension BC is in tension and others are in compression Figure 01 B E A F D TENT ELEVATION

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Need ASAP
Solve only six to ten ok just solve good correct Solutions Handwriting
Neeed answer ASAP thank you
Please answer with a complete solution. Thank you! The roof truss is supported by a hinge at A and a horizontal roller support at B. The wind loads are perpendicular to BC. Determine the reactions at A and B.
Please show your solution on a paper with FBD
need asap please
Helping tags: Civil Engineering . . . WILL UPVOTE, just pls help me answer the question and show complete solutions. Thanks!
Show the solution
Give two reasons why the tension development length is longer than the compression development length.
show complete solutions and answer should be in 4 decimal places
PROBLEM 2: Determine the smallest safe cross-sectional areas, in mm?, of members Cl and CD for the wooden truss shown below. The working stresses are 10 MPa in tension and 8 MPa in compression. (The working stress in compression is reduced due to the danger of buckling.) 8 kN 4 kN 4 kN FINAL ANSWERS 4 kN 4 kN 4 kN - 4 kN Acı mm? K 3.5 m ACD mm2 A в с D E F PA - 6 @ 4 m = 24 m
Gove a short description of the structures roller support and truss