(mm) gauges Error Y(mm) X (mm) 3.02 2.07 1

Q: On the attached drawing 11A005< what is dimension "G"

A:

Q: . a. On the part shown, show a angularity specification to orient the angled surface in relation to…

A:

Q: What type of geometric tolerances have no datum features? Profile Tolerances All Tolerances O…

A: Geometrical Tolerancing: The tolerances in any system which allows tolerances to be applied…

Q: In the belt drive system shown below, the input pulley is attached to an electric motor transferring…

A:

Q: Apply geometric tolerancing to part according to the instructions below. This exercise will provide…

A: The majority of current production techniques and equipment are incapable of producing items that…

Q: What is the measurement accuracy AND unity of the instrument in Figure

A: Accuracy of the Bourdon tube pressure gauge

Q: 1. cm What is the reading on the following Vernier? What is its resolution? Main Scale Vernier Scale…

A: To determine:The reading of the vernierResolution of the vernier

Q: I need help with question number 15 that is pertaining to the print provided.

A: 15.The unidirectional system is used here for the dimension placing. The unidirectional system is…

Q: Use the prefix multipliers to express cach measurement without any exponents. 22 x 10-15s

A: Given: The time is t=22×10-15 s. The unit conversion factor to convert Second into Femtosecond is, 1…

Q: 1st image : What is the reading on the micrometer? 2nd image : What is the reading on the…

A:

Q: You are given a set slip gauge containing 46 pieces of 2mm base (M46/2). Show how you would build…

A:

Q: Find the tolerance and fit type of Ø 60 H7k6,

A: given: nominal size, D=60mm tolerance hub: H7 tolerance shaft: k6 so for tolerance hub: H7, the…

Q: If the pin in the drawing below is produced at Ø.498, what is its total positional tolerance?…

A: Total positional tolerance shows us the maximum allowable deviation of a feature from its true…

Q: What is the reading on the micrometer? 5 20 -15 -10 0 1 2 3 09876543210

A: Since you have asked multiple questions in a single request, we would be answering only the first…

Q: 3. If the tolerance applies at MMC then a possible O indeterminant bonus O LMC zero tolerance…

A: given = fill in the blanks

Q: Sketch a setup and measurement method that may be used to check the runout tolerance. Also show the…

A: To sketch a setup and measurement method to check runout tolerance. and to show acceptable max…

Q: The layout foreman is using the transit to turn an angle to the left of 45° 20' 30". The transit…

A: The instrument would be turned to below readings: 314° 39' 30"

Q: Which statement is true in the case of the term "Range". O Is closely related to accuracy and define…

A: Range is closely related to accuracy

Q: If the pin in the drawing below is produced at Ø.498, what is its total positional tolerance? C…

A: Given data as per the question Pin diameter =0.498

Q: Perform position analysis on the crank slider shown below by 1) labeling the unknown values on the…

A:

Q: Consider the figure shown below, (enter all answers in this format 0.XXX) 4XØ 255 a 005 O 010 B -50…

A: TOTAL POSITION TOLERANCE The GD&T symbol for location tolerance is position tolerance. The True…