miles and is covered by cellular system using four /If Diwania city center has an area of 25 square cells reuse pattern. Each cell covers kalf square. mile and the city is allocated Go MHZ which uses two 30kHz simplex channels to provide full duplex voice and control channels as a communication enginer calculatie 1-number of cells to cover all the city 2-No channel per cell 3-total capacity

miles and is covered by cellular system using four /If Diwania city center has an area of 25 square cells reuse pattern. Each cell covers kalf square. mile and the city is allocated Go MHZ which uses two 30kHz simplex channels to provide full duplex voice and control channels as a communication enginer calculatie 1-number of cells to cover all the city 2-No channel per cell 3-total capacity

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Given a transmission rate of 1 Gbps and a propagation speed of 200m / μ sec , how many meters of cable are needed for a full duplex transmission link to have a minimum capacity of 1500 bytes?
Suppose there is a b+n (Sum of first and last digit of your Reg#) Mbps microwave link between a geostationary satellite and its base station on Earth. Every minute the satellite takes a digital photo and sends it to the base station. Assume a propagation speed of 2.4*108 meters/sec. 1. What is the propagation delay of the link? 2. What is the bandwidth-delay product?
You are designing the Wi-Fi for a classroom of 20 students and all students are using Wi-Fi at the same time. The protocol efficiency is 40% and the channel utilization is 80%. Each students uses a throughput of 2 Mbps. What is the minimum PHY rate requirement for the radio in Mbps?
Shielded twisted-pair (STP) cabling was first made popular by IBM when it introduced Type classification for data cabling. Though to purchase and install than UTP, STP offers some distinct advantages. Shielded twisted-pair (STP) cable can up to 600MHZ. STP has an more currently support applications requiring shield that consists of braided . The shield surrounds the 150-ohm, 22 AWG, two-pair conductors. Each is insulated with a to install than UTP. STP cabling solely material and then each twisted pair is individually shielded. STP cabling is because it provides better EMI protection and potential bandwidth, installers consider using fiber-optic cable instead. conductor copper material bandwidth expensive dielectric inner glass Cheap lower Interference expensive WAN higher outer
Computer Science As a network engineer in a telecommunication company, you are requested to setup a new office building in Seattle with a suitable transmission medium facility in the meeting room. The proposed network must be able to connect with ten computers, three printers, and two server workstations. All stations will be located within the ground floor and second floor. The management has also insisted minimum cost with sufficient networking performance. Propose and justify the suitable transmission medium and data rate to be utilized. Discuss the challenges and any other consideration that should be included in your proposal.
QUESTION 19 What is the maximum theoretical data capacity on a coax cable that supports 30 MHz of frequency bandwidth and experiences a signal to noise ratio of 10,400 to 1. 200 Mpbs 400 Mbps 800 Mbps 1600 Mbps
What is the delay of sending a data file from a source station to a destination station? Suppose that the length of the data file is 2 Mbytes and the bandwidth of the channel is 1600 bps, and the network link between the sender and receiver is 20000 Km and the speed of the light inside the link is 2x108 meters/second? Assume that the delay is composed of only transmission time and propagation time.
Data communication Suppose that the spectrum of a channel is between 8 MHz and 10 MHz, and the intended capacity is 8 Mbps. a. What should be the signal-to-noise ratio (SNR) to obtain this capacity? Constant values= c=3x^10°m/s, k=1,38x^10231/K I
Five channels, each with a l0a-kHz bandwidth, are to be multiplexed together. What is the minimum bandwidth of the link if there is a need for a guard band of 10kHz between the channels to prevent interference?
A Telecommunication channel in form of a copper cable has 4 kHz bandwidth. Calculate the amount of data rate that can be transmitted through this channel if binary signaling is used with raised-cosine pulses and 0.5 roll-off factor.
Consider a communication channel with bandwidth B = 8000 Hz. Suppose the channel has a signal-to-noise ratio S/N = 541. What is the maximum data rate of this channel? ? What is the minimum number of signal levels needed to achieve a data rate of 64000 bps?