Memo Date: Rule - Derive Valtge dividerifor hvee Series resistafs. elivider

Q: The latching current rating of thyristor is 50 mA. Minimum width of gate pulse to turn on the SCR is

A: Given data:Required information:

Q: I ID 5 V + Vo Given that Vin is 7V: a. What is ID if the diode is on? b. What is Vo if the diode is…

A:

Q: Symbol of SCR

A:

Q: 3. Collector characteristics for the Ge transistor If VEE =2 V, VCC =12V, and RC = 2k , size RE so…

A:

Q: Determine the gate trigger current and the anode current when the switch, SWI, is momentarily closed…

A: Fig: Given circuit  Given that  VGK=0.65VIH=15 mAVAK=0.35V

Q: Ex Sor the Circuit shown in Frel, Rc RE, RBif the Veez 1RU Vc Eahv aud Icz ImA auel fB:60 auel Sa…

A:

Q: For the circuit given in Figure 2, with R₁ Draw the output voltage waveform at point A. =2k,…

A: According to the question, for the circuit shown belowWe need to draw the output waveform.

Q: Tabulate the measurements. 4. Graph the tabulated results. C. Voltage-Current Characteristic Curve…

A: It is asked to show the V-I characteristics curve for reverse bias. Also ut is mentioned to…

Q: als are at the same A depletion mode JFET is a. normally on and must be biased off. b. normally off…

A:

Q: Draw the schematic symbols and explain the working principles of the following components: A- LDR

A: Dear student as per our guidelines we are supposed to solve only one question .kindly repost other…

Q: Q31Answer the following questions 1.Explain briefly the diode and forward bias and reverse bias of…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Q4/ For halfwave controlled rectifier Vs = 50 Sinwt ,a = 30° and a load of 200 resistor Find 1) Yar…

A: In this answer let us try to calculate for the required parameters using the formulae derived for…

Q: QUESTION 5 Determine the gate output for the input waveforms in Figure3 and draw the timing diagram.…

A: Given waveform with the logic circuit,

Q: Popular 2G CDMA standard IS-95 is also known as a) CdmaOne b) CdmaTwo c) IS-136 d) IS-95B

A: 2G CDMA interim standard 95 is also known as  'CdmaOne'  .

Q: A single phase half wave uncontrolled rectifier with R load is supplied by an AC source of 230…

A: Last option is correct. The explanation is provided below.

Q: A fixed bias n-channel JFET with Vdd= 12V, Rd= 1.2k ohms. Idss=12mA and Vp=-4V. Determine Id. O a.…

A:

Q: Determine the gate trigger current and the anode current when the switch, SW1, is momentarily closed…

A:

Q: Draw pnp transistor schematic symbol and explain its working principals

A:

Q: Q: A- For the transistor circuit shown in figure bellow 20v Determine: 1-.lc.le and Ver 2- Sketch…

A:

Q: Adavantages and disadvantages of ANALOG IC

A: ADVANTAGES  ANALOG ICS use less energy; There by involving lesser heat consumption and hence…

Q: For the circuit shown in Figure B24 i. Draw the DC load line in the Graph B24 ii. Calculate the Q…

A: Given:-

Q: When the drain saturation current is less than loss, a JFET acts like a

A: Given : drain saturation current is less than IDSS in a Jfet

Q: 2-Drift Determine w he ther each diede below is for Ward oY reverse b.iased. lovelt 3 Volt 8 Volt -…

A:

Q: In small-signal FETS, the DC voltage sources will be replaced by a O Short circuit Current source…

A: In small signal FETs the DC voltage source is replaced by

Q: Deter min the system Runction and unit samPle responce for equatron yin) = y (n-1) + 2x (n)

A: In this question we need to find a transfer function of the system and responce of the system when…

Q: R1 R2 VS RL D1 Z1 VS = 20,1 V, R1 = 11 k2, R2 = 11 kQ, %3D %3D %3D RL = 23,4 kn and Vzener = 9,6…

A:

Q: Write the following counter using verilog case statement. where reset is a high active signal

A: for the following counter we have to write the verilog code using case statement

Q: What is the required input voltage at AREF pin in Arduino UNO to have LSB voltage resolution of 1.47…

A: Given, Resolution of Arduino Uno is 1.47 mV. The Arduino Uno ADC is of 10 bit resolutions.

Q: Difference between passive and active circuit element

A: Very simple problem on network analysis. Look below the given explanation:-

Q: for the circuit shown below: The lower reference threshold 10v vin=5 sinwt -10v 3 kOhm 1 k Ohm

A: A voltage reference is an electrical component or circuit that generates a constant DC…

Q: 2. Sweep Vin (0 to 1V) and plot Id. Vth = 0.4V. Indicate the region of operation clearly. 1V Vin HE…

A: Given that , Vth= threshold voltage=0.4v VD= drain voltage=0.5v Vs= source voltage=1v Id= source to…

Q: Calculate fout and duty cycle from astable 555 timer with R1 1 kN, R2 = 2 kn, and C = 10 uF.

A: Given R1 = 1 Kohm, R2 = 2 Kohm, C = 10 uf To find  Fout and duty cycle

Q: What are the conduction angle of the SCR if the device will trigger at 38V break - over voltage? n…

A:

Q: Number of IC required to imlement min term of carry output of ful adder. Options A-1 B-2 C-3…

A: To implement min term of carry output of full adder, we require two half adders and OR gate.

Q: Q1. Vdc A SCR circuit is shown in Figure 1 and the SCR's gate firing angles are shown in Table…

A: Dc Voltage Vdc Vdc=150 volt Firing angles In degrees 30,45,110,150

Q: in I ww ID T5V Vo - Given that Vin is 7V: a. b. c. What is ID if the diode is on? What is Vo if the…

A: Given that: The circuit is shown below.   Vin= 7V Find; Calculate ID when the diode is ON.…

Q: voltage doubler will not provide a A.c. output that is twice the peak input D.c. voltage. true O…

A: Generally in the voltage doubler  circuits the voltage is taken across the capacitor,  so it…

Q: a. Determine the O point of the transistor circuit shown in Figure below. b. Also draw the d.c. load…

A:

Q: Write an AVR program using the timer to generate a square wave at a frequency of 50KHZ knowing that…

A: // Program to Generate waveform using AVR Microcontroller Timers #include<avr/io.h>…

Q: Collector characteristics for the Ge transistor If VEE =2 V, VCC =12V, and RC = 2k , size RE so that…

A: For a Ge transistor - VEE=2VVCC=12VRC=2kΩVCEQ=6.4 V

Q: The anode is connected to positive terminal with respect to the cathode & the gate circuit open, the…

A: Choose the correct option If the anode is connected to the positive terminal with respect to the…

Q: Sketch the output waveform for the switch transistor circuit of figure (2). VCC=10V RC =1K Vin Vout…

A:

Q: please write Details about Verification of series RL series circuit

A: Assume RL circuit  Connect DC supply and AC supply. Write down Verification of series RL series…