ment of each of the N (in N.m and co

Q: (Compute) What is line OA's direction cosine angle, in degrees, from the x-axis (θx)? Note that…

A:

Q: To compute the average-end area volume, you need to know the distance (L) between the stations of…

A: The average end area calculation is used to get the volume between two cross-sections. Two…

Q: The pictured disk which weighs 20 lbs. and contacts an inclined surface (this inclined surface is…

A:

Q: 2 Constraint indicated the name and where it should be

A: Given: To find: Where the constraint should be

Q: What is the maximum magnitude of the bending moment caused by force G? If none, enter zero. Do not…

A: It is required to determine the magnitude of the maximum bending moment by the force G.

Q: 9. A cantilever is a beam whose Both ends are supported either on rollers or hinges One end is fixed…

A: Answer is option (b) One end is fixed and other end is free.

Q: Input shaft of the gear train shown below rotates at 1,500 RPM. The output shaft must rotate exactly…

A: Given data wA = 1500rpm wB= 500rpm  TA= 20

Q: solve using analytical way Given a single disk system that rotates as in picture. If: m₁ = 10 kg; R₁…

A: co-ordinates are converted into x-y form. center of mass is found in x-y form and from there…

Q: Redraw when the rack AB is at 45o angle. What are the other two angles belonging to the triangle…

A:

Q: 4. What is the complement of a 72°21'47" angle?

A: We know that the complement angles pair have sum = 90o let x =  72o 21' 47"  (Given) Complement of x…

Q: Is 2.0cm3 of aluminum same as 2.0cm3 of lead

A: According to the given data, the volume of the aluminum object is 2.0 cm³  and the volume of the…

Q: Calculate y, the distance from the base to the position of the Neutral Axis of the T-section shown…

A:

Q: solve the following exercises:

A: To determine the acceleration of the system

Q: The of two meshed gears can be used to express their gear ratio. Select all that apply. O diameters…

A: The gear ratio of two meshed gears can be expressed using the above methods:Diameters: The gear…

Q: Co D N B F 500 mm E A 250 mm 300 mm

A: Given,

Q: Redraw when the rack AB is at 89o angle. What are the other two angles belonging to the triangle…

A: When the rack AB is at 89o angle. Draw the diagram as given above.

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.