My answer I am getting is 1.58. please help me Water waves with parallel crests 4.3 cm apart pass through two openings 7.2 cm aparton a board. At a point 3.0 m beyond the board, at what angles relative to the “straightthrough” direction would there be little or no wave action?

My answer I am getting is 1.58. please help me Water waves with parallel crests 4.3 cm apart pass through two openings 7.2 cm aparton a board. At a point 3.0 m beyond the board, at what angles relative to the “straightthrough” direction would there be little or no wave action?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter16: Waves

Section: Chapter Questions

Problem 61P: A copper wire has a density of =8920 kg/m3, a radius of 1.20 mm, and a length L. The wire is held...

See similar textbooks

Similar questions

Consider a sound wave moving through the air modeled with the equation s(x,t)=6.00nmcos(54.93m1x18.84103s1t) . What is the shortest time required for an air molecule to move between 3.00 nm and -3.00 nm?
A sunbather stands waist deep in the ocean and observes that six crests of periodic surface waves pass each minute. The crests are 16.00 meters apart. What is the wavelength, frequency, period, and speed of the waves?
During a 4th of July celebration, an M80 firework explodes on the ground, producing a bright flash and a loud bang. The air temperature of the night air is TF=90.00F . Two observers see the flash and hear the bang. The first observer notes the time between the flash and the bang as 1.00 second. The second observer notes the difference as 3.00 seconds. The line of sight between the two observers meet at a right angle as shown below. What is the distance x between the two observers?
Check Your Understanding The wave function above is derived using a sine function. Can a cosine function be used instead?
A microphone receiving a pure sound tone feeds an oscilloscope, producing a wave on its screen. If the sound intensity is originally 2.00105W/m2 , but is turned up until the amplitude increases by 30.0% , what is the new intensity?
Consider two waves defined by the wave functions y1(x,t)=0.50msin(23.00mx+24.00st) and y2(x,t)=0.50msin(26.00mx24.00st) . What are the similarities and differences between the two waves?
Sound waves can be modeled as a change in pressure. Why is the change in pressure used and not the actual pressure?
What is the difference between propagation speed and the frequency of a mechanical wave? Does one or both affect wavelength? If so, how?
Sound is more effectively transmitted into a stethoscope by direct contact rather than through the air, and it is further intensified by being concentrated on the smaller area of the eardrum. It is reasonable to assume that sound is transmitted into a stethoscope 100 times as effectively compared with transmission though the air. What, then, is the gain in decibels produced by a stethoscope that has a sound gathering area of 15.0 cm2, and concentrates the sound onto two eardrums with a total area of 0.900 cm2 with an efficiency of 40.0% ?
A copper wire has a density of =8920 kg/m3, a radius of 1.20 mm, and a length L. The wire is held under a tension of 10.00 N. Transverse waves are sent down the wire. (a) What is the linear mass density of the wire? (b) What is the speed of the waves through the wire?
A bat sends of a sound wave 100 kHz and the sound waves travel through air at a speed of v=343 m/s. (a) If the maximum pressure difference is 1.30 Pa, what is a wave function that would model the sound wave, assuming the wave is sinusoidal? (Assume the phase shift is zero.) (b) What are the period and wavelength of the sound wave?
Check Your Understanding The equations for the wavelengths and the frequencies of the modes of a wave produced on a string: n=2nLn=1,2,3,4,5...andn=nv2L=nf1n=1,2,3,4,5... were derived by considering a wave on a string where there were symmetric boundary conditions of a node at each end. These modes resulted from two sinusoidal waves with identical characteristics except they were moving in opposite directions, confined to a region L with nodes required at both ends.Will the same equations work if there were symmetric boundary conditions with antinodes at each end? What would the normal modes look like for a medium that was free to oscillate on each end? Don’t worry for now if you cannot imagine such a medium, just consider two sinusoidal wave functions in a region of length L, with antinodes on each end.