Mohr’s Circle ; Direct shear test was performed on dry, sandy soil. The specimen is 50 mm in diameter and 25 mm in height. Test results were as follows: Determine the cohesion and angle of internal friction.

Mohr’s Circle ; Direct shear test was performed on dry, sandy soil. The specimen is 50 mm in diameter and 25 mm in height. Test results were as follows: Determine the cohesion and angle of internal friction.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The piece of wood shown below was used in an experiment. During the test it sheared parallel to the…

A: Average Shear Stress is given by ; Average shear stress = Shear force Shear area

Q: In an unconfined compression test on a saturated clay, the maximum proving ring dial reading…

Q: A square cross-section v-notched specimen of height 75 mm has each side of 11 mm has been selected…

A: specimen of height 75 mm each side of 11 mm v-notch of thickness 1.53 mm Determine the…

Q: Determine the complete state of stress (δz , δr , δt ) using one layer theory under the centerline…

A: Solution: Given: P = 50,000 lb p = 100 psi μ = 0.5 E = 3000 psi r = 0, 0.5, 2

Q: need the answer as soon as possible

A: Given data : Shear strength (ζ)=150 KPaNormal stress (σn)=200 KPa Soil given in the problem is Sandy…

Q: A direct shear test was conducted on a cohesionless soil (c = 0) specimen under a normal stress of…

Q: For a triaxial compression test under untrained condition, the deviator stress and the pore water…

A: Given: Deviator stress at failure, σd = 75 kPa Pore-water pressure at failure, u = 45 kPa Confining…

Q: A unconfined compressive strength test was performed on a clay sample. The sample had a diameter of…

Q: Following are the values of compressive strengths were obtained from a single specimen. MPa. 57…

A: Given:

Q: Question A cylindrical soil specimen of saturated clay, 3.50 cm diameter and 8 cm length, is tested…

A: Given data- A cylindrical soil specimen- Diameter D=3.50 cm, Length L=8 cm, Failure load =50 kg,…

Q: Problem IV. Shear Strength of a Field Sample A direct shear test was run on a sample of sandy soil…

A: Given data : Effective normal stress (σn')=62.5 KPaShear stress at failure (S)=41 KPaSoil is sandy…

Q: 4. Flow net is used for the determination of (a) Quantity of seepage (b) Hydrostatic pressure (c)…

A: This all questions are from geotechnical engineering Here three questions are asked which are…

Q: Direct shear test were performed on a dry, sandy soil. The size of the specimen was 50.55 mm x 50.55…

Q: Q-1: Direct shear tests were performed on a dry, sandy soil. The size of the specimen was 50 mm x 50…

Q: An unconfined compression strength. test was conducted on a cohesive soil. The test specimen failed…

A: →Axial Stressσ1=78kPa→Unconfined Compression Strength test i.e σ2=σ3=0 (special case)To determine…

Q: The table below contains data from 2CU triaxial stress on usimilar upe cimens Specimen no cell…

Q: Question -4, A cylindrical specimen of saturated clay 40 mm in diameter and 80 mm in overall length…

A: Given- Diameter d=40 mm, 80 mm overall length Axial load =46.5 N Change in length at failure =1 cm,…

Q: A Plate load test is carried out on submerged soil using a 300 mm radius rigid plate. A load of 5…

A: Given- Radius of rigid plate a=300 mm, Load P=5 tons=5000 kg, Deflection d=1.20 mm, Poisson's ratio…

Q: SITUATION. In a certain Direct Shear Test Experiment the sample fails at shear stress of 8 kPa when…

A: Experiment 1: τ = shear stress = 8 kpa and σ= 12 Kpa. Experiment 2:…

Q: uction Management sing the soil profile shown below, determine the effective stress surface. 10…

A: We know that, effective stress = (total stress - pore water pressure) Here, Eff. Stress =…

Q: A direct shear test was conducted on a soil sample with the cohesion of 10KN/m². The cross sectional…

A: Solution:- 1.Angle of friction:

Q: Q.2) In an unconfined compression (UC) test on a saturated clay, the maximum proving ring dial…

A: Given that :-Maximum proving ring dial reading recorded = Initial height = 70 mmInitial diameter =…

Q: The simplest and oldest nonrigid method is the Winkler method, which uses inde-pendent springs, all…

A: Winkler method : The Winkler Method is a method for determining the concentration of dissolved…

Q: 3. A direct shear test on a joint under constant normal stress of 10 MPa gives the following…

A: The Direct Shear Test is an exploratory strategy led in geotechnical designing practice and…

Q: a. A vane shear test was conducted in a saturated clay. The height and diameter of the rectangular…

Q: Compute the tensile stress from the value acquired from the experiment if the breaking load is…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: Q.2) In an unconfined compression (UC) test on a saturated clay, the maximum proving ring dial…

A: Given that :- Maximum proving ring dial reading recorded = 240×10-3 mm Initial height = 70 mm…

Q: Data were taken from a TORSION TEST for a circular specimen. [Length of specimen = 20mm, the…

A: L=20mm D=4mm

Q: Q.2) In an unconfined compression (UC) test on a saturated clay, the maximum proving ring dial…

Q: A vane shear test was conducted in a saturated clay. The height and diameter of the rectangular vane…

A: Given:- A vane shear test was conducted in a saturated clay The height of the rectangular vane = 4…

Q: Given A vane field test was performed in a layer of soft clay. The vane tester had a diameter of…

Concept explainers

Test for Determination of Shear Strength

The term shear strength is often associated with the soil. Shear strength is defined as the resistance to the deformation of soil particles due to the continuous action of shear stress. In short, shear strength is the maximum shear stress that a soil can sustain.

Question

Test No.
Normal force, N
Shear force, N
1
243
124
268
137
352
179
4
412
210
23t

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Test for determination of shear strength

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A plate load test is carried out on a subgrade soil using a 300 mm radius rigid plate. A load of 8 tonnes resulted in a deflection of 1.5 mm. The elastic modulus (in MPa) of the soil, if the poisson's ratio is 0.5, is
An unconfined compression test is conducted on a 3 in diameter sample 6 inches in length. The peak load recorded was 67 lb at a strain of 4 percent. Determine qu and Su.
Soil
The followings are data from the unconfined compression test. Use these data to determine the unconfined compression strength of the soll and the undrained cohesion. Diameter of sample = 1.6 cm; Length of sample= 4.0 cm; Dial gauge factor = 0.02 mm Reading 0 20 Load (kN) 40 60 80 0.000 0.004 0.007 0.009 0.011 100 0.012 120 140 160 0.013 0.014 0.015 180 200 220 240 260 0.016 0.016 0.016 0.016 280 0.016 0.016
Assuming in Test 4, a sample was tested using the Unconfined Compression Laboratory Test, and the test was conducted fast enough as to assume that undrained conditions develop. If the sample failed when the axial compression stress is 01f 50 kPa, draw the Mohr Circle showing the failure envelope and its equation, and calculate the undrained shear strength Cu of the sample. =
x 18 The effective shear strength equation (S = T₁ = 25+5 tam 30); expressed for a saturated clayey soil. In undrained test on a sample of the same soil using the shear box apparatus, the following data at failure were recorded :. Shear Stress = 90 kPa a) What and Normal stress = 180 kPa pore water pressure in the specimen at time of was the failure (assume Øu= 0). Find the Unconfined compressive strength (Od max) for the same soil an Unconfined. when tested in Compression test. c) Find the major principal stress when a sample of the same soil is tested in Ul test with confining pressure of (200 kPa).
Q26 Please provide justified answer asap
In the discussion of Von-Mises criterion, how different is the description of J2 when compared to the Von-Mises stress?
Direct shear tests were performed on a dry, sandy soil. The size of the specimen was 50 mm x 50 mm x 20 mm. Tests results were as given in the table. Find the shear stress parameters
Question A sample of dry sand was tested in direct shear test apparatus under a normal load of 72 kg. The shear load required to fail the sample was found to be 36 kg. The angle of internal friction () will be:
Q5. Determine the rod extension after tension test on a steel rod had the following results; Rod diameter = 30mm Rod length before test = 200mm Maximum applied load = 400KN Youngs modulus of elasticity = 25000N/mm %3D %3D
Given data : Lateral strain=D-0.34 Poisson ratio=0.31 Determine longitudinal strain